煅燒料 的英文怎麼說
中文拼音 [shāoliào]
煅燒料
英文
baked mass-
For this reason the distributor for the bed directly above the calcination stage should be made of heat-resistive material.
基此理由，直接位於煅燒段之上的床層分佈板必須用耐熱材料製成。Clinker burning of special cement with precalciner kiln
用預分解窯煅燒特種水泥熟料Study on the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process using kaolinite as raw material showed that impurities introduced by kaolinite mainly increased the liquid amount at high temperature, which can assist sintering of specimen. the experiment results indicated that the samples with lower gahnite content had better sinterability than others. however, if the gahnite content was relative high, the promoting effect on sinterability caused by kaolinite was not significant
採用天然原料高嶺土二步煅燒合成剛玉?莫來石?鋅鋁尖晶石復相材料研究發現：天然原料中帶入的雜質主要是增加液相量，促進高溫下試樣的燒結；當尖晶石含量較低時，試樣在1300保溫2h時，在1600燒后試樣燒結性能相比之下較好；而當鋅鋁尖晶石含量較高時，天然料對試樣的促燒作用不是非常明顯。Based on orthogonal designed experiment, the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process showed that the light fired temperature and holding time mostly influenced the apparent porosity of the multiphase materials. further study on the light firing time indicated that at the light firing temperature of 1300 and died fire temperature of 1600 for 3h, the optimal light fired time was about 1h
二次煅燒及正交實驗合成復相材料研究表明：輕燒溫度和輕燒時間對復相材料的顯氣孔率影響顯著；通過輕燒保溫時間的進一步研究表明：含剛玉、莫來石、鋅鋁尖晶石的復相材料，在輕燒溫度為1300 、終燒條件為1600下保溫3h時，最佳的保溫時間為1小時左右。The effects of calcinations temperature and holding time on the perovskite phase of synthesized pmn - pt have been studied
並研究了煅燒溫度及保溫時間對合成材料單相性的影響。Study of influences of performances of material to induration and circle forming in coal - fired rotary kiln for lime
原料性能對石灰回轉窯煅燒及結圈影響的研究Technical features : utilizes advanced second sintering technology, and has world - advanced fully computerized multi - pipe spreading technology, compounding microlite glass to surface of vitrified tile, and organically blend through second high temperature firing, so the product achieves a higher level in strength, luster and surface crystal feeling
技術特點：採用領先的二次燒結技術和具有國際先進水平的全電腦多管道布料技術，將微晶玻璃復合在陶瓷玻化磚的表面，經二次高溫煅燒有機融合於一體，令產品強度、光澤度與表面晶瑩質感達到另一個高度。Paper faced gypsum board is mainly made of construction plaster ( calcined with natural gypsum of chemical by product ) and protective paper, mixing with appropriate fiber, modified starch, coagulant agent, vesicant and water
紙面石膏板是以建築石膏（利用天然石膏或化學副產品石膏煅燒制得）和護面紙為主要原料，摻加適量纖維、改性澱粉、促凝劑、發泡劑和水，經混合、成型、凝固、切斷、烘乾、切邊等工藝製成的輕質建築板材。Industrial waste containing wolfram acted as mineralizer in the burning of cement clinker
用含鎢工業廢棄物作礦化劑煅燒水泥熟料Using burnability index to control the burning temperature of rotary kiln
用生料易燒性指數控制回轉窯煅燒溫度Influence of mno2 on the burnability and mineral formation of alite - sulphoaluminate cement clinker
硫鋁酸鹽水泥熟料煅燒及礦物形成的影響Paper faced gypsum board is mainly made of construction plaster calcined with natural gypsum or chemical by - product and protective paper, mixing with fiber, modified starch, coagulant agent, vesicant and water. which are mixed, formed, coagulated, cut, dryed and sliced into light construction material. they have advantages of light weight, fire resistance, soundproof, damp proof, heat insulation, easy to operate sawn, nailed or milled an disassemble. it s widely applied in industrial and civil constructions, especially widely used as interior wall, less loading wall, ceiling etc in high buildings
紙面石膏是以建築石膏利用天然石膏或化學副產品石膏煅燒制得和護面紙為主要原料，摻加適量纖維改性澱粉促凝劑發泡劑和水，經混合成型凝固切斷烘乾切邊等工序製成的輕質建築板材。In order to obtain the strontium titanate nanocrystalline powers materials with small grain, high purity and homo - geneous grain size distribution, the effect of water, waiter - free acetic acid, gel temperature, heat treat temperature and so on were researched
為了制備出晶粒小、材料純度高以及粒徑分佈均勻的納米鈦酸鍶粉體材料，研究了用水量、冰醋酸加入量、凝膠溫度和煅燒溫度等工藝參數對制備納米鈦酸鍶粉體材料的影響。It has to be crushed after firing and the aggregate therefore has sharp corners.
煅燒后需要進行破碎，因此骨料具有尖銳的稜角。Experience of burning white cement clinker in precalciner kiln
預分解窯煅燒白水泥熟料的體會The nanoparticle titanium dioxide was prepared with tnb as raw material by the sol - gel process, the effects of the alcohol salt concentration the kind of solvent the water volume hydro1yze temperature. the dried ways of the wet gel and the calcined temperature of the dry gel on the specific surface area. particle size
本文以鈦酸丁酯為前驅體，利用溶膠?凝膠法制備了納米級的tio _ 2粉體材料，通過正交實驗研究了醇鹽的濃度、溶劑的種類、水含量、水解溫度、乾燥條件和煅燒溫度等工藝條件對納米粒子的比表面積、粒徑大小及分佈、晶相組成等性能的影響。The homogenous precursor of magnesium niobate titanate was prepared under high temperature by adjusting the excess content of mgo after milling
通過研磨，高溫煅燒等工藝，調節鎂的含量，制得了均勻的先驅體粉料。The magnesia - alumina spinel is synthesized by using high - quality bauxite and active magnesia as starting materials and calcined at high temperatures. the spinel has high density and low water absorption rate
本品採用優質鋁礬土與活性氧化鎂合成，經高溫煅燒，體積密度大，吸水率低，是冶金建材行業理想的原料。Ceramic grain filters ard made of refined pottery clays added with certain modifiers, and processed of grinding, mixing, shaping and high temperature sintering. they do not contain any substances that harmful to people or environment. they are hard and rough in surface, porous inside the structure, and have the advantages of high mechanical strength, large specific surface area and porosity. when used in water treatment, they behave a activated surface property, a great amount of pollutant entrapment, less water head loss in the filter bed, lower consumption of back - flush water, stable in chemical and gbiologic property, and long service life, ceramic grain filters is a new and efficient filter material to increase the water yield, upgrade the water quality, and save chemicals and energy
陶粒濾料是以精製陶土為主要原料，摻加適量改性劑，經粉碎，混練，成型和高溫煅燒而製成的，不含任何對人體和環境有害的物質.其表面堅硬，粗糙，內部疏鬆，多孔，具有機械強度高，比表面積大，孔隙率大的特性.用於水處理中，具有表面性狀好，截污能力強，過濾水頭損失小，反沖洗耗水量低，化學穩定性和生物學穩定性好，使用壽命長的特點.陶粒濾料是一種能增加水產量，提高出水質量，節省藥劑和能耗的新型高效過濾材料Textile glass reinforced plastics - prepregs, moulding compounds and laminates - determination of the textile - glass and mineral - filler content - calcination method
玻璃纖維增強塑料.預浸料坯模塑料及層壓板.玻璃纖維和礦物填充料含量的測定.煅燒法分享友人