磨粒粒度 的英文怎麼說

中文拼音 [mólìlìdù]
磨粒粒度 英文
grain grit
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. Abrasive macrograins - determination of capillarity iso 9137 : 1990

    磨料粒度.毛細作用測定
  2. Gold extraction from ground whole - of - ore by agitated leach ranged from 97 % up to 99 % depending on grind size and cyanide concentration

    通過范圍從97 %到99 %的攪動瀝濾，地面所有礦石中的黃金提煉取決于磨礦粒度和氰化物濃度。
  3. Abrasive grains - sampling and splitting iso 9138 : 1993

    磨料粒度.取樣和分割
  4. Abrasive grains - test - sieving machines iso 9284 : 1992

    磨料粒度.篩分試驗機
  5. Testing method for bonded abrasive grain size

    粘接磨料粒度的試驗方法
  6. Abrasive products - checking the grit size of superabrasives

    磨料製品.超級磨料的磨料粒度的檢驗
  7. Cast shot and grit size specifications for peening and cleaning

    噴丸和清理用鑄造鐵丸和磨料粒度規范
  8. Abrasive grains. sampling and splitting

    磨料粒度.取樣和分離
  9. Abrasive grains and crude - chemical analysis of silicon carbide iso 9286 : 1997

    磨料粒度.碳化硅的化學分析
  10. Comparison chart for grit sizes

    磨料粒度尺寸參照表
  11. Abrasive grains - determination of bulk density - part 1 : macrogrits

    磨料粒度.堆積密度的測定.第1部分:粗磨粒
  12. Coated abrasives - grain size analysis - part 1 : grain size distribution test

    塗附磨具用磨料粒度分析第1部分:粒度組成
  13. Bonded abrasives - determination and designation of grain size distribution - part 1 : macrogrits f4 to f220

    固結磨具用磨料粒度組成的檢測和標記第1部分:粗磨粒f4 f220
  14. Bonded abrasives - determination and designation of grain size distribution - part 2 : microgrits f230 to f1200

    固結磨具用磨料粒度組成的檢測和標記第2部分:微粉f230 f1200
  15. Coated abrasives - grain size analysis - part 2 : determination of grain size distribution of macrogrits p12 to p220

    塗附磨具用磨料粒度分析第2部分:粗磨粒p12 p220粒度組成的測定
  16. Coated abrasives - grain size analysis - part 3 : determination of grain size distribution of microgrits p240 to p2500

    塗附磨具用磨料粒度分析第3部分:微粉p240 p2500粒度組成的測定
  17. The effect of grind size and cyanide concentration, within the range tested was minimal

    本試驗范圍內，磨礦粒度和氰化物濃度的影響很小。
  18. Bond abrasives - determination and designation of grain size distribution - macrogrits f230 to f1200

    粘合磨料.粒度分佈的測定和標記.第2部分:粒度范圍為f230 - f1200
  19. Factors and mechanisms influencing granularity uniformity of nano - sized - al2o3 abrasives for preparing cmp

    3磨粒粒度均一性的因素及其機理
  20. Dental rotary instruments - diamond instruments - part 3 : grit sizes, designation and colour code

    牙科旋轉儀器.金剛石儀器.第3部分:磨料粒度牌號和色碼
分享友人
分享到 Line

分享到臉書