熱退磁 的英文怎麼說

中文拼音 [rètuìcí]
熱退磁 英文
thermal demagnetization
  • 退 : 動詞1 （向後移動） retreat; draw back; move back 2 （使向後移動） cause to move back; remove; wit...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  1. Adiabatic demagnetization is used.

    應用了絕熱退磁作用。
  2. There is a north - north - east negative anomaly belt of aerial magnetism in the middle - east part of the basin, which could be displayed by the aerial magnetism of commutative field, upwardly continuation, lvt in earthquakes, the experimentation of granite liquation ( demagnetization ), the distribution of neozoic era volcanic rock, earthquake, hot spring and ground feature. the anomaly shows the blocking in east - west direction, and it is also associated with intense activity of deep heat interaction and the development of the crust - mantle mixed layer in the north qiangtang

    從區域航磁、向上延拓、地震低速層、花崗巖熔融（退磁）實驗、新生代火山巖的分佈、地震、溫泉、地貌等發現，盆地中東部存在一北北東向航磁負異常帶，既顯示出東西分塊，也與北羌塘深部熱力作用強烈活動、發育「殼幔混合層」有聯系。
  3. The resistivity of the films drops compared with the as - grown films, but the temperature of maximum magnetoresistance reaches 287k, very close to the room temperature. therefore it is not only an important improvement to fabricate the cmr bolometer which can work near room temperature, but also a prospective research for other applications such as magnetic - sensors, spintronics devices and infrared detectors

    同時，退火后薄膜的電阻率明顯下降，外加5t磁場時，最大磁電阻率溫度點上升到287k ，接近於室溫，這不僅為製作室溫超巨磁電阻測輻射熱儀打下了堅實的基礎，也為其它許多器件的應用提供了可能。
  4. The results showed that the microstructure of as - deposited tbdyfe ii 1ms were amorphous and the crystal of tbfe2 were found in films after annealing at 500. annealing films in vaccum could improve the saturation magnetization ms and the susceptibility, decrease the coercivity and the saturaion field, and make the direction of the magnetic moments parallel to the film plane

    結果表明，制備態薄膜為非晶態結構，經過500真空退火熱處理后，薄膜出現了tbfe _ 2的結晶物，薄膜的矯頑力和外場的飽和磁場大大降低，飽和磁化強度增強，初始磁化率提高，易磁化軸轉向膜面。
  5. X - ray diffraction results revealed that the structure of as - deposited smco film was amorphous and crystallization happened after the films annealed at 500 in vacuum. the magnetic tests of smco thin films showed that its coercivity reduced with the increase of film ' s thickness while the ratio of mr / ms was opposite. the films " coercivity and mr / ms declined after it annealed at 500 because the machanism of magnetization were changed from domain wall nailing into magnetic nuclear forming

    研究結果表明，由於雜質fe的摻入降低了smco薄膜的磁性能；制備態smco薄膜為非晶態結構，矯頑力hc隨著薄膜厚度的增加而減小，剩磁比mr ms隨膜厚增加而增加；經過500真空退火熱處理后，薄膜出現smcos的結晶物，矯頑力hc降低， mr ms減小，磁化機制由疇壁釘扎類模型轉為形核類模型。
  6. In this paper, the effect of heat treatment on the magnetic properties of s s fibers was studied

    對不銹鋼纖維進行退火處理，以探索材料成分、熱處理工藝與相結構和纖維磁性能的關系。
  7. For example, the furnaces can be used for quenching of high - speed steel, mould steel, alloy structure steel, bearing steel, elastic alloy etc, sintering and annealing of magnetic materials, and so on

    其它熱處理工藝根據用戶要求實例：高速鋼模具鋼合金結構鋼軸承鋼彈性合金等材料的淬火，以及磁性材料的燒結退火等。
  8. In the making process we use hot - forging warm - forging cold extrusion forming and magnetic annealing processes to completely solve the problem of complex form hign precision dimensions difficult manufacturing lower power and so on. what s more, part surface is very smooth with no trimmed margin, continuous flowing metal fiber, high strength, lower noise. forged claw poles obviously increase generator s power and life, and also improve finished product rate of roughness

    在製造過程中採用了熱鍛溫鍛冷擠壓成型及磁性退火等先進生產工藝徹底解決了精鍛「爪極」形狀復雜尺寸精度高製造難度大功率低等問題，且產品表面光潔無飛邊金屬流動纖維連續毛坯強度大噪音低，明顯提高了發電機的功率和壽命，並且提高了毛坯成品率。
  9. In this paper, we implanted mn + ion of different dose into undoped semi - insulating ( 100 ) gaas substrate then performed rapid thermal annealing in different temperature and time. studied the different annealing condition dependence of the samples " structure, electrical and magnetic properties and the relation of the mn + forms and these properties

    本課題採用離子注入的方法將不同劑量的mn ~ +注入到非摻雜半絕緣（ 100 ） gaas單晶襯底中，然後進行不同溫度和時間的快速熱退火處理，研究了不同的退火條件對樣品注入層的晶體結構、電特性和磁特性的影響以及mn ~ +在樣品中的存在狀態與這些性質之間的關系。
  10. It has been found that a preferable orientation can be obtained while both the smco5 phase and the sm2co17 phase have deposited plenty in the two - steps heat treatment

    而合適的兩級退火熱處理能使smco5和sm2co17永磁相充分析出，並形成一定的擇優取向，從而可以顯著提高薄膜的矯頑力。
  11. Analyses showed that the effect of heat treatment is remarkable to 304 stainless steel fibers. and a new martensitic phases formed, and ms increased during annealing at 180c ; annealing above 180c decreased the ms. after annealed in the range of 380c ~ 440 c, the he increased and the product ( mr hc ) improved. it was also shown that annealing affected the mechanical properties of 316l ss fibers obviously

    304不銹鋼纖維在180附近退火處理其ms略增加，其內部相變與一般的304不銹鋼體材料存在差別； 380 440區間退火處理，其矯頑力急劇增加、磁能積參數配合比較好；退火熱處理對316l不銹鋼纖維的力學性能作用明顯。
  12. Based on the multi - shelves thermal demagnetization, magnetic test, directional analysis, the paper has drawn the paleo - latitude map and contrasted it with international standard polarity pole on the basis of the volcano rock age

    經過巖心的多檔熱退磁及磁性測試和定向分析，繪制出古極緯度圖，在參考火山巖同位素年齡的基礎上，將古極緯度柱與國際標準極性年表進行對比。
  13. The better magnetostriction of tbdyfe thin films was 120x 10 - 6 in 100ka / m and 240 x 10 - 6 in 330ka / m the research on the magnetostriction of smco / tbdyfe bilayer films indicated that smco thin films could improve the magnetostricion of tbdyfe thin films effectively through improving its saturation magnetization ms and susceptibility

    退火熱處理和襯底粗糙度的降低有助於薄膜磁致伸縮性能的提高。對smco tbdyfe復合薄膜磁致伸縮特性的研究表明， smco薄膜的復合能提高磁致伸縮薄膜的磁化率和飽和磁化強度從而提高tbdyfe薄膜磁致伸縮性能。
  14. The results of gmr testing indicate that the gmr effect is much little in the assputtered films, but they will be enhanced after vaccum annealling in magnetic fileld. and we also found that the thickness of the films and the

    磁阻性能測試結果表明，沉積態薄膜的磁阻性能微弱甚至沒有，經過真空磁場熱處理后的薄膜磁阻性能明顯得到提高，並且薄膜厚度與退火溫度均對薄膜的巨磁阻性能有重要影響。
分享友人
分享到 Line

分享到臉書