破裂強度 的英文怎麼說
中文拼音 [pòlièqiángdù]
破裂強度
英文
bursting strength-
Test method for bursting strength of pressure - sensitive tapes
壓合膠帶抗破裂強度的試驗方法Methods for determining the bursting strength of paper and board
紙紙板破裂強度的測定方法Bursting strength test
破裂強度試驗Mullen bursting strength tester
密廉式破裂強度試驗機Bursting strength tester
破裂強度試驗機Standard test method for hydraulic bursting strength of textile fabrics - diaphragm bursting strength tester method
織物液壓破裂強度的標準測試方法.薄膜破裂強度試驗器法When heating temperature reached 300, crackings appeared on the surface of ceramic tiles but the microstructure of glaze exhibited no apparent change when heating temperature reached 900, the glaze melted, the crystal structure of the tiles broke down, the integrity of ceramic tile was destroyed and the intensity was almost lost
當溫度達到300 ，冷卻試驗時，釉面可產生裂紋，但顯微結構基本無變化；當溫度達到900 ，冷卻試驗時，釉面出現熔化現象，坯體晶體結構酥裂、破碎，完整性遭到破壞，強度基本喪失。Barrier cracks cannot stop the extending of a fracture, and the strength of the sample is reduced by almost one magnitude because of the existing barrier cracks. there are great differences of ae distribution between specimens with non - penetrate crack and specimens with penetrate crack. as for penetrate crack, ae occurs near the two end of the crack, and for non - penetrate crack, crack, ae occurs near the two end of the crack, and for non - penetrate crack, ae occurs near the front edge of crack, which can be explained well by the theory of 3 - d fracture ; ae distribution near the outer part of collinear crack is similar with that of the end of penetrate crack, and inner part of collinear cracks will run - through with high loads
關于預制裂紋系對巖石破裂的影響，集中討論了：空障礙體構造不能阻止主裂紋的擴展，反而會使巖石的破裂強度降低近一個量級；由於構造的不同，非穿透切口樣品和穿透切口樣品的聲發射空間分佈特點有本質區別，穿透切口樣品的微破裂在切口兩端發育，而非穿透切口樣品的微破裂在切口兩端之間切口前緣處發育，這用三維破裂理論可以很好地解釋；含共線構造的巖石，裂紋外端的聲發射分佈與單裂紋構造中裂紋端部的聲發射分佈相似，裂紋內端聲發射有密集分佈，在應力達到一定水平時，內端部發生錯斷，而不是貫通。Hydraulic fluid power. filter elements. methods for checking collapsing or bursting resistance
液壓流體動力.過濾元件.抗破壞或抗爆裂強度檢驗方法Ceramic tiles - part 4 : determination of modulus of rupture and breaking strengh iso 10545 - 4 : 1995 ; german version en iso 10545 - 4 : 1997
瓷磚.第4部分:斷裂模數和破壞強度的測定But calcium phosphate ceramic with high porosity is such brittle and low toughness that it ca n ' t fit to bone tissue engineering. in order to provide appropriate scaffolds for bone tissue engineering, calcium phosphate was combined with plla to prepare porous material
但磷酸鈣多孔陶瓷材料脆性大，在生理環境中的疲勞與破壞強度不高，尤其在濕環境下斷裂韌性很低，不能制得滿足組織工程要求的高孔隙率，力學性能較高的支架材料。Creep rupture strength
蠕變破裂強度Test methods for percentage of breaking and bursting strength lowering of textiles to oxygen - bleaching
織物經氧漂白劑處理其抗破裂及脆裂強度降低的百分比試驗方法Rubber - or plastics - coated fabrics - determination of bursting strength - steel ball method
橡膠或塑料塗覆織物.破裂強度測定.鋼球法Sintered metal bushes. determination of radial crushing strength
燒結金屬襯套.徑向破裂強度的測定Test method for bursting strength of textiles - constant - rate - of - traverse ball burst test
針織品破裂強度測試方法.恆速橫向移動球式破裂試驗Methods of test for dense shaped refractory products. part 5 : determination of cold crushing strength
緻密異型耐火產品的試驗方法.第5部分:冷破裂強度的測定Rubber - or plastic - coated fabrics - determination of bursting strength - part 2 : hydraulic method ; german version en 12332 - 2 : 2002
橡膠或塑料塗層織物.破裂強度測定.第2部分:液壓法Test method for bursting strength of paper
紙破裂強度的測試方法Test method for bursting strength of pressure - sensitive tapes metric
壓合膠帶抗破裂強度的試驗方法分享友人