硅酸度 的英文怎麼說

中文拼音 [guīsuāndù]
硅酸度 英文
degree of silication
  • 硅 : 名詞[化學] silicon （14號元素符號 si）
  • 酸 : 酸構詞成分。
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 酸度 : [化學] acidity酸度計 acidimeter; acidometer; 酸度檢定 acidity test; 酸度控制 acidity control; 酸...
  1. It is inferred that the dissolution rate and dissolubility of gypsum are the main decisive factors of cement performance of portland - sulphoalminate composite system

    推導證實，石膏的溶解速度和溶解度是決定硅酸鹽硫鋁酸鹽復合體系水泥性能的主要因素。
  2. The effects of equilibrium time, acidity of the solution, temperature, concentration of redox reagents on the adsorption of neptunium by silica gel were carried out. desorption and isotherm adsorption experiments were also performed. the results are shown as follows : the equilibrium for adsorption of neptunium on silica gel reached rapidly

    進行了吸附平衡時間、酸度、溫度、氧化還原劑濃度等條件對硝酸溶液中np （ ） 、 np （ ）和np （ ）在硅膠上吸附的影響的實驗，與吸附時同酸度條件下的洗脫實驗，用濃度為3mol l的硝酸作為解吸劑的解吸實驗。
  3. Test method for whiteness of white portland cement

    白色硅酸鹽水泥白度試驗方法
  4. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討，選用鎳鉻合金電阻絲作為加熱元件，配以陶瓷質埋入式爐膛；選用陶瓷質小尺寸扁平?圓盤均熱塊體型樣品支持器；選用0 . 5mm絲徑鎳鉻?鎳硅熱電偶（ k ）作為測溫元件；熱電偶對稱安置在樣品支持器容器的中部；選用硅酸鋁耐火纖維作保溫材料；合理選用和設計了溫度控制器、溫度變送器、信號放大電路等硬體；採用升溫曲線來控制爐膛供熱過程；採用最小二乘法非線性回歸與分段函數相結合的曲線模擬方法，進行圖形處理。
  5. The light - storing fiber was produced from fluorescent masterbatch which was composed by basic silicate or alumina with thulium

    摘要蓄光纖維是通過用堿土類硅酸鹽熒光粉體或氧化鋁加稀土元素組成的發光粉體，製成一定濃度母粒切片，用母粒來紡絲。
  6. Standard test method for fineness of portland cement by the turbidimeter

    用濁度計測定硅酸鹽水泥細度的標準試驗方法
  7. Industrial production pianguisuan that business sales, chemical products ( excluding hazardous chemicals ), wholesale and retail. the documents involving licensing business

    工業偏硅酸納的經營生產銷售，化工產品（不含化學危險品）的批發零售。凡涉及許可證制度的憑證經營。
  8. The influence of different gypsum on strengh of portland - sulphoalminate composite cement system is complicated, related with aluminiferouse mineral in cement system and the so4 ( superscript 2 - ) concentration of its hydrated solution ; in distilled water and maximum lime wash, the dissolution rate of dihydrate gypsum is higher than that of anhydrite but the dissolubility is lower

    石膏品種對硅酸鹽硫鋁酸鹽復合體系水泥強度的影響較復雜，與水泥體系中含鋁礦物及其水化溶液中so4 （上標2 - ）離子濃度有關；在蒸餾水和飽和石灰水中，二水石膏的溶解速度比硬石膏快，溶解度比硬石膏低。
  9. The result of transmission electron microscope ( tem ) showed that layers of layered silicates were exfoliated and dispersed in matrix homogeneously. according to statistical data, average thickness of layers was lonm, and the thickness of the biggest layers was less than 40nm, only a few layers were exfoliated in monolayer whose thickness was about inm

    透射電子顯微鏡（ tem ）照片顯示：層狀硅酸鹽片層發生剝離，片層均勻分散在nbr基體中，統計表明片層的平均厚度約為10nm ，最大的聚集體的片層厚度達到40nm ，推斷有一小部分片層剝離成單晶層的形式，厚度為1nm 。
  10. The main conclusions are as follows : the hco3 - ion content of zhujiang river changes notably in one hydrological year, especially in wet season and dry season. as for the content of inorganic carbon, that of the xijiang river is the highest, then the beijiang river, and then the dongjiang river. the xijiang river ' s inorganic carbon source was major from karst process in the drainage basin

    得出如下的結論：珠江水體hco _ 3 ~ -離子含量在一個水文年中發生顯著變化，特別是豐水期與枯水期之間波動幅度較大；無機碳含量西江含量最高，其次是北江，東江最低；西江無機碳主要來源於巖溶作用，由於受河流沖刷效應影響，豐水期hco _ 3 ~ -離子含量升高；東江流域無機碳主要來源於硅酸鹽巖的碳酸鹽風化過程，豐水期hco _ 3 ~ -離子含量無顯著變化；北江無機碳來源於巖溶作用和硅酸鹽巖的碳酸鹽風化過程，受稀釋效應影響，無機碳含量隨水量增加而降低。
  11. Thick layers of silicate glasses can be formed by repetitively using this technique. waveguide structures can be fabricated by sintering the sample at certain temperature

    通過多次使用這種方法可以形成厚的硅酸鹽玻璃膜層，最後樣品在一定溫度下燒結得到波導結構。
  12. Test method for whiteness of white

    白色硅酸鹽水泥白度試驗方法
  13. From a chemical - mineralogical point of view, emeralds are beryllium - aluminium - silicates with a good hardness of 7. 5 to 8, and belong, like the light blue

    從化學礦物學角度來看，祖母綠是鈹鋁的硅酸鹽礦物，有良好的硬度，在摩氏硬度表中為
  14. Test methods of crystalline layered sodium disilicate - measurement of whiteness

    層狀結晶二硅酸鈉試驗方法白度的測定
  15. Sodium and potassium silicates for industrial use. determination of dynamic viscosity

    工業用硅酸鈉硅酸鉀.動粘度測定
  16. Potassium silicate solution for use in electronic industry - the methods of determination for density

    電子工業用硅酸鉀溶液密度的測定方法
  17. Potassium silicate solution for use in electronic industry - the methods of determination for viscosity

    電子工業用硅酸鉀溶液粘度的測定方法
  18. The alkali & alkaline metal oxide will react with sic at about 1300c and generate silicate, which calls alkali - chemical corrosion, and can influence the glowing of element

    在1300c左右，堿和堿性金屬氧化物與碳化硅發生反應，生成硅酸鹽，稱為堿化學侵蝕，會明顯影響元件發熱的紅熱程度。
  19. Manufacturer of specialized dispersions and compounds for the polymer industry, including non - halogen flame - retardant compounds for wire and cable applications, and specialty elastomers. located in canada

    -生產銷售泡沫玻璃，泡沫塑料，阻燃瑪碲脂，深冷粘結劑，巖棉及硅酸鋁製品，高強度聚氨脂管托
  20. Standard test method for bond strength of ceramic tile to portland cement

    瓷磚和硅酸鹽水泥粘著強度的標準試驗方法
分享友人
分享到 Line

分享到臉書