移動臂 的英文怎麼說

中文拼音 [dòngbèi]
移動臂 英文
moving arm
  • : Ⅰ動詞1. (移動) move; remove; shift 2. (改變; 變動) change; alter Ⅱ名詞(姓氏) a surname
  • : 臂名詞1. (胳膊; 從肩到腕的部分) arm 2. (人體解剖學上多指上臂) upper arm
  • 移動 : 1 (改換原來的位置) shift; move 2 [力學] translation motion; removal; shifting; dislocation; dis...
  1. Traveling portal jib crane

    式懸起重機
  2. Travelling portal jib crane

    式懸吊車
  3. Kinematics analysis of slide redundant manipulator

    導軌式冗餘度操作的運學分析
  4. Whereas modern apes exhibit a rich repertoire of locomotory modes ? from the highly acrobatic brachiation employed by the arboreal gibbon to the gorilla ' s terrestrial knuckle walking ? early miocene apes were obliged to travel along tree branches on all fours

    雖然現代猿的模式花樣繁多,例如長猿在樹間以雙身體、大猩猩在地面上以上肢手背關節支撐體重,但是中新世早期的猿類都以四肢在樹枝上活
  5. A movable temporary stay arrangement must be used to limit the cantilever stresses during construction to a reasonable level.

    必須採用一個可的臨時拉索裝置將施工過程中的懸應力限制在合理的范圍之內。
  6. Full floater technology connects the rear shock mounts to two moving linkages - the evo link on the top, and the extension of the swingarm at the bottom

    全漂技術將後防震架與兩個的連接結合起來evo連接位於頂部,搖擴展位於底部。
  7. Such products, whose front end are equipped with swing boom device ( as picture shows ), and side - dumping bucket, can work closely to the house corner or edge, very suitable for those operations in narrow working sites, without frequent driving the machines

    這種產品,在機體前部裝備了裝置(如右圖) ,配合反轉鏟斗,機器可以近距離的靠近墻角屋邊,非常適合在狹小的空間作業,工作中無須頻繁機身,狹窄地帶的作業可以應對自如,從而真正實現了類似墻角等狹窄地帶的直接挖掘工作。
  8. Key machine arm, the enter key start

    方向鍵機器,回車鍵啟
  9. This paper addressed three problems for a nonholonomic mobile robot. first, dynamics model of a six - wheeled rocker lunar rover is built. then based on this model the control strategies are proposed for trajectory tracking control and point stabilization

    本文以非完整機器人為控制對象,針對六輪獨立驅式月球車進行建模,分別對月球車的軌跡跟蹤問題以及輸入受約束的點鎮定問題進行了研究。
  10. Notice the new vibrations moving slowly under one ' s feet, up through the legs, hips and pelvis, solar plexus and diaphragm, breasts and chest, hands arms and shoulders, neck and head

    注意新振從你的腳下慢慢向上通過大腿,臀部和骨盆,太陽神經叢和橫膈肌,胸部與胸腔,手與肩膀,脖子與頭部。
  11. Specification for continuous mechanical handling equipment - safety requirements - loose bulk materials : mobile suction pipes suspended from derrick jibs used in pneumatic handling

    連續式機械裝卸設備規范.安全性要求.第4部分:鬆散物料:氣裝卸用起重式吸管
  12. Travelling derrick crane

    式轉起重機
  13. The main products are as follows : industrial storage racking, as / rs system, pallet racking, drive - in racking, push back racking, live racking, cantilever racking, drawer racking, mobile racking, light weight shelving, medium weight shelving and the relevant equipments ( stacking racking, pallet, cart, foldable mesh container, steel container, roller conveyer )

    公司主要產品有:大型倉儲超市貨架、自化立體倉庫貨架、貨位式貨架、貫通式貨架、壓入式貨架、重力式貨架、懸式貨架、輥輥式貨架、抽屜式貨架、式貨架、輕量型貨架、中量型貨架及周邊設備(堆垛架、掛板貨架、托盤、推車、倉儲籠、料箱、輸送輥道等) 。
  14. The saracen came on at the speedy gallop of an arab horseman, managing his steed more by his limbs, and the inflection of his body, than by any use of the reins, which hung loose in his left hand ; so that he was enabled to wield the light round buckler of the skin of the rhinoceros, ornamented with silver loops, which he wore on his arm, swinging it as if he meant to oppose its slender circle to the formidable thrust of the western lance

    撒拉遜人用阿拉伯騎士慣常的高速沖來,他靠身子操縱坐騎,很少用鬆鬆地掛在腕上的韁繩,空出來的左手拿著一麵包著犀牛皮的圓盾,盾上的銀環套在他的上,現在他晃著這面小盾,象是要靠它來抵擋西方人長矛的猛刺。
  15. Travelling jib crane

    起重機
  16. According to the principle of curve axial symmetry, authors inferred the theoretical foundation of error - free translation of the working equipment of loader and proved that when the diameter of piston rod on arm oil cylinder was designed properly, the two oil cylinders could be guaranteed to have a synchronous movement which made the bucket maintain translation throughout the working process under the condition of the oil cylinder ' s basic parameter ; also made the equipment structure of the loader greatly simplified and provided the reference for improvement of the present equipment of loader

    根據曲線軸對稱原理,推導出了能使裝載機工作裝置無誤差平的理論基礎,證明了只要適當地設計油缸活塞桿直徑,就可以在油缸的基本參數上保證機構工作時兩油缸同步運,使鏟斗在作業過程中保持平;使裝載機工作裝置結構大為簡化,為進一步改進現有裝載機工作裝置提供參考。
  17. This paper sets up the kinematics and dynamics models of three - link mobile manipulator by using lagrange dynamics equation and nonholonomic dynamics routh equation, and the method of artificial potential function is applied to the mobile manipulator to avoid collision with the obstacles and reach its target

    摘要採用拉格朗日力學方法和非完整力學羅茲方程建立了三連桿機器學和力學模型,並且利用該模型採用了人工勢函數方法來驅機械系統繞過障礙物到達目標位置。
  18. S26 serials move type sand mixer with long or short arm

    ( 1 ) s26系列長、短式混砂機。
  19. String players practice moving the fingers of the left hand up and down, while drawing the bow to and fro with the right arm ? two entirely different movements

    小提琴演奏者每天練習演奏上下左指的同時右前後拉弓- - - - -兩種完全不同的
  20. Terminalization the movement of chiasmata to the end of the bivalent arms, a process that may occur during late prophase i of meiosis

    交叉)端:發生在第一次減數分裂後期,染色體交叉向二價體染色體的末端的過程。
分享友人