碰撞引信 的英文怎麼說

中文拼音 [pèngzhuàngyǐnxìn]
碰撞引信 英文
direct-action fuze （da fuze）
  • 碰 : 動詞1 （一物體突然接觸另一物體; 撞擊） touch; bump 2 （碰見; 遇到） meet; run into 3 （試探 ） tr...
  • 撞 : 動詞1 （猛然碰上） collide; strike; knock; bump against; run into 2 （碰見） bump into; run into;...
  • 引 : Ⅰ動詞1 （牽引; 拉） draw; stretch 2 （引導） lead; guide 3 （離開） leave 4 （伸著） stretch 5 （...
  • 碰撞 : 1 （猛然碰上） collide; run into; knock against; run foul of; crash 2 [物理學] collision; impact;...
  1. This paper analyzes the characteristics of rainfield and raindrops, gives - formulae to calculate falling velocity of raindrops, studies the frequency of raindrops hitting detonating area of fuzes head on ballistic trajectory based on the theory of exterior ballistics and uses statistical theory to study methods of rainfield simulation

    本文分析了雨場和雨滴的各種特性，給出了雨滴降落速度的計算公式，利用外彈道學的理論研究了引信頭部觸發區在彈道上與雨滴碰撞的頻率，同時還採用統計學手段對雨場模擬的方法進行了研究。
  2. The first chapter is introduction. a lot of possible signatures of qgp formation predicted by theorists are introduced in this part. the ultra - high energy heavy - ion experiments are the main ways to study qgp phase transition at the controlled condition

    論文的第一章為引言部分，主要介紹了qgd相變與夸克?膠子等離子體的特性，高能核?核碰撞的時空圖像和相變條件、以及理論上預言的qgp存在的一些可能的信號。
  3. Aiming at the high - speed impact characteristics of fuze pressure sensor when the percussion of the projectile, according to the requirement of developing fuze pressure sensor, the method of anti - ballistic simulation was adopted to design a suit of performance measuring device it could dynamically calibrate and simulate the process of collision between the projectile and the targets at the different angles and speeds

    摘要針對引信壓力傳感器在彈丸著發時處于高速沖擊狀態的特點，根據研製引信壓力傳感器的要求，採用反彈道模擬的方法，設計了一套既可對傳感器進行動態標定又可模擬彈丸以不同著角、不同速度碰撞目標時對傳感器進行性能測試的裝置。
  4. The theory of the simulation is that, firstly put fuze and parts in simulation device in reverse, then fire them in high speed by air gun, and they fly into gun spinning quickly and impact cushion and brass block in it, negative acceleration because of impact is to simulate setback, meanwhile they spin with spin gun when impacting, so spin environment can be simulated, so the simulation system can stimulate setback and spin of fuze in fire

    該模擬系統的原理是將引信及其零部件倒置在模擬彈丸中，通過空氣炮以高速發射出去，然後飛入高速旋轉的旋轉管內，與旋轉管內的緩沖塊和黃銅塊碰撞，碰撞而形成的負加速度作為引信發射時受到的后坐，由於碰撞時與旋轉管一起旋轉，模擬引信發射時的旋轉環境，達到模擬引信發射后坐與旋轉環境的目的。
  5. The closeness of both albums will no doubt cause comparisons to arise

    如此近距離的碰撞相信會引發更大的一個比較。
  6. Because the physical distance between ouns and olts in apon is different from each other, and the transmission distance will undergo dynamic changes as a result of the variation in environmental temperature and the aging of optoelectrical appliances, the differences in the uplink transmission delay will cause an overlay of the uplink time slots of onus, thus leading to the collision of different atm cell flows

    由於apon中各onu與olt之間的物理距離各不相同，並且其傳輸距離也會由於環境溫度的變化和光電器件的老化等因素而發生動態的改變，引起上行傳輸時延差異造成各onu的上行時隙重疊，從而導致不同的atm信元流發生碰撞。
  7. For power control of listening users, forward power control method are introduced based on full, multichannel, filtered report, and collision method etc. the full report method has redundancy report information, and its real - time performance is bad, multichannel report is introduced to improve the real - time performance, and filtered report is introduced to eliminate the redundancy information, finally the collision method introduced can not only get higher real - time performance but also diminish the redundancy information ; 2. in order to meet the requirements of making the dynamic simulation of trunking group system, the ms ’ s random move equation is brought forward, the simulation of ms ’ s distribution is done and the integrated channel model are presented ; 3. the smart predicative model of power control is introduced to overcome the delay and track the change of the complicated network, with this model, the power control ‘ s performance is greatly improved

    全匯報方法存在冗餘的匯報信息，而且實時性較差，為了改善實時性提出了多通道的匯報方式，為了改善冗餘匯報而提出了篩選法，最後介紹的碰撞法在減少冗餘信息的同時又提高了實時性;二、為了集群功率控制動態模擬的需要，提出了移動臺的隨機運動方程，進行了有關移動臺的分佈模擬，建立了綜合的通道模型;三、希望克服延時和跟蹤復雜網路環境變化，提出了功率控制的智能預測模型，通過智能預測模型可以改善功率控制的性能，著重介紹了採用神經網路的方法實現智能預測的通用模型，從而跟蹤復雜多變的無線環境，諸如慢衰落及快衰落（包括多徑衰落、多普勒效應所引起的衰落）等網路特徵，達到預測功率需求;四、採用二級正交碼和智能天線（空分多址）的方法進行組內用戶的識別，改進功率控制效果;五、話權用戶的前向和反向功率控制方法;六、對引入gota的cdma系統提出了復合容量表示方法，並作容量分析，探討有關gota系統的qos問題。
分享友人
分享到 Line

分享到臉書