熱凝固膠 的英文怎麼說
中文拼音 [rènínggùjiāo]
熱凝固膠
英文
thermosetting cement- 凝 : 動詞1. (凝結) congeal; curdle; coagulate 2. (注意力集中) fix
- 固 : Ⅰ形容詞(結實; 牢固; 堅硬) firm; hard; solid Ⅱ副詞1 (堅決地; 堅定地) firmly; resolutely 2 [書...
- 膠 : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
- 凝固 : solidify; solidification; coagulation; congealing;clotting; hardening; solidifying; freezing
-
Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )
體積電阻率的測定:當r _ v 10 ~ 8時,製成100 100 4mm板材,用zc36型高阻儀測量;當r _ v 10 ~ 8時,用dt - 9205b型數字式萬用表測試試樣的體積電阻,為了減小接觸電阻對測試的影響,採用銀導電膠將銅片粘接在試樣的兩個端面上,靜置24小時,待銀導電膠凝固,試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。These stresses arise from the exothermic nature of the reaction during gelatin and cure.
這種殘余應力系由凝膠和固化期間化學反應能放出的熱引起的。08. 02 test method for gel time and peak exothermic temperature of reacting thermosetting resins
活性熱固樹脂膠凝時間和最大放熱溫度測試方法Heat sets eggs and cold sets jullies
加熱能使蛋凝結,寒冷能使凍膠凝固。The sol - gel method and solid - state thermal reaction technique were used to prepare the composite oxides with variable lithium content. the doping treatments of some compounds were conducted. dta and tg were used to analyse synthesis mechanism, xrd to analyse phase composition, sem to observe morphology, li - b / licl - kcl / oxide simulated thermal cells to analyse the lithium - intercalation mechanism and properties of cathode material
實驗中採用溶膠?凝膠工藝和固相熱反應技術制取相應的不同鋰含量的復合氧化物,並嘗試對某些化合物進行適當的摻雜處理,應用dta和tg分析合成機制、 xrd分析所得物的物相組成、 sem觀察其形貌,模擬li - b / licl - kcl /氧化物的單體熱電池來分析陰極材料的嵌鋰機制及其電極性質。Methods of testing plastics - other properties - determination of gelation time of thermosetting resins using a hot plate
塑料試驗方法.第8部分:其他性能.試驗方法835d :用熱板測定熱固性樹脂膠凝時間Testing methods for paint - part 9 : coating powders - section 1 : determination of gel time of thermosetting coating powders at a given temperature
塗料的試驗方法.第9部分:塗料粉末.第1節:在給定溫度下測定熱固性塗料粉末的膠凝時間It has exact processing and heat treatment gate bushing, the part of heat can be delivered to the steel around the gate which make the plastic just enter wouldn ' t be frozen so quickly. it applies to crystalline materials
帶精確加工及熱處理的一體澆口司,能傳遞部分熱量至澆口區域的金屬,使得剛一進入型腔的塑料不至於迅速凝固,適于快速凝結的結晶性塑膠。Luub is easy to disperse in rubber, thermosets and thermoplastics greases and printing ink. it will not lump or agglomerate in handing
Luub易於分散在橡膠,熱固性塑料及熱塑性塑料,油脂,油墨中。凝結不結團。The tlow distance and gelating time of the nanocomposites were shorter than that of the pure pf, which meet the standard of the pf used in frictional materials. compared to the pure pf, the silica7pf nanocomposites exhibited excellent heat stability only in nitrogen atmosphere, however, so do vermiculite / pf nanocomposites in both nitrogen and air atmospheres. compared to the brake pad based pf resin, the wear rate of the present one based with silica / pf nanocomposite decreased obviously, especially in high temperature
用烷基銨ctab和kh - 560對蛭石進行有機化處理,通過原位聚合法制備了酚醛樹脂接枝改性sio _ 2納米復合材料、酚醛樹脂kh - 560改性sio _ 2納米復合材料、酚醛樹脂ctab改性蛭石納米復合材料、酚醛樹脂/ kh . 560改性蛭石納米復合材料,採用ftir 、 xrd 、 afm和tg分析與流動距離、凝膠化時間的測試,研究了所制備的酚醛樹酯納米復合材料的結構、固化行為和熱穩定性能,並研究了以酚醛樹酯納米復合材料為基體的剎車片摩擦磨損性能。As the content of vermiculite minerals increased, the content of the " intercalated " shape, in which crystal gallery breadth was about of 40nm, also increased. in the curing reaction processing of polybenzoxazine / vermiculite hybrid nanocomposites intercalated with bisphenol a type precursor. according to the content of vermiculite minerals, while different shape of crystal was forming, these crystals were retarding the heat ring - opening polymerization of bisphenol a type precursors in the nanocomposites
通過對雙酚a型ben蛭石納米插層物固化過程的分析:不同蛭石含量的插層物,在形成不同納米分散狀態固化結構的過程中,蛭石晶片對雙酚a型ben的熱開環聚合有明顯不同的阻礙作用,蛭石含量為3的插層物160的凝膠化時間較純樹脂的延長約7min ,活化能高約8kj mol ,固化反應熱晗低約14j g ,使得固化物的固化程度較純樹脂低約10 ,阻礙作用最大,其它含量的次之。Standard test method for gel time and peak exothermic temperature of reacting thermosetting resins
活性熱固樹脂膠凝時間和最大放熱溫度的標準測試方法Standard test method for gel time of thermosetting coating powder
熱固塗料粉的膠凝時間的標準標準試驗方法Thermosetting powder paints. determination of the gel time at a given temperature
熱固性粉末狀塗料.在給定的溫度下膠凝時間的測定Coating powders - part 6 : determination of gel time of thermosetting coating powders at a given temperature iso 8130 - 6 : 1992, including amendment 1 : 1998
粉末塗料.第6部分:在給定溫度下熱固性粉末塗料膠凝時Nickel - zinc ferrites are important electronic ceramic materials which are used in electronic devices suited for high - frequency applications in the telecommunication field, the synthesis of the powder has always been the subject of extensive studies. besides the traditional synthesis, there are some new methods, such as : hydrothermal synthesis. sol - gel synthesis and citrate precursor method, but all these method have not been extensive applied because of their shortcomings
鐵氧體是一類具有非常廣泛用途的磁性材料,其粉料的制備方法一直是人們探索的課題,除了用傳統的固相反應法外,它還可以用水熱法,溶膠凝膠法,檸檬酸鹽法等濕法技術,但由於上述方法各有其局限性,沒有實現大規模的生產。In order to solve the problem of stability fading, sol - gel method and hydrothermal synthesis method, called as soft chemical methods, were employed to prepare the materials and improve the performance by the body - doping
為了解決固相合成法獲得的層狀limno2電化學穩定性差的問題。本文採用了溶膠凝膠和水熱合成兩種軟化學方法對材料進行合成和體相摻雜改性。分享友人