熱裂解 的英文怎麼說

中文拼音 [rèlièjiě]
熱裂解 英文
thermal cracking
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 解 : 解動詞（解送） send under guard
  1. Multicomponent kinetic model of biomass pyrolysis

    生物質的多組分熱裂解動力學模型
  2. Experimental study of lignin flash pyrolysis

    木質素快速熱裂解試驗研究
  3. Electrode materials have effects on properties of electrochemical capacitor, many carbonaceous materials such as active carbon, pyrolytic carbon, active carbon fiber and carbon nanotube were mainly used in electric double - layer capacitor. because of synthetic conditions and cost, we studied their electrochemical properties of electronic double - layer capacitor that pyrolytic carbon was used as their electrode materials

    電極材料是影響電化學電容器性能的主要因素之一，應用於雙電層電容器的電極活性物質主要是各種碳材料，如各種活性炭、熱裂解碳、碳纖維、碳納米管等，考慮到合成工藝和成本因素，我們採用熱裂解碳為雙電層電容器的電極材料，並研究了它們的電化學性能。
  4. The results provided theoretical basis for down - hole catalytic upgrading of heavy oil

    探討了催化劑對稠油水熱裂解反應的催化機理。
  5. Heavy oil viscosity reduction of was studied by using toluene as additive for catalytic aquathermolysis reaction in this paper

    摘要以鉬酸銨作為稠油水熱裂解反應的催化劑。
  6. The results showed that hydrothermal cracking occurred while injecting steam, and the catalyst had catalytic activity for hydrothermal cracking of heavy oil at higher temperature ; viscosity and average molecular weight of heavy oil was thus lowered

    實驗結果表明，在注入蒸汽的條件下，遼河稠油可以發生水熱裂解反應，高溫下催化劑對水熱裂解反應具有催化作用。
  7. A two - dimensional model is proposed for simulation of gas phase cracking of 1, 2 - dichloroethane ( edc ) to produce vinyl chloride monomer ( vcm ) in tubular reactor furnace, in which side reaction of coke precursor formation is taken into consideration

    摘要建立了二氯乙烷在管式反應器中進行氣相熱裂解的二維模型，模型考慮了二氯乙烷熱解生成氯乙烯的主反應和生成焦前體的副反應以及氣體密度變化對裂解反應的影響。
  8. The activation energy and pre - exponential factor for pyrolysis of the residues were estimated from the kinetic models for first order parallel reactions

    研究表明：木質素是木質纖維素類熱裂解產生焦碳的主要來源。
  9. The research results provided the foundation for further study of biomass pyrolysis mechanism in future

    本文建立了基於上述機理性試驗臺的纖維素熱裂解機理模型。
  10. 3. when table sugar was used as starting materials, it was used and pyrolyzed directly or was first mined with sulphuric acid after surface area of those materials is not larger than that of pas capacity is small in their electric double - layer capacitor, specific surface area has great effect on capacity, the larger specific surface area is, the higher capacity is, . but bulk density will decrease with increase of specific surface area

    當以食糖為熱裂解碳的原料時，採用直接焦化和酸洗焦化兩種方式。所制備的樣品比表面積沒有聚並苯材料的大，在以30 h _ 2so _ 4為電解質的雙電層電容器中，容量相對較小。電極活性物質的比表面積對雙電層電容器的容量有很大的影響。
  11. Because the pyrolyzed theory does still not reach the last word and the procedure of pyrolyzing is restricted by a lot of factors, lti has different microcosmic structures and qualities on different conditions

    由於熱裂解的沉積機理尚無定論，熱裂解過程又受多個因素制約，因此，不同的工藝條件所獲得的製品的微觀組織結構和性能截然不同。
  12. Except the asphaltenes, the other 4 part was given to the gc / ms. h ) comparison of gas contents and flow rate before and after the catalytic cracking reaction ; i ) the energy cost of the catalytic cracking ; after the exper

    在此基礎上，結合熱裂解和催化裂解的反應理論解釋了生物質焦油的催化裂解原理，同時分析了催化裂解和熱裂解前後氣體成份和含量的變化。
  13. B ) the concept of ratio of conversion ; c ) effect of temperature and residence time on tar conversion ratio ; increasing the temperature and residence time is beneficial to tar cracking, and the effect is not evidence when t > 900c and > 1. 0s d ) effect of cracking temperature on the tar conversion ratio with sic ; e ) effect of different catalyst on the tar conversion ratio ; some catalyst was test in the experimental system and dolomite is a most promising one

    研究了生物質焦油含量隨熱解溫度和生物質原料的變化趨勢，提出了生物質焦油裂解率的概念、探討了不同條件（熱解溫度、停留時間）下熱裂解的效果和不同催化劑，不同反應條件下對焦油催化裂解效果的影響，催化劑在使用過程中由於積碳、中毒等原因會使得活性喪失，本文針對催化劑活性的喪失以及再生進行丁試驗研究和理論分析。
  14. Rubber and rubber products - determination of the composition of vulcanizates and uncured compounds by thermogravimetry - acrylonitrile - butadiene and halobutyl rubbers

    橡膠和橡膠製品.利用熱裂解法測定硫化和未硫化化合物的成分.丙烯晴丁二烯和丁基鹵化橡膠
  15. Kinetic research of lignin pyrolysis by tga - ftir analysis

    基於熱紅聯用分析的木質素熱裂解動力學研究
  16. Effects of structure on electrochemical properties of pyrolytic carbon anodes

    聚合物熱裂解碳材料結構對電化學性能的影響
  17. The model was integrated the kinetic model of cellulose pyrolysis and transfer model of mass and heat

    模型綜合了纖維素熱裂解動力學模型（本文採用改進的broido - shafizadeh模型）以及傳熱傳質模型。
  18. On the basis of an assessment on the existing technologies of biomass pyrolysis for producing bio - oil, the experimental study on the cellulose pyrolysis behavior was carried out

    本文基於這個目的，對生物質閃速熱裂解制取生物油機理進行系統的試驗和理論研究。
  19. The exploitation and utilization of biomass energy is an effective method for relieving the pressure of conventional energy resources shortage. the technology of biomass pyrolysis can convert low - quality biomass into bio - oil that has the character of high - quality, high energy density, cleanness and zero carbon dioxide emission

    大力開發生物質的熱裂解制油技術，可將低品位的生物質能轉化成高品質的、高能量密度，清潔、無污染而且二氧化碳排放為零的生物油液體燃料。
  20. The porosity changing during the cellulose pyrolysis and convective mass transfer caused by pressure variations was also considered in the model. the reaction product distribution varying with the reactor temperature and reacting time was obtained

    模型考慮了纖維素在熱裂解過程中孔隙率變化，以及內外壓力差引起的對流傳質，並在此基礎上，進行了相應的計算。
分享友人
分享到 Line

分享到臉書