穩定誤差 的英文怎麼說

中文拼音 [wěndìngwùchā]
穩定誤差 英文
stabilized error
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 穩定 : 1 （使穩定） stabilize; steady 2 （穩固安定） stable; steady 3 （物質的性能不易改變的作用） stabi...
  • 誤差 : error
  1. Finally, the controller working based on the combination of rbf neural networks and traditional pid control was applied to in aclinic kinetic machinery and lifting machinery of tower crane. the simulation of this controller was made using matlab, and the simulation results showed that the control system has some merits, such as quick response, little overshoot, well anti - jamming capacity, and little steady - state error, etc. both the dynamic property and static characteristic of this controller are better than traditional pid controller, and meet the tower crane

    應用matlab對塔機的變幅和起升機構的運動控制進行模擬，模擬結果表明基於rbf神經網路整定pid的控制系統具有響應快、超調小及穩態誤差小等優點，其動、靜態性能優于單一pid控制，從而提高了塔式起重機工作機構的工作性能。
  2. So-called "gimbaling errors" can result from improper gimbal geometry or from imperfect roll and pitch stabilization of the gimbal system.

    所謂「框架誤差」是框架幾何形狀的不正確或框架系統的側擺和俯仰穩定得不完善所產生的。
  3. This thesis is to recommend a important class of regularized strategies for solving inverse problems - mollifier method. it anaysises the consistency, numerical stability and error estimates of mollified solution. similar to tikhonov regularization, a discrepancy principle for selecting the mol - lifier parameter is proven and applications to numerical differentiation and numerical inversion of abel transform and also given

    本文將介紹求解反問題的一類重要的正則化策略?緩鎮法，並基於用gauss核構造的緩鎮運算元，分析了緩鎮解的相容性、數值穩定性和誤差估計，與tikhonov正則化類似，我們證明了決定緩鎮參數的偏差原理。
  4. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為： （ 1 ） 、這次冷渦在其發生發展過程中，其移動路徑是沿經圈直線南壓，攜帶的冷空氣勢力較強，形成槽后較強的垂直運動； （ 2 ） 、西太平洋副熱帶高壓偏北位置與東北冷渦南壓形成的急流軸，把源源不斷的西南暖濕氣流輸送到遼西地區，也就是急流軸的左前方位置，為這次暴雨的產生提供了充足的水汽來源； （ 3 ） 、低空急流不但為暴雨輸送水汽，其造成的較強的垂直環流也是產生強降水的一個主要原因； （ 4 ） 、 mm5模式以四維同化資料作為初始場，最大限度地避免了觀測誤差可能造成的積分不穩定，提高了模擬結果的參考價值。
  5. We validated this system on the black - body oven, analyzed the errors which brought about by the optical system, ccd, surroundings and workers, expounded the improvement methods ; 5. we had done many real measurements with this system. after analyzing the experiment results, we improved the original system and proposed a new system

    在自己研製的黑體爐上對系統進行了標定實驗研究，對標定誤差進行了分析，對消除光學系統、 ccd 、環境以及主觀因素等對誤差的影響提出了改進和處理方法，大量實驗得出了較為穩定的標定測量值，為系統進行實際工況環境下的測量奠定了基礎； 5
  6. The experiment and simulation results show that the stabilization error peak is caused by the step friction torque when the disturbance changes its direction

    實驗和模擬顯示轉臺穩定誤差在擾動換向時的「尖峰」由轉臺轉軸的靜摩擦階躍干擾力矩產生。
  7. And so on, the mathematical model and transfer function of the tracking system are built, and the feasibility of the tracking control system design is demonstrated. furthermore, the static error of the system with a unit incline input is deduced. a majority of model of unit is based on analytics, so the general model can apply to other optical intersatellite communications systems

    在此基礎上，將atp跟蹤控制子系統視為線性定常系統，通過解析法和實驗法對子系統的各個控制環節的單元器件進行合理建模，得出整個環路總的開環及閉環傳遞函數，論證了本課題所設計的atp跟蹤控制環路的可行性及其視軸輸入為斜坡信號時的理論穩態誤差。
  8. Among the adaptive beam - forming algorithms, the least mean square algorithm is widely used because it has a simple configuration and it is apt to come true and have nice convergence. on the other hand, it has a disadvantage that it converges slowly and there is a conflict between the fixed step and the convergence pace or the error in stabilization. so people have developed many improved least mean square algorithms which generally start from convergence, stabilization, misadjustment, and robustness and come to a formula about variational step in the end

    在自適應波束形成演算法中，最小均方（ lms ）演算法因結構簡單，易於實現，能穩定收斂而得到廣泛應用，但它也存在收斂速度受限的缺點：固定步長因子無法解決收斂速度和穩態誤差之間的矛盾。因此，人們提出了各種改進的最小均法演算法來解決這一問題。改進的最小均方演算法通常從如何改進收斂速度、穩態誤差、失調量和魯棒性等指標上出發，最後在新演算法最終表達式中的步長公式上變化。
  9. The step friction torque is the main source for the stabilization error

    這種干擾力矩是對穩定誤差影響最大的因素。
  10. Experiment and simulation show the same result in rejection frequency characteristic and time domain stabilization error

    對轉臺的抑制比頻率特性以及時域穩定誤差的實驗和模擬取得了一致的結果。
  11. Generally the effect of many factors causes a deviation of the result from the ideal, but the stabilization error is a key element of all factors

    一般來講，引起光電穩定系統精度偏離理想情況的因素頗多，但穩定誤差是非常關鍵的一項。
  12. Simulation system of a single axis stabilized turntable system shows that the peak of the stabilization error is caused by the step friction disturbance torque

    針對一個單軸穩定轉臺進行的模擬和實驗結果表明，在擾動換向時產生的穩定誤差尖峰由擾動換向時的階躍摩擦乾擾力矩產生。
  13. The current loop technique improves the stabilization bed ability to reduce base disturbance direct drive constraint couple and enhances the torque sturdiness. the stabilization error is reduced with current loop technique under same base angular disturbance

    在轉臺穩定系統中使用電流環技術，提高了轉臺對直接帶動約束耦合的抑制能力，提高了系統的力矩剛度，在同等的擾動條件下，降低了穩定誤差。
  14. The controlled system has much defect, such as asymmetry of the dynamic characteristic, low accuracy, bad stability. on the contrary, self - adaptive control can eliminate model error, restrain outside disturbance and parameters ’ change of the system

    由於被控對象本身具有動態性能不對稱，系統精度低，穩定性差等缺點，而自適應控制具有消除模型化誤差，抑制外界干擾及本身參數變化等優點。
  15. The essential theory of analog phase lock loop ( apll ) and digital phase lock loop ( dpll ) are introduced

    然後介紹了模擬鎖相環和數字鎖相環技術，並對數字鎖相環的穩定性和穩態誤差性能進行了分析。
  16. Because the friction force mainly influences the track precision and the orientation precision of the servo system, it should consider these two targets changes between before and after compensation. low - velocity ramp signal and step signal were chosen as simulation test signal

    由於摩擦力主要影響電液位置伺服系統的低速跟蹤精度和定位精度（即穩態誤差） ，所以要考慮補償前後這兩個指標的變化情況，模擬測試信號選為低速斜坡信號和單位階躍信號。
  17. The deterministic steady state errors with jerk model are eliminated in the new model, the advantages of ‘ current ’ statistic jerk model is also illustrated via simulation

    該模型消除了jerk模型中存在的確定性穩態誤差，模擬實驗驗證了該模型的優越性。
  18. According to the model, some kinds of parts of an apparatus are choosed and stability, error, time - domain and frequency - domain are presented

    根據數學模型，選取了具體型號器件，並從系統的穩定性、穩態誤差、時域和頻域方面對系統進行了分析。
  19. The paper regards the middle hollow electrohydraulic servomotor as studying object and build the mathematical model, the stability and the frequency response of opened - loop and closed - loop system are analyzed. this paper discusses the influences of steady error and static error on system precision in detail

    文章以中空電液伺服馬達為研究對象，建立了電液位置伺服系統數學模型，分析了系統的穩定性、開環和閉環的頻率特性，詳細探討了系統的穩態誤差和靜態誤差對系統精度的影響。
  20. Due to the convergent speed and steady - state error are affected by the fixed stepsize and can not be improved simultaneously in classical lms algorithm, this paper presents an improved algorithm of lms

    針對傳統的lms （ leastmeansquare ）演算法中，固定步長選取影響收斂速度與穩態誤差的這一對矛盾，提出了一種改進的lms演算法。
分享友人
分享到 Line

分享到臉書