片狀增強 的英文怎麼說

中文拼音 [piānzhuàngzēngqiáng]
片狀增強 英文
patchy enhancement
  • : 片構詞成分。
  • : Ⅰ名詞1 (形狀) form; shape 2 (情況) state; condition; situation; circumstances 3 (陳述事件或...
  • : 強形容詞(強硬不屈;固執) stubborn; unyielding
  • 片狀 : schistose片狀避雷器 plate protector; 片狀電容器 chip capacitor; 片狀結構 laminated structure; 片...
  1. A study on flake reinforced friction brake materials

    片狀增強制動摩擦材料的研究
  2. The main work and conclusion for this paper is as following : according to the flashover test results of several kinds of iced insulators under positive voltage and negative voltage, this paper obtained : for the single porcelain insulator, the single glass insulator and the composite insulator bridged completely by icicle, the metal cathode ' s strong ability of emission electron is the primary reason that results in the lower negative flashover voltage ; the position difference of the high resistance district in method anode side results in that porcelain insulator cluster and glass insulator cluster have an evident effect of polarity ; when less ice and no icicle at the brim of the sheds, due to numerous non - polar arcs on the composite surface, the effects of polarity of composite insulator was lost using the test method of the average flashover voltage in the freezing period, dc flashover performances were investigated of several insulators with some typical structures and different material

    本文的主要工作和結論如下:在人工氣候室內,根據不同覆冰絕緣子正、負極性下的閃絡試驗結果,得出負極性電弧金屬陰極的電子發射能力造成了單瓷、玻璃絕緣子及被冰凌橋接的合成絕緣子有較低負極性冰閃電壓;正極性電弧金屬陽極側產生高電阻區所處位置的差異使得瓷和玻璃絕緣子串具有明顯的極性效應;覆冰較少時,合成絕緣子表面出現數量較多的非極性電弧使合成絕緣子無極性效應。利用覆冰期內平均閃絡電壓的試驗方法,對不同材質和結構的絕緣子在覆冰、低氣壓和污穢共存環境中的直流閃絡特性進行了研究。試驗結果表明,直流平均閃絡電壓隨著海拔的升高、覆冰量的加以及污穢度的加而降低,且其特徵指數與絕緣子結構、覆冰量、覆冰態、污穢度等有關。
  3. In order to obtain well effect on the improve the strength and toughness, the interface on the grain and the resin matrix should have a good glue performance ; the diameter of the grain should be small and the shape component of grain patch and fiber should be suitability

    要獲得好的韌效果,填料顆粒與樹脂基體界面上應有好的粘結性能;顆粒粒徑應小且填料粉體中粒和纖維的組分應適當。
  4. The research results show that aggregate gradation and the nominal maximum aggregate size evidently influence the shear resistance of asphalt mixture ; aggregate flakiness content influences the shear resistance of asphalt mixture, and with the increase of aggregate flakiness content the shear resistance of asphalt mixture decreases ; asphalt binder properties, especially penetration, softening point and viscosity influence the shear resistance of asphalt mixture, and the latter increases with the decrease of penetration and the increase of softening point and viscosity ; asphalt content influences shear resistance of asphalt mixture, and with the increase of binder / aggregate ratio the shear resistance of asphalt mixture decreases ; air void influences shear resistance of asphalt mixture, and usually with the increase of air void the shear resistance of asphalt mixture decreases ; homogeneity does not have a direct and obvious relationship with absolute value of shear resistance of asphalt mixture, but does with variation of shear resistance of asphalt mixture

    研究結果表明:集料級配和公稱最大集料粒徑對瀝青混合料抗剪度有顯著的影響;瀝青混合料抗剪度受其集料中針含量的影響較大,集料中針含量大,瀝青混合料抗剪度減小;結合料的性質,特別是針入度、軟化點和粘度對瀝青混合料抗剪度有較大的影響,隨著針入度減小,軟化點和粘度大,瀝青混合料抗剪大;含油量對瀝青混合料抗剪度有較大影響,隨著油石比的大,瀝青混合料抗剪度減小;瀝青混合料抗剪度受其空隙率的影響較大,一般隨著空隙率的大,其抗剪度減小;瀝青混合料均勻性與瀝青混合料抗剪度絕對數值間沒有明顯的關聯,而與數值間的變異性有著很好的相關性。
  5. Smc. textile - glass - reinforced plastics - sheet moulding compound - basis for specification

    玻璃纖維塑料.模塑料
  6. As an important process of fibre - reinforced composites, sheet molding compound ( smc ) technology draws worldwide attention recently

    模塑料(簡稱smc )模壓成型工藝是近年來在國內外受到普遍重視的短纖維復合材料成型工藝。
  7. As the deformation caused by centrifugal force is beyond the small deformation range, the large deformation effect was also taken into account in the equation. two models are constructed, one is of shrouded blade and the other is of bladed disc. the static natural frequencies and dynamic frequencies ( under 3000rpm ) are calculated by the finite element method and cyclic symmetry technique

    針對葉的結構特點,採用適應較的三維八節點實體單元模擬葉,建立葉運動微分方程;葉?輪盤系統在高速旋轉時,受到離心力作用,使葉發生大變形,故在方程中考慮了幾何大變形的問題;為研究葉根輪緣之間的接觸態,建立了考慮葉根?輪緣接觸的有限元方程,利用拉格朗日廣演算法來求解該方程,確定葉根輪緣之間的接觸面態。
  8. The best content of nanometer caco3 is 10 part by weight ( pbw ) ; light caco3 have no ditinct toughening and reinforcing effect in nanocrystal pvc / pvc / light caco3 composite. nanocrystal pvc promotes the form of claster crystal that induce t he improvement of property of pvc by sem test

    輕質caco _ 3沒有明顯的作用,僅起到降低成本的作用; sem照顯示納米晶pvc促進了基體中細小串珠晶區的形成,表明納米晶pvc具有成核作用,可以提高體系的力學性能。
分享友人