滯后硬化 的英文怎麼說
中文拼音 [zhìhòuyìnghuà]
滯后硬化
英文
after hardening-
The lcf behavior of a recrystallized zircaloy - 4 plate at room temperature and 400 show that alloy has better lcf property at rt than at 400, and cyclic hardening at 400 which could be attributed to the dynamic strain aging effects. it is noticeable that the hydrided plate has the same cyclic behavior as the above unhydrided sample at room temperature
在400下，合金錶現出與常溫下不同的循環特性，其循環穩定滯后回線出現鋸齒狀波形，且在整個疲勞過摘要程中呈現出一致循環硬化的現象，這主要是因為合金在400下發生動態應變時效效應的結果。Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application
熱、壓環境下壓阻變換壓力傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型，模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究表明，硼硅堆導致產生一定的非線性，但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器輸出的滯后和漂移誤差.然而，在相對穩定的環境下，軟黏合劑對傳感器的影響可以忽略.此外，詳細的設計和過程信息有助於提高模型的適用性However, the research indicates that there still exist many problems, including low lavor talents, weak information application ability, inadequate information demand, high using cost, and lacked service
不過，也存在許多不足，以農業信息化硬體設施滯后、信息使用成本高、信息服務體系不完善、人力資本缺乏、農民文化素質低等問題尤為嚴重。
分享友人