相角差 的英文怎麼說

中文拼音 [xiāngjiǎochā]
相角差 英文
angular phase difference
  • : 相Ⅰ名詞1 (相貌; 外貌) looks; appearance 2 (坐、立等的姿態) bearing; posture 3 [物理學] (相位...
  • : 角Ⅰ名詞1 (牛、羊、 鹿等頭上長出的堅硬的東西) horn 2 (古時軍中吹的樂器) bugle; horn 3 (形狀像...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  1. The relative phase shift between s - and p - light is a function of the incident angle, and changes highly with the incident angle in the vicinity of the critical angle

    S光與p光的是入射的函數,當入射在臨界附近變化時,會隨著入射高靈敏度變化。
  2. Maximum phase angle deviation

    最大
  3. The short - baseline interferometer ’ s angle measurement accuracy is influenced by phase difference measuring accuracy, the base length measuring accuracy, the system operating wavelength ( frequency ) and so on, the article analyzes the existing theory, and emphatically analyzes the influence of base length measuring accuracy to the precision of angle measurement

    短基線干涉儀測精度受測量精度、基線長度測量精度、系統工作波長(頻率)測量精度等因素的影響,文中,在對原有理論進行分析的基礎上著重分析了基線長度測量精度對系統度測量精度的影響。
  4. Analysis indicates the " low pressure closed reticular flow region " results in the non - equilibrium of pressure along the primary jet ' s orifice. to obtain as large vectoring angle as possible, the optimal ranges of angles, frequencies, velocity amplitudes, and distances from the microjet actuator to the primary jet exit were discussed. the relationship between the vectoring angle of the primary jet and the phase - difference of two adjacent actuators was analyzed

    分析了「拉」模型單作動器模式下,微射流作動器的入射度、驅動頻率、速度幅值及與主射流間的距離對主射流偏轉程度的影響,並確定了作動器工作參數的最佳范圍;分析了「拉」模型雙作動器模式下,不同的對主流偏轉程度的影響。
  5. The coordination control between the angle error and the ratio error was realized through analyzing the common characteristics between the similar magnetizing current compensation and the anti - turn compensation

    通過分析似電流補償和反匝數補償的特點,對電流互感器的比進行了協調控制,補償效果明顯。
  6. However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences

    干涉儀測向不必進行測向信號預處理而是直接或間接求取在空間上分開的傳感器上感應電勢之間的位關系,即干涉,方位或仰是直接由干涉計算得到,或將兩基線正交的天線陣的干涉轉化為驅動電壓(電流)分別加到crt陰極顯示器的垂直偏轉線圈和水平偏轉線圈,模擬顯示出來波方位,干涉儀測向為典型的位測向方法。
  7. Based on the comprehensive analysis of the application status and the existed problems of transmission line fault location, this dissertation presented a new algorithm for fault location based on two - terminal asynchronous data, which can make correction for the integrate error of line parameter, length of transmission line, sampling value and so on. at the same time, it can work out the two - terminal asynchronous phase angle with the corrected parameters

    本論文在充分分析了國內外故障測距的理論與技術以及存在的問題后,針對輸電線路故障定位因線路參數變化對定位準確度的影響,提出了能夠對線路的參數、長度和采樣值等誤等進行綜合誤修正( cie )的新演算法,並利用修正後的參數來求解兩端的不同步相角差
  8. Two angle - related shafts are joined with one set of universal joints, the two shafts will developed a phase difference, however, if taking advantage of two universal joins and the deviation angle will become the same, enabling synchronism

    可以連接兩個有度關系的轉軸,但在使用單組萬向接頭的情況下兩軸會有,若使用兩組萬向接頭加之以兩組的軸偏同即可使兩轉軸的位同步。
  9. It proves that the capability of wind generator is determined to slip, rotor voltage and angle between rotor voltage and stator voltage, and investigates the control model based on the stator field - oriented vector control

    文中還分析了雙饋型風力發電機的轉矩特性和穩態特性,證明了發電機的性能由轉率、轉子電壓和定轉子電壓間的決定的。
  10. In this topic, the error characteristic of resistance voltage sensor was analyzed in theory, by using electric circuit analysis, the reasons which affected its error were gotten. based on theory analyses, initial structure was designed. then by using fem ( finite element method ) of simple resonance field, several structures electromagnetic field was calculated, and their amplitude errors, phase errors, maximum of electric field intensity and frequency characteristic of amplitude error were contrasted

    本文從理論上分析了電阻式電壓傳感器的誤,用電路分析法定性的研究了影響電阻分壓器誤的因素;在理論分析的基礎上進行了電阻分壓器結構的初步設計;基於該設計,利用簡諧場的有限元方法進行了場的計算,比較了幾種結構方案的幅值誤、最大場強值及其幅值誤的頻率特性,從而得到一種最優方案;製作了分壓器樣機,並在本實驗室進行了實驗;最後,對電子電路部分進行了初步設計,並提出了抗干擾的措施。
  11. The principal axis torsion angle, produced by torque, is converted to two channel square waves with phase difference through grating sensor. then the degree of torsion angle is measured by data collection card. finally the value of torque and the other parameters of the axis can be calculated by upper pc

    將主軸受扭矩作用而產生的扭轉,通過光柵傳感器轉換為兩路有的方波信號,再通過數據採集系統檢測出扭轉的度數,最後由上位pc機計算出扭矩的大小和主軸的各種參量。
  12. The reason that the noise is lower with inclining tongue is : 1 ) both the radius of the tongue and the gap between the tongue and the blade are changed across the wideth ; 2 ) the phase angle between blade and the tongue is changed across the wideth, therefore the peak value of the noise do not appear at the same time, so the peak value of the noise with inclining tongue is much lower than the straight one. the influence of the expanded angle of the shell of the fan on the noise was invested experimentally, and the optimal angle was got

    傾斜蝸舌降噪的主要原因是:一是改變了從氣流入口側到風機輪盤的蝸舌間隙和蝸舌半徑;二是改變了葉輪與蝸舌非定常互作用的,使其產生噪聲也有,迭加的結果進一步降低了噪聲。另外,試驗研究了不同蝸殼擴張對風機噪聲及效率的影響規律,蝸殼擴張選擇當否,對效率和噪聲影響較大。
  13. This paper mainly studies the coupling error caused by induction voltage phase difference, and fluctuation of directional sensitivity caused by changes in near - field difference slope. the trend of system sum and difference phase difference, directional sensitivity and cross - coupling with change in distance is compared and discussed when the antenna is in the near - field and at a certain elevation

    本文著重研究了因近場感應電壓引起的耦合誤,以及近場天線斜率變化引起的定向靈敏度的變化;討論了天線在近場並有一定仰的條件下,隨著距離的變化,系統和、、定向靈敏度與交叉耦合的變化趨勢。
  14. The principle of angle measurement of short - baseline interferometer is that using phase difference between returning signals to obtain the angle of the target. the method has high precision, but has the phase ambiguity problem inevitably, the article give the explanation to the short - baseline interferometer about these two questions

    短基線干涉儀測的基本原理是位法測,即利用系統中不同接收站之間的來獲得目標的方位信息,具有測精度高的優點,但卻不可避免的存在著測模糊的問題,文中對短基線干涉儀這兩個基本問題進行了說明。
  15. Signal forming and different demodulation of gmsk baseband signal are mainly discussed in the dissertation. gauss filter, phase integral, sin table, matched filter, calculate angle, bit - synchronization 、 output filter 、 a / d 、 d / a and etc of gmsk baseband signal are carefully studied through software emulation in systemview environment. the modulation and demodulation of gmsk baseband signal are carried out by the way of using tms320vc549 of ti to integrate software and hardware

    本文重點討論了gmsk基帶信號的形成以及gmsk基帶信號的分解調,系統在systemview的環境下進行了軟體模擬,通過對系統的模擬工作,仔細的研究了gmsk基帶信號的高斯預濾波器、位積分、 sin查表、匹配濾波器、計算、位同步、幀同步、輸出濾波、 a / d和d / a等。
  16. The new system uses short base - line to avoid the long base - line phase illegibility to get the signal arrive angle with higher precision, then use the phase differences without illegibility and the arriving angle to detected the emitter ' s range

    該系統首先通過短基線測,去除長基線接收機位模糊,進而獲得更高精度的波達度;然後通過無模糊的側量值和波達度估計值確定信號源與觀測站之間的距離。
  17. The claim has been made upon the results that the wmt method should be used in the area near the vertical, while the phase difference method in slant beams and a rule has been given to select among those two methods according to the " effect value " on condition the depth is known for the consideration of improving the measurement precision, this paper studies the factors which affect the toa measurements, and three expressions of precision has been introduced as to applications of phase difference method, this paper introduces an automatic hunting method based on amplitude power to get the range of echo arrival

    採用方分析的方法,使用重復海試數據對wmt法和法的優劣進行了分析,指出了垂直附近應該使用wmt法,而傾斜波束應該使用法;給出了在深度真實值已知前提下wmt法和法使用的判決準則,即根據效應值的大小來選擇。本文從提高測量精度度出發,分析並驗證了影響toa測量精度的因素;給出了三種精度表示。在應用法時,引入了一種基於幅度能量的區間自動搜索方法;實驗表明該方法能很好地確定回波到達的大概時間范圍。
  18. Small - angle measurement based on total internal reflection effect is a high - precision method. the s - and p - polarized components in reflection beam has different phase shift when total reflection occurs, which could be used to measure the incident angle

    光學內反射法測量光束微小偏轉是一種高精度的測方法,它主要是利用光束在發生全反射時反射光中的s光和p光產生的不同這一特點進行測的。
  19. A phase difference of 90°may therefore be obtained by means of two successive total reflections at either of these angles.

    所以,如果在其中某一度接連全反射兩次,則可獲得90的
  20. The impact on the system of direction finding for the existence of baselines ' obliquity is approved in actual system

    給出了和基線傾的對應關系,並在實際系統中證實了基線傾的存在產生的位誤對整個測向系統的影響。
分享友人