管受熱面 的英文怎麼說

中文拼音 [guǎnshòurèmiàn]
管受熱面 英文
heating surface of tubes
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. The paper mainly consider the followings : the performance parameter determination of cryopump, heat load determination and heat transfer of large cryopanel, reasonable distribution of heat load, the condition for construct steady flow in small vertical circle pipeline, balance condition for gas and liquid two - phase flow in the connection pipe between cryopanel and dewar, the safety of cryopump

    文中探討了低溫泵性能參數的確定；大抽速低溫抽氣面的熱負載的確定及合理分配；冷凝面上豎直圓管內受熱建立穩定流動的條件；冷凝面與杜瓦間的連接管道內氣液「雙相流動」的平衡條件；低溫泵系統運行的安全問題。
  2. The difference of heated area between tubes is very small, so the thermal deviation mainly results from inhomogeneous endotherm and flux

    但由於管子毛間的受熱面積差異很小，過熱器的熱偏差主要由於吸熱不均勻和流量不均勻造成。
  3. Abstract : based on the analysis of influence of tubular rib construction on heat transfer area on steel blank and heat transfer space in furnace, a t - shape support system for tubular rib is presented, by which the construction of wholly overhead furnace hearth can be realized for large and medium scale continuous reheating furnaces, making furnace gases to come into full contact with steel blank, raising space utilization ratio of furnace chamber and improving heat exchange

    文摘:分析了爐筋管結構形式對傳熱空間、坯料受熱面積的影響；提出採用t形支撐技術優化爐筋管，可實現大、中型連續加熱爐的全架空爐底，使爐氣與坯料表面充分接觸，提高爐膛空間利用率，可較大幅度提高爐膛熱交換。
  4. For long - term protection of heated pipelines, exhaust pipes, smoke stacks and other heated surfaces up to 550 - 600

    長期保護加熱管道、排氣管道、煙囪及其它溫度可高達550 - 600的受熱面。
  5. All sorts of methods for preventing and reparing the damage of panel pipe of heating surface which is caused by boiler sootblower

    鍋爐吹灰器吹傷受熱面管排的綜合治理
  6. Approchment to the calculation on hydrodynamics of the flag pattern surface on corner tube boiler

    角管鍋爐旗式受熱面水動力計算方法探討
  7. This program can predict the wall temperature 、 internal wall heat tranfer coefficient 、 fluid temperature and entropy profile along the water wall. all of these provide an important foundation for designing this type of water wall structure to ensure the safety of the boiler operation. this hydrodynamic calculation program and the results can be used to analyze operation reliability and structure design of water wall system

    利用所開發的程序對設計的超臨界cfb進行了計算，給出不同負荷下，水冷壁出口工質溫度分佈，水冷壁受熱面不同位置處的金屬壁溫、內壁放熱系數、流體溫度焓值分佈，以及不同管子的流動壓降等結果，為分析鍋爐工作可靠性及水冷壁系統的結構設計提供了重要依據。
  8. After implementing the said measures, tube - burst ratio due to over - temperature of the heating surface has reduced from 34. 8 % to 15 %, occurrence ratio of said leakage accidents due to improper repairs has also greatly decreased, but leakage times resulting from welded defects and material quality of the heating surface are enhanced obviously

    實施后，受熱面超溫爆管比例從34 . 8 %下降至15 % ，因檢修不良而造成的「四管」泄漏發生率也有大幅下降，但因焊接缺陷和受熱面材質造成的泄漏次數卻明顯上升。
  9. The water went up in the tube because, when the water became hot, its volume increased, nearly all liquids and solids get bigger like this when they become hot

    玻璃管中的水面上升是因為當水變熱時，它的體積增加，幾乎所有的液體和固體受熱時都像這樣變大。
  10. So its naissance brings a lot of hope and promotion to application and deploitation of milimeter and submilimeter - wave. because of gyrotron, s superiority of high peak power and average power among many known milimeter and submilimeter - wave gyrodevices, it has been paid much respect in the world for application in many areas such as plasma heating, rf accelerator, millimeter radar, dew and so on

    由於迴旋管具有在毫米、亞毫米波段其它器件無可比擬的高峰值功率、高平均功率的優越性，因此在受控熱核聚變等離子體的迴旋管加熱（ ecrh ） 、電子高能rf加速、雷達系統、通信系統以及定向武器（ dew ）等方面都有著廣闊的應用前景。
  11. It tell us : the abrasive capability of fly ash ; the similar calculation of ash erosion ; the calculation of ash erosion in the tube in turn and tube out of turn ; the reason of tube abrasion for gas flue ; the influence of air parameter for fly ash erosion ; the influence of changing temperature ; the influence of the flue gas composition, etc. next, it advances the solving measure ; reduce the flue gas velocity ; reduce the concentration of fly ash ; responsible construction : replace smooth tube with spiral tube ; use the new material of abrasion ; fuel desulfurization ; reduce so3 of flue gas ; raise flue gas temperature, making it up the dew point ; use the abrasion - resistance material to resist abrasion

    討論了飛灰磨損性能、管壁受飛灰沖蝕的近似計算、灰粒對順列管和錯列管的磨損計算、煙氣走廊引起對流管束的磨損機理、空氣動力參數對飛灰沖蝕的影響以及受熱面壁溫變化及煙氣成份對飛灰磨損的影響等問題。接著提出了解決的措施：降低平均煙氣流速；降低飛灰濃度；使用鰭片管、螺旋翅片管代替光管；選擇合適的結構及排列方式，減少煙氣中so3的含量；提高受熱面壁溫使之大於煙氣的露點溫度；採用抗腐蝕材料作受熱面等防腐蝕的措施。
  12. Preliminary study on tube clip weld rupture of boiler heating surface

    鍋爐受熱面管定位連接件焊縫開裂原因初探
  13. Superheater, reheater and economizer are the main component of the heat exchangers in boiler. whether they run safely and stably or not is directly count for much the safe of the whole plant operation. and the frequent tube leakage of heat surface impact upon the economy benefits and the society benefits of the power plant

    水冷壁管、過熱器管、再熱器管、省煤器管（ 「四管」 ）是鍋爐內部的主要受熱面結構件，它們是否安全穩定的運行直接關繫到整個電廠的安危，頻繁爆漏事故影響了電廠的經濟效益和社會效益。
  14. Reliability design and life assessment of large capacity station boiler tubes

    大容量電站鍋爐受熱面管子的可靠性設計與壽命評定
  15. Welding quality supervision management of in - service boilers in heating surface modification project

    在役鍋爐受熱面管改造工程中的焊接質量監督管理
  16. There are a lot of advantages when inner trachea applied in air pre - heater, such as the improvement of the temperature of pipe, the low consumption of metal, except for the increment of flow resistance. according to many related papers, it is more proper inner trachea with the structure of short distant between two whorls and shallow depth of whorl. it can enhance heat transfer with smaller flow loss

    內螺紋管是一種異形管，和光管相比，管內側的換熱系數大大增強了，應用於空氣預熱器可以起到提高總傳熱系數、節約受熱面金屬消耗量的目的；同時提高了管壁溫度，能夠減輕低溫腐蝕的程度和速度；不足之處是帶來了更大的阻力損失。
  17. There will appear a very uneven flow field, and appear a very big velocity magnitude distribution and ash concentration distribution near back wall. thus, the velocity magnitude is far bigger than that of optimal design velocity magnitude, which will lead to serious wear and tear in metal face of heater. especially, because of curve structure in front of heat pipe air preheater, there is more serious wear and tear

    由於靠近豎井后墻面的煙氣流速很大，飛灰濃度也較大，斷面速度分佈的最大速度大於最佳設計速度的2 - 3倍，這樣將造成受熱面的嚴重磨損，特別是熱管空氣預熱器前端煙道的幾何結構有一定的轉角，更增加了磨損的程度。
  18. There come two questions when the temperature of gas is low. one is that metal consumed in air pre - heater is relatively more, due to lower temperature press and heat transfer coefficient. the other is that corrosion of pipe result from so2, which exists in gas

    由於煙氣溫度低而產生了兩個問題：一個是傳熱溫壓小，管子所用金屬的消耗量相對比較多；另一個是受熱面的管內側金屬壁面容易出現低溫腐蝕。
  19. Basing on the studies on the problems of leak - in, intermittent supplying water, ashing and abrasion in the operation of the auxiliary heating surface - economizer of chain boiler, the problems have been solved, through reinforcing the economizer ' s seal, supplying water frequently and using fin tube economizer. the economizer will reach the design effect in practical operation and the fuel will be saved

    本文在分析鏈條鍋爐輔助受熱面省煤器運行中存在的漏風、間斷上水、積灰及磨損等問題的基礎上，通過加強省煤器的密封、勤上水、採用鰭片管省煤器等措施解決省煤器在運行中的問題，使省煤器在實際運行中達到設計效果，節約燃料。
  20. The tubes of superheater and reheater are the main component of the heat exchangers in power plant boilers. whether they run safely and stably or not is directly count for much the safe of the whole plant operation

    電站鍋爐過熱器管和再熱器管是鍋爐內部的主要受熱面結構件，它們是否安全穩定地運行直接關繫到整個電廠的安危，頻繁爆管事故影響了電廠的經濟效益和社會效益。
分享友人
分享到 Line

分享到臉書