煙灰濃度 的英文怎麼說

中文拼音 [yānhuīnóngdù]
煙灰濃度 英文
ash concentration
  • 煙 : Ⅰ名詞1 （物質燃燒時產生的氣體） smoke 2 （像煙的東西） mist; vapour 3 （煙草） tobacco 4 （紙煙、...
  • 灰 : Ⅰ名詞1 （物質燃燒后剩下的粉末狀的東西） ash 2 （塵土; 某些粉末狀的東西） dust 3 （特指石灰） lime...
  • 濃 : 形容詞1. （液體或氣體中所含的某種成分多; 稠密） dense; thick; concentrated 2. （程度深） （of degree or extent） great; strong
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 煙灰 : tobacco or cigarette ash; soot煙灰缸 ashtray; tobacco tray
  • 濃度 : potency; thickness; concentration; consistence; strength; consistency; density
  1. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下，不同流速對熱管空氣預熱器壁面溫度的影響；然後對影響整個流場分佈的各種因素：包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬；最後提出在分流煙道轉彎處加裝導流板，並模擬加裝導流板后的流場分佈，得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈，以論證加裝導流板能達到流場均勻化的作用。
  2. It tell us : the abrasive capability of fly ash ; the similar calculation of ash erosion ; the calculation of ash erosion in the tube in turn and tube out of turn ; the reason of tube abrasion for gas flue ; the influence of air parameter for fly ash erosion ; the influence of changing temperature ; the influence of the flue gas composition, etc. next, it advances the solving measure ; reduce the flue gas velocity ; reduce the concentration of fly ash ; responsible construction : replace smooth tube with spiral tube ; use the new material of abrasion ; fuel desulfurization ; reduce so3 of flue gas ; raise flue gas temperature, making it up the dew point ; use the abrasion - resistance material to resist abrasion

    討論了飛灰磨損性能、管壁受飛灰沖蝕的近似計算、灰粒對順列管和錯列管的磨損計算、煙氣走廊引起對流管束的磨損機理、空氣動力參數對飛灰沖蝕的影響以及受熱面壁溫變化及煙氣成份對飛灰磨損的影響等問題。接著提出了解決的措施：降低平均煙氣流速；降低飛灰濃度；使用鰭片管、螺旋翅片管代替光管；選擇合適的結構及排列方式，減少煙氣中so3的含量；提高受熱面壁溫使之大於煙氣的露點溫度；採用抗腐蝕材料作受熱面等防腐蝕的措施。
  3. There will appear a very uneven flow field, and appear a very big velocity magnitude distribution and ash concentration distribution near back wall. thus, the velocity magnitude is far bigger than that of optimal design velocity magnitude, which will lead to serious wear and tear in metal face of heater. especially, because of curve structure in front of heat pipe air preheater, there is more serious wear and tear

    由於靠近豎井后墻面的煙氣流速很大，飛灰濃度也較大，斷面速度分佈的最大速度大於最佳設計速度的2 - 3倍，這樣將造成受熱面的嚴重磨損，特別是熱管空氣預熱器前端煙道的幾何結構有一定的轉角，更增加了磨損的程度。
  4. This paper also analyzes the ash wear mechanism, and then does the effects of low temperature economizer wear five factors : the first is the smoke corridor caused by wear mechanism, the second is the impact on the wall material, and the third is that of flying ash concentration, the fourth of the excess air ratio, and the fifth is the change in the composition of the gas to wear the impact

    分析了飛灰磨損的機理，然後分析了影響低溫省煤器磨損的5種因素，一是煙氣走廊引起磨損的機理；二是管壁材料的影響；三是飛灰濃度的影響；四是過量空氣系數的影響；五是煙氣成分的變化對磨損的影響。
分享友人
分享到 Line

分享到臉書