相對衰減系數 的英文怎麼說

中文拼音 [xiāngduìshuāijiǎnxìshǔ]
相對衰減系數 英文
relative damping coefficient
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 對 : Ⅰ動詞1 （回答） answer; reply 2 （對待; 對付） treat; cope with; counter 3 （朝; 向; 面對） be tr...
  • 衰 : 衰動詞（衰弱） decline; wane
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 相對 : 1. （面對面） opposite; face to face 2. （非絕對的） relative 3. （比較的） relatively; comparatively
  • 衰減 : attenuation; decay; damping; reduction; rejection; weakening; deamplification; dampening; dying o...
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  2. A dynamical system is built which is satisfied to lyapunov function whose energy function is penalty function in augmented lagrange multiplier method. the dynamical system is global stable, and its stable solution is the optimization solution of sub - problem in augmented lagrange multiplier method according to lasalle invariance principle. finally a complete optimization algorithm is developed

    針對這種工業過程，本文基於一個lqr的性能指標（本性能指標和衰減系數和自然頻率密切相關） ，提出應用本文提出的mmlaax優化演算法，對不確定工業過程進行魯棒pto控制器的設計，取得令人滿意的效果。
  3. Its main contributions include the following several aspects : firstly, the dissertation constructs the mathematic model of short baseline orientation determination using two geostationary satellites and analyses the applicable conditions of carrier phase interferometry. orientation determination precision is analysed in depth through both the conventional linearized method and monte - carlo computer simulation method, and the mathematical simulation results show that the linearized method has the shortcoming of fairly low elevation error analysis precision in high latitude area so as not to be very appropriate there. by analyzing the definite factors influencing orientation precision, the dissertation develops the concept of orientation dilution of precision, which uncovers the internal cause of exotic error behavior of bi - satellite orientation, and has important guiding significance for practical engineering applications

    本文系統地研究了基於「北斗一號」衛星載波相位干涉測量原理實現地球靜止雙星定向的相關技術，主要研究成果包括以下幾方面:首先，建立了利用兩顆地球靜止軌道衛星進行短基線定向的數學模型，分析了載波相位干涉測量的適用條件;採用傳統的線性化解析法及蒙特卡洛隨機模擬法兩種途徑對雙星定向的精度進行了詳細分析，數學模擬結果表明在高緯度地區線性化解析法由於俯仰角誤差分析精度略有下降而不太適合;在分析定向精度確定性影響因素的基礎上，提出了雙星定向精度衰減因子odop的概念，揭示了雙星定向誤差特殊表現的內部機理，對實際工程應用具有重要的指導意義。
  4. The experimental study is performed on the c - band tapered milo designed with the help of the simulation. the whole system is calibrated separately by parts. from milo to microwave receiving hom, the special system is simplified to be a two - port network and its s parameter is measured to calculate the attenuation factor a

    對于微波功率的標定問題，我們根掘實驗條件，將整個系統劃分為幾個部分分別進行了標定，包括：從milo到接收喇叭組成的特定系統，將該特定系統簡化為一雙口網路，並測量出了其s參數，從而計算出與頻率密切相關的衰減量a ；對固定衰減器在不同微波頻率下的衰減量進行了標定。
  5. The study shows that using a obtained from cylindrical surface of column can characterize the alloy steel samples, which have complicated phase structure

    研究表明，通過比較圓柱面法測得的相對衰減系數，能夠對具有多種相結構的較大尺寸合金鋼試樣進行超聲表徵。
  6. The difference among the elasticity modulus of various microstructures is probably the main reason, which caused the experiment results above. under the same experiment conditions, such as sample shape, size, surface roughness, establishment of testing system, pressure on the probe, and thickness of coupling medium, the variety of relative attenuation coefficient ( or ) in different heat treatment samples is measured and compared by measuring the attenuation obtained from the cylindrical surface of column. the result is as following : for 40cr and 38crmoal, a mt < az mq < a s < a p + f ; for gcrlssimn, a mt < a annea < s < a p + f ; and a increased with the increasing of frequency

    在保證試樣形狀、尺寸、表面光潔度、系統參數設置、施加在探頭上的壓力以及耦合層厚度等測試條件一致的情況下，利用棒材圓柱面測衰減系數法，分別測定並比較上述不同熱處理試樣相對衰減系數的變化情況，得到的實驗結果是：對於40cr及38crmoal鋼， _ （低溫回火） （淬火） _ （高溫回火） _ （正火） ；對于gcr15simn鋼， _ （低溫回火） _ （退火） _ （高溫回火） _ （正火） ；且隨著頻率的提高，衰減系數均呈現增加的趨勢。
  7. According to structural characteristics of multi - phased alloy steels and the properties of ultrasonic propagation, microstructures characterization with different heat treatment processes ( normalizing, quenching / annealing, quenching plus low tempering, quenching plus high tempering ) for three steels ( 40cr, 38crmoal, gcrlssimn ) was studied experimentally by using ultrasonic methods. ultrasonic velocity, relative attenuation coefficient, and power spectral analyses were researched on the same samples respectively, on the basis of theory and experiment, the sensitivity and other characterizations of the three methods used to distinguish different microstructures were compared

    根據具有多種相結構合金鋼不同熱處理轉變產物的組織特點，以及超聲波在其中的傳播規律，利用超聲波速度、相對衰減系數以及功率譜分析三種方法，對三種鋼（ 40cr 、 38crmoal及gcr15simn ）不同熱處理（正火、淬火退火、淬火+低溫回火及淬火+高溫回火）轉變產物的顯微組織進行了超聲表徵研究。
  8. This paper relates to some problems about the determination of design ground motion parameters, which include the choice of the attenuation relationship of rock horizontal acceleration response spectrum, the impact of focal depth to rock peak horizontal acceleration and rock response spectrum curves, the choice of intensity envelops function and random input phase, the choice of soil nonlinearity and shear wave velocity, scale of design ground motion response spectrum etc. in the researches of relative aspect, based on a typical section plane of the engineering site, influence of the change of some parameters on design ground motion parameters and the existing errors and corresponding rules are studied by using the method of one dimension model of equivalent linearization

    摘要研究了確定設計地震動參數中涉及的若干問題，其中包括基巖水平加速度反應譜衰減關系的選擇、震源深度對基巖水平加速度峰值及基巖反應譜曲線的影響、強度包絡線函數及輸入隨機相位的選擇、土體非線性特性參數和土層剪切波速值的選擇、設計地震動反應譜的標定等問題。
  9. Ct method uses array linear detectors to perform high - resolution tomography and yield relative image of linear attenuation coefficient

    測出的線衰減系數是相對的，成像要求高分辨。 tgs裝置用的是同軸大體積hpge探測器。
  10. The three methods are independent, supplement mutually and proved each other because the sensibility of every method is different when used to distinguish different microstructures

    超聲波速度、相對衰減系數及功率譜分析三種方法，各自獨立；同時，三種方法區分不同組織的靈敏度不同，實驗結果能夠互為補充。
分享友人
分享到 Line

分享到臉書