熱條件 的英文怎麼說

中文拼音 [rètiáojiàn]
熱條件 英文
heat condition
  • 條 : Ⅰ名詞1 （細長的樹枝） twig 2 （條子） slip; strip 3 （分項目的） item; article 4 （層次; 秩序; 條...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 條件 : 1. （客觀的因素） condition; term; factor 2. （提出的要求） requirement; prerequisite; qualification
  1. All experimental investigations about the geothermal conditions are based on measurements of original rock temperatures.

    有關地熱條件的所有實驗研究都是建立在測量原始巖體溫度的基礎上。
  2. In this paper, oxid crystals were synthesized by the hydrothermal method, and the effects of the hydrothermal condition on shape and quality of crystal were studied by changing experimental temperature and mineralizer. on the base of these works the blue sapphire dopped with fe, ti and sapphire dopped with ti were synthesized. meantime, the effects of ti, fe - dopped on sapphire and what lead to the blue of sapphire were studied

    本文採用水熱法合成了- al _ 2o _ 3和zno晶體，通過改變溫度和礦化劑條件研究了水熱條件下溫度和礦化劑對- al _ 2o _ 3和zno晶體合成的影響；在此基礎上通過摻雜致色元素，合成了藍色藍寶石、鈦藍寶石，並研究了fe 、 ti等致色離子對藍寶石晶體界面形態和質量的影響，分析了藍寶石的致色原因。
  3. Depending the pneumatic delivers to torque, the construction is simple, make and installing the technique request to be low, thermolysis would be better to not as good as ventilated type, the pneumatic capacity is bigger, the aeration and deflate time longer, easy is slippery

    靠氣胎傳遞扭矩，結構簡單，製造、安裝技術要求低，散熱條件不如通風型，氣胎容積較大，充氣、放氣時間較長，容易打滑。
  4. It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods

    對其充灌量、散熱量、電子元件（ cpu模擬晶元）表面與環境溫度之差及通風、流速的影響進行了系統的測試，發現充液量與溫差的關系在負荷不變時呈拋物線分佈，其極小值點對應的充液量是最佳充液量g 。在充液量為g時，對風速v 、散熱量q進行的研究表明，當風速超過1 . 5m / s后，奔騰晶元在60w發熱條件下晶元溫度小於40 ，能滿足長期正常工作。
  5. Thirty - one crystals of polyoxometalates ( 1d, 2d, 3d ) were prepared by means of middle hydrothermal technique, molecular design and self - assembly, and characterized structurally by single crystal x - ray diffraction. the thermal stability, activity of catalysis and magnetism of some compounds were systematically studied. the continuous appearance of p - v - o, p - mo - o, v - mo - o, v - o system with novel structure enrich polyoxometalate chemistry, the reaction characterization and the synthesis law of molybdates, tungstates and vanadates under hydrothermal conditions were explored

    由於p - v - o 、 p - mo - o 、 v - mo - o 、 v - o體系新結構不斷出現，豐富了多金屬氧酸鹽化學，探討水熱條件下釩、鉬、鎢物種的反應特性和生成規律，研究原料的選擇、配比、加料順序、濃度、酸度、反應溫度、反應時間等因素對產物的生成及結構的影響，為新的催化劑、導電材料、磁性材料的研製與開發積累經驗。
  6. The samples were welded at 800, 900. d _ ( cu ) and dni at contacting line increased with increase of welding temperature. and atom diffusion at contacting line welded by bpec heating was much quicker than by radiation heating

    其它條件相同時，改變裝模方式以獲得不同的加熱條件和電場條件，結果表明，無模套時接觸面處cu和ni的擴散系數比有模套時大。
  7. In this paper, three unique models were designed to research atom diffusion at interface, contacting line and joining point under bpec heating and compare with it under radiation heating in order to find out if bpec speed atom diffusion. the first model was aimed to research atom diffusion at interface under bpec heating. experiment condition of bpec diffusion welding sheet cu and ni : direct diffusion welding, at a pressure of l0mpa, welded at 750 ~ 900, with heat rate of 200 ~ 400 / min for 10mm, on / off of 6 / l ~ 48 / 8, with die or not, vacuum of 6pa

    本文設計出三種樣品預構件，研究脈沖大電流加熱條件下片狀材料、線狀材料和球形顆粒之間的原子擴散過程，弄清脈沖大電流加熱條件下原子擴散與一般燒結和焊接過程中原子擴散的區別，以證實特殊的電場和磁場是否對原子的擴散有推動作用，揭示脈沖大電流加熱條件下原子的擴散過程，探索脈沖大電流熱加工技術快速高效的原因。
  8. The third model was designed to investigate atom diffusion at contacting point. fe was sintered at 500, 550 > 600, 650 > 700 under bpec and radiation heating. the test results of image processing indicated that the average pore size took on wavelike with temperature under bpec heating

    脈沖大電流加熱條件下，其它條件相同時，分別在800 、 900的溫度武漢理土大學碩士學位論文下擴散連接cu絲和ni絲，結果表明接觸線處cu和ni的擴散系數隨溫度的升高而增大。
  9. Experimental inve stigation of the heat transfer and hydromechanical characterist ics of single - head quot; w quot; type spirally fluted tubes

    對流換熱條件下微鋼管壁面軸向導熱的實驗研究
  10. On the basis of test results, the effects of operation parameters such as material thickness, heating temperature and pressure of drying chamber on vacuum freeze drying are discussed. aiming at decreasing drying time and reducing energy consumption, these parameters are optimized and optimization results agree well with actual results

    在三因素二次正交回歸試驗的結果分析的基礎上，利用降維分析方法探討了凍干厚度、加熱板溫度和系統的真空度對乾燥時間和乾燥能耗的影響，並對混合加熱條件下單位水分能耗和凍干生產率進行了優化分析。
  11. Test method for corrosion of cast aluminum alloys in engine coolants under heat - rejecting conditions

    排熱條件下發動機冷卻劑鑄造鋁合金腐蝕性測試方法
  12. Standard test method for corrosion of cast aluminum alloys in engine coolants under heat - rejecting conditions

    在排熱條件下發動機冷卻劑對鑄造鋁合金腐蝕性的標準試驗方法
  13. Plastics - test methods of exposure to damp heat, steady state

    塑料在恆定濕熱條件下曝露試驗方法
  14. In terms of distribution characteristics, the conditions of light and warmth are the key factors determining the elements and their distribution in the core area

    從分佈特點來看，光熱條件是決定核心區內植被景觀要素及其分佈的重要因素。
  15. A global carbon tax would be a more efficient way to close the price gap between fossil and alternative fuels

    這些電池板本可以在光熱條件更理想的區域發揮更好的作用。
  16. However, unsatisfactory results were obtained under the following conditions : discharge tube covered with glass cover, thermal dispersion conditions not as effective, thermal expansion of the discharge tube restricted by the co - axis glass cover ( longer preheat time, lower anti - interference )

    在放電管外有玻璃罩，散熱條件差；放電管溫度變形受外玻璃罩約束的同軸式管子上則效果不理想（預熱時間較長，抗干擾能力不如前者） 。
  17. Preparation of manganese carbonate crystal through ligand ' s decomposing under hydrothermal condition

    水熱條件下由配體分解制備碳酸錳晶體
  18. Subsequently adiabatic condition about two states system is obtained

    隨后對二能級系統的絕熱條件提出了自己的見解。
  19. In practice, this dissertation focuses on the study of the aforementioned two problems, we have investigated and analyzed the controlling mechanism of the adiabatic conditional geometric quantum phase - shift gates for two - qubit, and realized the geometric quantum computation by making use of the nonadiabatic geometric phase of quantum states of the superconducting josephson junctions quantum interference device system. we have also discussed the accessible information of quantum signal resource ensemble, and studied the teleportation of an arbitrary d - dimensional tv - particle unknown state via a partially - entangled quantum channel ; this dissertation comes in four parts

    實際上，我們在本文中就上述兩方面的問題作了一些探討：研究和分析了兩量子位絕熱條件幾何量子相移門的控制機制，利用超導約瑟夫森結量子器件系統的量子態的非絕熱幾何相位實現了幾何量子計算、討論了信源系綜的可接收信息問題以及任意d維n粒子未知量子態通過部分糾纏量子通道的隱態傳輸問題等。
  20. The second part, which includes chapter 3 and 4, is designed to discuss the problem about geometric quantum computation : the study of the effective controlling and manipulating on the two - qubit conditional geometric quantum phase - shift gate and the realization of the two - qubit nonadiabatic conditional geometric quantum phase gate

    第二部分包括第三章和第四章，這部分主要討論幾何量子計算問題：兩量子位條件幾何量子相移門的有效控制和操縱及兩量子位非絕熱條件幾何量子相位門的實現。
分享友人
分享到 Line

分享到臉書