熔化劑 的英文怎麼說

中文拼音 [rónghuàjì]
熔化劑 英文
consumable agent
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 熔化 : melt; smelt; meltdown; fusion; fusation; diatexis; eliquation; run; melting; smelting
  1. Methods for chemical analysis of melted welding fluxes. the pyrolytic method for determination of calcium fluoride content

    熔煉焊劑化學分析方法.熱解法測定氟化鈣量
  2. Methods for chemical analysis of melted welding fluxes. the lead chlorofluoride - edta volumetric method for determination of calcium fluoride content

    熔煉焊劑化學分析方法.氟氯化鉛- edta容量法測定氟化鈣量
  3. First to heat pvc and sulfur together at a certain temperature, where the melted sulfur being a fine dehydrogenating agent, captured hydrogen from pvc bone chain and led to an electrially conductive polymer with conjugated electrons

    採用聚氯乙烯與單質硫在一定的溫度下加熱處理，在熔融狀態下的單質硫作為良好的脫氫氧化試劑，使聚氯乙烯主鏈脫氫形成具有共軛電子的導電聚合物。
  4. A kind of stainless steel flux - cored wire has been successfully developed, based on acid slag type system, by adding a bit of oxides and trace of deoxidizer, adjusting the fluidity of melting slag to increase shielding of the back weld

    在酸性渣系的基礎上，通過添加少量氧化物，調整熔渣的流動性，並加入微量的強脫氧劑，以增強背面焊縫的保護，研製成功一種背面不充氬的不銹鋼打底單面焊雙面成形專用藥芯焊絲。
  5. It is composed of melting furnace, heat holding furnace, transport system, and quantitative feeding system. it can fulfil vacuum refining of the magnesium alloy meltings without adding solvents, and can transport the meltings quantitatively to the gate of the die - casting machine, and prodt e qualified die - casting magnesium alloy products

    該設備由熔化爐保溫爐傳輸系布定量給料控制系統四部分組成，可將鎂合金熔液在不加熔劑的情況下進行精煉，並定量傳輸至壓鑄機進料口，從而壓鑄出合格的鎂合金產品。
  6. Strong negative 8 eu shows the granites are high evolved granite. ( 6 ) the tetrad effect of ree and the obvious fractionation between k - rb, y - ho, zr - hf, nb - ta, and sr - eu in the dajishan granites indicate that, the aqueous fluid pays an important role in the evolution of the granites, as well as indicate that there exist enough interaction between peraluminous melt and aqueous magmatic fluid. furthermore the fluorine played a very important role in this process

    （ 6 ）大吉山花崗巖類稀士元素具有「四重效應」配分的特點以及微量元素對kjrb 、 y / ho 、 zr艦f以及nb / ta發生明顯分異，暗示在花崗巖巖漿的演化過程中，經歷了充分的流體一熔體作用，同時分異出大量富含f 、 w等礦化劑元素和成礦元素的熱液流體，致使鎢礦的形成。
  7. Antiwear ( aw ) agent additive that is active in preventing damage caused by occurrence of solid phase welding between sling surfaces without local surface melting

    抗磨（ aw ）添加劑相互滑動的表面因發生相互摩擦會造成損壞。抗磨添加劑就是能有效防止這類磨損，同時又不會發生滑動的表面熔化的添加劑
  8. Standard practice for determination of fusion temperature of dry electrostatic heat - fixing toners

    干靜電熱定影的調色劑熔化溫度的測定
  9. Test methods for lead - free solders - part 1 : methods for measuring of melting temperature ranges

    無鉛焊劑的試驗方法.第1部分:熔化溫度范圍的測量方法
  10. Study on the optical properties of transparent epoxy / clay nanocomposites a new type transparent epoxy based nanocomposites has been prepared by the reaction of alkylammonium exchanged montmorillonite ( amt ) with diglycidyl ether of bisphenol a ( dgeba ) and triethylamine as the curing agent. the morphology of amt in the epoxy matrix was characterized with x - ray diffraction ( xrd ), scanning electron microscopy ( sem ) and transmission electron microscopy ( tem )

    光學透明環氧樹脂粘土納米復合材料光學性能採用十八烷基伯胺鹽、十六烷基三甲基溴化胺處理na基蒙脫土製備出兩種不同的有機土，以三乙胺為固化劑，有機土與雙酚a型環氧樹脂熔融插層聚合后制備出剝離型和插層型兩種結構的環氧樹脂粘土納米復合材料。
  11. The catalytic activity of ( hmbp ) 2ticl2was lower than - diketonate titanium catalysts. the catalytic activity of dinuclear - diketonate titanium catalysts was comparative to mononuclear ones. however, the dinuclear - diketonate titanium catalyst showed the synergism effect, for example, the lower catalyst concentration and the molar ratio of al to ti, the activity reached the maximum value at 80, the melting temperature of polymer was enhanced

    2 -羥基苯酮鈦[ （ hmbp ） _ 2ticl _ 2 ]的催化活性低於-二酮鈦類催化劑；雙核催化劑在催化活性方面與對應單核催化劑相差不多，但在聚合規律上表現出與單核催化劑不同的雙核協同作用，如聚合所需的催化劑濃度、助催化劑甲基鋁氧烷mao量降低，活性在80時出現極值，熔點提高等，而且雙核催化劑是單活性中心催化劑。
  12. The results showed that the melting ratio of silica flux decreases and the complete melting time prolongs with the size of silica flux and matte grade increasing, and the effect of the blowing air and oxygen enrichment is not remarkable in the high grade copper matte converting process

    對于高品位冰銅轉爐吹煉，鼓入氣體流量和氧濃度對石英熔劑熔化率影響不顯著；熔劑粒度和冰銅品位對熔化率影響顯著，並隨著熔劑粒度和冰銅品位的增加，熔劑熔化率降低，完全熔化時間延長。
  13. In this paper the formula, the technics, the dosage of the filler and the macromolecule coupling agent are studied which influence the technics condition, mechanical properties, structure configuration. also x - ray large angle diffraction, scan electron microscope, dta etc are used to analysis and test the properties of the pp / talc composites. conclusions as follows : 1

    本文系統地研究了復合體系配方、工藝方法、填料及偶聯劑用量對復合體系工藝條件、力學性能及結構形態的影響，同時利用廣角x射線衍射、掃描電鏡、 dta等對復合體系的性能進行了測試與分析，主要研究內容及結論如下： 1滑石粉的加入，雖然使pp的熔化時間增加，但是混煉能耗下降，有利於pp的加工；偶聯劑的加入，使pp的熔化時間增加，能耗略有降低，總體而言，對加工無不利影響。
  14. Several factors affecting the melting of silica flux, such as the size of silica flux, matte grade, blowing air and oxygen enrichment were discussed

    主要考察了熔劑粒度、冰銅品位、鼓入氣體流量和氧濃度對石英溶劑熔化的影響。
  15. The result of experiment showed that the reaction between ti and c is a thermodynamic course, when 2 wt % mg is added to melt, it can restrain the formation of fragility phase al3ti, and gained al matrix composite which contained tic reinforced particles only. because mg reacts with the forms a micro - high temperature field around the oxide around the graphite particles and the oxygen gas which is brought by the immersion bell, and the reaction gives out a lot of heat energy, thus forms many high micro - fields in melt, which prompt the reaction between the al and ti

    加入適量的mg （ 2wt ）可以抑制tic al復合材料中的脆性相al _ 3ti的產生，生成僅含tic的鋁基復合材料；由於活化劑鎂在體系中與石墨顆粒周圍的氧化物、以及外來的氧反應放熱，在熔體中形成微高溫區，促進al - ti反應，同時， al - ti反應也是放熱反應，因此體系中的內能急劇增大，促使al _ 3ti分解以及ti朝c顆粒擴散，縮短反應的孕育時間。
  16. The main results of this study are summarized as folio wings : firstly, the effect of rare earth - doped catalyst to the synthesis of carbon nanotubes was systemic studied ; the vary of morphology and content of catalyst in the catalysis synthesis process of carbon nanotubes was also deeply investigated, which is helpful to the understanding of carbon nanotube growth mechanism

    本文利用cvd和熔劑法及直接氧化法在合成和表徵碳納米管、硼基納米材料及其他若干材料等方面做了以下初步的探討： （ 1 ）系統研究了稀土摻雜催化劑對碳納米管生長的影響及催化合成碳納米管過程中催化劑形貌和成份的變化，加深對碳納米管生長機制的理解。
  17. Abstract : melting behavior of silica flux in the converting process of high grade copper matte was investigated

    文摘:研究了高品位銅冰銅轉爐吹煉石英熔劑熔化行為。
  18. Embedded in a flux of dehydrated b2o3, melts of ge and ag etc. were undercooled by repeatedly treatment of melting and solidifying with a dsc facility, with undercooling of 190 k and 146. 9 k respectively for ge and ag

    對半導體ge 、金屬ag等樣品的過冷現象進行了研究和分析。通過助熔劑包裹和反復熔化與凝固處理，實驗得到的ge 、 ag的最大過冷度分別為190k和146 . 9k 。
  19. It is made of fused magnesite and high purity flake graphite by adding metal composite antioxidant and phenolic resin as binder. it has the excellent properties of corrosion resistance, spalling resistance, resistance to oxidation and better thermal shock resistance. it can be used in all kinds of converters, eaf, refining ladles and common ladles. upon request, multiple lining - up designs of reasonable materials can be provided according to the working conditions of above mentioned furnaces

    採用電熔鎂砂、高純鱗片石墨為主要原料，添加金屬復合抗氧化劑，以酚醛樹脂為結合劑製成的製品具有優良的抗浸蝕性、抗剝落性、抗氧化性和良好的抗熱震性，適用於各種容量的轉爐、電爐、精煉鋼包及普通鋼包，本公司可根據用戶要求，針對上述4種熱工窯爐的具體使用條件提出爐襯的材質綜合砌築方案。
  20. Antiwear ( aw ) agent additive that is active in preventing damage caused by occurrence of solid phase welding between sliding surfaces without local surface melting

    抗磨（ aw ）添加劑相互滑動的表面因發生相互摩擦會造成損壞。抗磨添加劑就是能有效防止這類磨損，同時又不會令發生滑動的表面熔化的添加劑。
分享友人
分享到 Line

分享到臉書