澆鑄樣 的英文怎麼說

中文拼音 [jiāozhùyàng]
澆鑄樣 英文
casting sample
  • 澆 : 澆名詞（姓氏） a surname
  • 鑄 : Ⅰ動詞（鑄造） cast; coin; make Ⅱ名詞1. （古國名） zhu, a state in the zhou dynasty2. （姓氏） a surname
  • 樣 : Ⅰ名詞1. （形狀） appearance; shape 2. （樣品） sample; model; pattern Ⅱ量詞（表示事物的種類） kind; type
  1. The results show that the heat preservation coating and its proper thickness are favorable to the enhancement of filling mold speed of aluminium alloy ; the higher the pouring temperature is and the larger the ratio of hollow areas of vertical pouring is, the faster the speed of filling mold of aluminium alloy is ; if the mold is too thick or too thin, it may decrease the speed of filling mold ; the proper length and the area of vertical pouring are favorable to the enhancement of the speed of filling mold ; although negatire - pressure may improve filling the speed, too high negatire - pressure may enlarge the flaw in casting

    結果表明：保溫塗料及一定的塗層厚度有利於提高鋁液的充型速度；澆注溫度越高、直澆道空心面積率越大，鋁液充型速度越快；模樣厚度太厚或太薄，均會使鋁液充型速度降低；一定的直澆道長度及直澆道面積有利於提高鋁液的充型速度；施加負壓會使鋁液的充型速度大大提高，但負壓過大會增大鑄造缺陷。
  2. Standard practice for preparing refractory concrete specimens by casting

    澆鑄法制備耐火混凝土樣件的標準實施規程
  3. Preparing test specimens from basic refractory castable products by casting

    用澆鑄法從鑄制堿性耐火產品中制備試驗樣品
  4. The casting dimension accuracy reached ct10 class and even higher b adopting following measures : controlling foaming agent content, strictly controlling pattern manufacture, patterns welding and assembling, filling sand and moulding, as well as controlling pouring process

    採用控制發泡劑含量和嚴格模樣製作、粘結和組模工序、填砂造型工序和澆注工序中各關鍵技術措施，使產出的鑄件尺寸精度達到了ct10級以上。
  5. The resul ts indicated that there exists obvious gas gap in molten iron flowing front, and the pressure in gas gap with eps pattern during vacuum pouring is less than 1 a tm

    試驗結果表明，鑄鐵件流動前沿不僅存在明顯的氣隙，而且採用聚苯乙烯模樣材料，負壓下澆注時，其氣隙壓力低於1個大氣壓。
分享友人
分享到 Line

分享到臉書