激勵信號 的英文怎麼說

中文拼音 [xìnháo]
激勵信號 英文
drive signal
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : Ⅰ動 (勸勉) encourage; exert oneself Ⅱ名詞(姓氏) a surname
  • : 號Ⅰ名1 (名稱) name 2 (別號; 字) assumed name; alternative name3 (商店) business house 4 (...
  • 激勵 : 1 (激發鼓勵) encourage; impel; urge; inspire; excite; stimulate; put one on one s mettle 2 [電...
  1. The experiment apparatus has been developed, which is based on software ( labview ) and hardware ( pci board ni 6024e ). the displacements and generative force at the tip of the ipmc actuators were measured with respect to the different voltages, frequents and various waveforms which include square, sinusoidal, and triangular wave

    實驗選取了不同電壓幅值,不同頻率的方波、三角波、正弦波三種波形作為電激勵信號,利用高速攝像記錄ipmc的位移變形,並通過力傳感器實測了ipmc試樣末端的輸出力。
  2. The probe ' s linearity, temperature and dynamic characteristics are analyzed base on principal theory of eddy - current displacement sensor, such as the influence of the coil q value to the linearity characteristic, influence of the diameter of coil to the linearity characteristic, influence of coil resistance to the temperature characteristic, influence of the measuring coil to the syntony loop

    在介紹渦流位移傳感器的基本理論的基礎上,分析了傳感器探頭線性特性、溫度特性、動態特性的影響因素。從探頭線圈q值對線性特性的影響;探頭直徑對線性的影響;探頭線圈電阻對溫度特性的影響;激勵信號溫度特性的影響:檢測線圈?振迴路動態響應特性等方面分析並提出製作高質量傳感器探頭的改進措施。
  3. So here introduces a new method - the combination of boundary scan with deltascan, in which deltascan is applied to do short and open test in ict, so that the number of vectors used to test circuit short and open in boundary can be eliminated. all vector test, including boundary scan test, need to create test vectors

    任何邏輯元件的矢量測試,包括邊界掃描測試,都必須先生成測試矢量,然後用這些測試矢量作為輸入端的激勵信號,因此測試矢量是矢量測試的基礎,測試矢量生成方法的難易程度和測試矢量數目是邊界掃描技術能否在實際中應用的關鍵。
  4. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現:源電路部分,由分頻電路和頻率合成電路組成,產生頻率穩定的激勵信號以確保檢測任務的正常進行;傳感器變換電路部分,由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成,主要將電渦流傳感器檢測線圈檢測到的變換成只含有被測息的離散,易於后續電路處理;由dsp晶元構成的微處理系統,主要完成檢測系統的數據擬合、顯示及與主機通等功能。
  5. In communications, a device that automatically transmits a predetermined signal when activated by a received signal

    技術中使用的一種設備,在接收到激勵信號后該設備能自動發送預先確定好的
  6. In this thesis, how to design the 1 - bit amplifier is introduced, and the main task is to achieve the pumping signal using dsp

    本設計結合課題需要,採用了1比特數字功放的實現方案,利用dsp實現了1比特激勵信號的輸出。
  7. Some stimulating signals, which are similar to that of the engines, are sent to the box against pant by the testing instrument, then some respondent signals are produced by the box

    該儀器的檢測原理為:檢測儀模擬發動機,當防喘系統工作時,向防喘盒發出激勵信號
  8. This paper suggests that there is another better way to judge whether a system is stable or not - that is analyzing the amplification of loop circuit with the nyquist rule

    由於激勵信號是復數形式的變化量,因此我們還可以採用奈奎斯特準則,利用奈奎斯特圖在復平面上的變化特點,對環路增益進行分析。
  9. Experimentation result show that the method provided in this paper can choose effective characters from acoustic signal and establish the base for classify distinguishing effectively and forecast

    實驗結果表明,用本文所提供的特徵提取方法,可以從聲激勵信號中提取出有效的特徵息,對以後進行粘接構件性能的分類預報奠定了基礎。
  10. Besides, this method can satisfy the break - even requirement and provide appropriate economical signals to transactions, which can promote the rational distribution of power demands to reduce total system losses

    另外,這種網損分攤方法能保證收支完全平衡,並且能夠向各交易提供適當的經濟激勵信號,促進電力負荷的合理分佈,從而降低系統的總網損。
  11. The main function that the data communication board carries out is sending data under the control of industry computer to the same card in the simulation computer and also receiving data from it. through this way the two computers can communicate

    該板卡分別安裝在總控計算機和模擬計算機內,由專用電纜互連,兩板之間互相發送激勵信號,使得雙方可以實現數據的通
  12. 3. using the vpp code in labview and vxi bus, a softwar is programmed for the driving signals generating and the response signals sampling. the software can process the data to appropriate the exciting force, control the whole test and display the response curves

    3 .在labview環境下,調用vpp節點驅動vxi總線來實現多通道正弦激勵信號的生成、響應的採集與處理、不同振力之間的相位協調以及測試結果的動態顯示、儲存。
  13. With the nonlinearity of vehicle suspension, simulation signal of suspension system is more practical by road exciting signal of time domain than frequency domain, furthermore, it is easy to get the results which are consistent with practical results

    考慮到車輛的非線性因素,在進行主動控制分析過程中,懸架系統激勵信號採用時域。因此,首先進行了時域路面隨機不平度生成方法的研究,所得路面模型的功率譜密度與理論路面功率譜密度吻合較好。
  14. Transient electromagnetic methods ( tem ) can be called as time domain electromagnetic methods. the exploration equipments of tem include two units : transmitter and receiver. emission current falls down from i to 0 suddenly when step current passes through the transmitter loop

    瞬變電磁探測需要發射的電流激勵信號要足夠強、功率足夠大,發射電流波形的關斷時間要求比較苛刻,而且發射部分還需提供實時監測發射電流、關斷時間,記錄電流下降沿等功能。
  15. This study adopts active detection technique based on lamb wave to monitor damage in composite materials. pzt ceramics with the diameter of 8mm are bonded on the surface of fiberglass - reinforced composite material acting as both actuators and sensors to generate and collect lamb waves. the waves emitted interact with discontinuities and experience a change in their propagation characteristics when damage is generated

    本文採用lamb波主動監測技術,利用粘貼在復合材料板表面的壓電元件,通過選擇恰當的激勵信號出可進行lamb波分析的主動監測,進而對監測進行分析及模式處理,初步實現了二維結構的損傷定位。
  16. According to the principles of piezoelectric smart concrete structure health monitoring, a mathematic model of monitor system for static performances is discussed. then, the virtual waveform generator based on dds is designed using a data acquisition card and a pc to supply multiform excitation signals to piezoelectric elements in experiment. the theoretical analysis and experimental research demonstrate the performances of the waveform generated by the virtual instrument

    為了給壓電元件提供多種類型的激勵信號,根據直接數字合成原理,設計了利用數據採集卡和計算機實現dds波形發生的虛擬儀器,並對生成波形的各方面性能進行了理論分析和實驗研究,從理論和實驗兩個方面分析了這種波形發生方式所能取得的效果。
  17. In chapter 4, we design a new conductivity detector for ion chromatography. the square wave is used as stimulating signal and the sampling is triggered by synchronization pulse at suitable time. by using these measures, the effects of doublelayer capacitance and polarization on the measurement are eliminated and the accuracy is improved

    摘要第四章介紹了一種新型的以方波脈沖采樣為原理的二電極電導檢測器,這種電導檢測器採用了方波為激勵信號,在適當時刻用同步脈沖觸發采樣,從而在較大程度上克服雙層電容和極化的影響,且在結構設計上比目前國內常用的五電極電導池簡單。
  18. On the aspect of errors analysis of hrg, a brief introduction of the close - loop detection theory of hrg is present first. later the expressions of close - loop detection errors are deduced in theory. the impact of stimulating signals, turning speed, outside appended oscillation, the location & area of electrodes, and the current loss in capacitor is considered, and the primary analysis of error compensation is given

    在半球諧振陀螺誤差分析方面,本文從半球諧振陀螺的閉環檢測原理出發,對半球諧振陀螺閉環檢測誤差進行了分析和推導,考慮了激勵信號、轉動速率、外界附加振蕩、電極位置及極板面積和電容傳感器等因素造成的陀螺誤差並對誤差補償進行初步分析。
  19. None but is the test spectrum abundant and controllable, it is possible to simulate the stresses environment needed for exposing weakness of the product. based on summarizing the present status of the vibration test and vibration environment simulation technology in the world, the topic of simulation of super - gaussian random vibration environment with controllable frequency spectrum and its applications in reliability enhancement testing is put forward. the main content and conclusions of the dissertation are as following : 1

    本文在綜述國內外振動試驗技術和振動環境模擬技術的基礎上,引出「頻譜可控的超高斯隨機振動環境模擬技術及其在可靠性強化試驗中的應用」這一主題,並緊緊圍繞該主題開展了如下研究工作: 1 .全面分析了振動的功率譜密度量級、幅值分佈、帶寬以及試件結構的固有頻率、阻尼比等因素對疲勞損傷累積的強化效應,提出振動強化試驗激勵信號應具備的重要特性:頻譜可控和超高斯,確立了本文的研究主題和方向。
  20. White noise acting as inspirit signal, the experiment data is collected. utilizing these data and error back propagating identification method, different neuron and input - output delay are selected. by comparing approximation ability and generalization ability, the neural networks model in position mode and velocity mode is identified

    並以模擬白噪聲為激勵信號,收集了數據;利用實際收集的數據,採用誤差反傳的辨識方法,選擇不同神經元及輸入輸出延時量的模型,通過比較網路的逼近能力和泛化能力,辨識得到了位置和速度兩種工作模式下的方位通道的神經網路模型。
分享友人