熔結帶 的英文怎麼說

中文拼音 [róngjiēdài]
熔結帶 英文
clinkering zone
  • : 動詞(熔化) melt; fuse; smelt
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  1. And apatite. by these analyses and comparison with general granite both in china and the world and with the granite in other au or cu belt in china, the characteristics of the granite in this area are concluded as follows. it belongs to magnetite - i or syntectic granite and has crust - mantle mixed characteristics ; it was formed mainly by crystallization differentiation of melting magma and multiphase varied intrusion ; the degree of differentiation evolvement is not high ; the granite and its enclaves p. re congenetic ; the range of temperature is about 500 - 700, the range of pressure is about 2. 50 gpa - 4. 35 gpa, and the range of oxygen fugacity ( lg fo2 ) is - 15. 53 - - 14. 00 ; most granite bodies formed before the collision of plates, and few formed after the collision of plates

    通過對測試數據的分析與綜合研究,並同中國和世界一般花崗巖類以及中國主要金、銅成礦巖體的花崗巖類進行對比,得出本區花崗巖類巖石具有以下特徵:屬磁鐵礦-型或同型花崗巖,其巖漿物質具殼幔混源特徵:主要由融態巖漿經晶分異作用,通過多期變速上侵而形成;其分異演化程度較低;寄主巖基和包體具有同源性;巖石的形成溫度范圍約為500 - 700 ,壓力大約為2 . 50gpa - 4 . 35gpa ,氧逸度值1gfo _ 2為- 15 . 53 ? 14 . 00 ;該巖主要形成於板塊碰撞前消減的活動板塊邊緣期,為燕山至喜馬拉雅早期的大陸邊緣火山弧環境的產物。
  2. However, in the area with strong magma mingling, there are widespread abnormal fabrics, distinguished differences in the idiomophic - textures and the peritectic reaction, poililitic texture, metasomatism among the minerals, metasomatic border, embayment, rimmed structure, abnormal plagioclase zoning, relict fabric as well as the acicular apatite are very common

    巖石的異常構構造十分發育,礦物之間自形程度差異顯著,常見包晶反應、包含構、交代邊、蝕邊、交代蠶食的港灣狀構構造及交代縫合線、礦物鑲邊、斜長石異常環和礦物殘留等,多見指示巖漿混合的標志性礦物針狀磷灰石。
  3. Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. , if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios

    文摘:在某些廢鋼煉過程中,當爐料中含碳及碳氫物質且燃燒不充分時,會來煙氣中一氧化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變化,試驗果表明,反應過程的限制性環節是油分的熱分解;在較低的溫度下( co ) / ( co2 )比例影響轉化率和二次燃燒率;而在任意比例下保證充分反應的溫度為900以上
  4. Base on two - stage approach, we adjust experimental parameter to develop a new method ( three - stage approach ) to prepare c - bn thin films. the study proves that it is favorable to prepare bn thin films of high cubic phase content. depositing time and substrate bias voltage in the first stage are 5 min and - 180v respectively

    根據si片上bn薄膜的反射光譜r ( )和融石英片上bn薄膜的反射光譜r ( )和透射光譜t ( )各自獨立的計算了bn薄膜的光學隙,利用兩種方法分別計算立方相含量均約為55 %的bn薄膜的禁寬度為5 . 38ev和5 . 4ev ,其果均和由經驗公式計算得到的果非常接近。
  5. During the yanshanian phrase, the area is in the condition of contractional background, with multi - staged tectonic reversion. 5. through studying the origin of volcanic rocks and the characteristics of magma evolution, it concludes that there exist 3 originated areas of magma - from mantle, crust, and mantle - crust exchange. the basic magma of nandaling volcanic rocks of early jurassic is derived from upper mantle ; the magma of tiaojishan volcanic rocks of mid jurassic is formed in the contractional tectonic setting, and derived from the transition zone of crust and mantle interaction ; the acid magma of l

    5 、通過巖石化學、微量元素、稀土元素的研究,探討了不同級別節律的火山巖成因、巖漿演化等特徵,認為本區燕山期火山巖有三個巖漿源區,即地幔源、地殼源和殼幔混源,早侏羅世的南大嶺旋迴的基性巖漿,起源於上地幔;中侏羅世髫髻山旋迴火山巖是在相對擠壓環境中,巖漿起源於殼幔過渡;晚侏羅世無負eu異常的酸性巖漿來源於下地殼的古老晶基底的局部融,有負eu異常的酸性巖漿來源於上地殼的局部融;早白堊世火山巖基性巖漿起源於上地幔,中性巖漿起源於下地殼底部的殼幔過渡
  6. It has a broader absorption band at 808 nm which is emitted by laser diode ( ld ). therefore, nd : cngg is suitable for ld pumping, the ld pumped all solid - state lasers can be made by using nd : cngg. in this study, nd : cngg single crystals of 25mm in diameter and above 80mm in length were successfully grown by the automatically pulling method from the melt

    摻釹鈣鈮鎵石榴石(簡稱nd : cngg )是一種新型激光晶體,該晶體點低( 1470 ) ,具有無序構,在通用的808nm半導體激光二極體( ld )發射波長區有寬吸收,因此很適合ld泵浦,可做成ld泵浦全固態激光器。
  7. Based on our theoretical predictions, we find optimal splicing parameters on fsm - 30s fiber splicer for low loss joints between erbium doped fiber and other single mode fibers. we also experimentally demonstrate a novel three - stage erbium - doped fiber amplifier with high gain, low noise figure, and high output power. finally, a prototype of a gain - clamped fiber amplifier is obtained with high gain ( 26 db ), low noise figure ( 5. 3 db ), high output power ( 17 dbm ), and large bandwidth ( 31 nm )

    文章研究了摻鉺光纖( edf )與其他光纖低損耗焊接問題,得到光纖接機低損耗接的最佳參數,這對摻鉺光纖放大器的科研生產具有一定的指導意義;研究了新型的三段級聯泵浦優配的摻鉺光纖放大器的優化光路構,得到高增益,低噪聲,大輸出功率的摻鉺光纖放大器;最後研製成功高增益( 26db ) ,低噪聲( 5 . 3db ) ,大輸出功率( 17dbm ) ,寬( 31nm )增益箝制摻鉺光纖放大器樣機。
  8. Electrospinning origins from that electrically charged fluid is forced jets in the high voltage electrostatic field. electrospinning occurs when the electrical forces at the surface of a polymer solution or melt overcome the surface tension and cause an electrically charged jet to be ejected. when the jet dries or solidified, an electrically charged fiber remains

    電紡絲技術是基於高壓靜電場下導電流體產生高速噴射的原理發展而來,其基本過程是:聚合物溶液或體在幾千至幾萬伏的高壓靜電場下克服表面張力而產生電噴射流,溶液或體射流在噴射過程中乾燥、固化,並保持一定電荷量,最終落在接收裝置上形成纖維氈或其它形狀的纖維構物。
  9. The lack of the penetration of welding bead is a typical defect. it will do great harm to the quality and safety of the welding structure

    焊縫深不足是焊縫及焊接接頭內部的一個典型缺陷,會給焊接構的質量及使用安全來危害及影響。
  10. Pressure resistant circular glass - to - metal fused sight glasses - part 1 : for holders with recess ; design steel ; operating temperatures - 30 c and - 60 c

    耐壓圓形玻璃與金屬的瞄準鏡.第1部分:用於凹槽
分享友人