濕敏電阻 的英文怎麼說

中文拼音 [shīmǐndiàn]
濕敏電阻 英文
humistor
  • : Ⅰ形容詞(沾了水的或顯出含水分多的) wet; damp; humid Ⅱ名詞(姓氏) a surname
  • : Ⅰ形容詞(靈敏;敏捷) quick; agile; smart; nimble Ⅱ名詞(姓氏) a surname
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • 電阻 : (物質阻礙電流通過的性質) resistance; electric resistance (電路中兩點間在一定壓力下決定電流強度...
  1. The optimal aging conditions for the sensors investigated are : u 200 mv, f1 khz, t24 - 48 h, rh 81 - 87 %, t 3 80c ii the sensing mechanism of the humidity sensors has been explored by means of complex impedance analysis

    合適的老化條件為:施加壓200mv , 1khz , 24 48h , 38 , 81 87 rh 。採用復抗譜分析法,研究元件感機理,認為napss元件感機理為離子導,其導隨度的變化可由改進的onsager方程描述。
  2. Carbon humidity - dependent resistor

    濕敏電阻
  3. It was found that introduction of hydrophobic monomer into polymer chain improved the response linearity and sensitivity, and the impedance of sensors decreased with longer quaternization time and shorter distance between electrode tracks

    發現:疏水性單元的引入,提高了元件的響應線性度和靈度;季胺化時間的延長,使聚合物季胺化程度提高,元件抗減小;極叉指間距增大,抗增大。
  4. Herein we employed 3, 4 - polyethylenedioxythiophene ( pedt ) as the polymer material, and tetracyanoquinodimethane ( tcnq ) and tin phthalocyanine ( snpc ) as small molecules. pedt was synthesized using chemical oxidation method. infrared spectrum ( ir ) and scanning electron microscopy ( sem ) were utilized for the characterization of the obtained pedt material and surface morphology of the pedt film

    對于pedt ,本文採用化學氧化法的工藝,探討了工藝對成膜的影響,用掃描子顯微鏡( sem )觀察膜的表面形貌,運用紅外吸收光譜( ir )分析驗證了所生成的pedt聚合物,並測量了其隨溫度的變化,最後探討了這種材料對兩種氣體的感特性。
  5. Humidity - dependent resistor

    濕敏電阻
  6. Thin film resistive - type polymer humidity sensors have been prepared on small interdigital gold electrodes, using sodium polystyrenesulfonate ( n pss ) and sodium salt of hydrated poly ( styrene - alt - maleic anhydride ) ( na - sma ) as sensing materials

    本文以聚苯乙烯磺酸鈉( napss ) 、苯乙烯?馬來酸酐共聚物鈉鹽( na - sma )等為材料,在小型叉指金極上成膜,制備了高分子型薄膜元件。
  7. Resistance type humidity sensors for use in electronic equipment. part1 : general specification

    子設備用元件.第1部分:總規范
  8. Resistance type humidity sensors for use in electronic equipment. part2 : sectional specification : resistance type humidity sensors with linear characteristic

    組合型元件.第2部分:分規范:子設備用元件
  9. Resistance type humidity sensors for use in electronic equipment. part2 : blank detail specification : resistance type humidity sensors with linear characteristic assessment level e

    子設備用元件.第2部分:空白詳細規范:組合型元件評定水平e
分享友人