管道尺寸 的英文怎麼說

中文拼音 [guǎndàochǐcùn]
管道尺寸 英文
line size
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 道 : Ⅰ名詞（道路） road; way; route; path 2 （水流通過的途徑） channel; course 3 （方向; 方法; 道理） ...
  • 尺 : 尺名詞[音樂] （中國民族音樂音階上的一級 樂譜上用做記音符號 參看「工尺」） a note of the scale in ...
  • 寸 : Ⅰ量詞（長度單位） cun a unit of length （=1/3 decimetre）Ⅱ形容詞（極短或極小） very little; very ...
  • 管道 : [工業] pipeline; channel; tunnel; piping; canalis; pipe run; duct; conduit; conduit pipe; ducting...
  1. Cut tube end square. ream, burr and size

    垂直切割管道。刮除毛刺，測量尺寸。
  2. Modular co - ordinating sizes of piping unit for dwellings

    住宅管道裝置的模數協調尺寸
  3. Threaded - in bonnet is common in lighter - duty services and smaller sizes of bronze multi - turn valves

    螺紋旋進式閥蓋：通常用於輕型管道系統和小尺寸青銅多回轉閥門中。
  4. When threading pipe, gauge pipe threads for size and length to avoid jamming pipe against seat and disc

    當對管道進行攻絲時，要測定管道螺紋的尺寸和長度，避免將管道塞滿閥座和閥瓣。
  5. Eight trapezoid labyrinth flow - channels are designed through modification to the cell dimension and the number of flow cells based on the parameterized structural design. integral emitter prototypes combining exterior hull and exterior flow - channel are built using rapid prototyping technique, and structural dimension of those flow - channel are measured by optical microscope, the measuring results showed that the design can completely meet the requirement of emitter accuracy

    文中以參數化的設計思想，通過改變梯形迷宮流道單元尺寸和單元數設計了8種梯形迷宮流道，採用快速成形技術製作出外管與內迷宮流道一體化的滴頭原型；利用最小標注尺寸為50nm的光學顯微系統對滴頭流道結構尺寸進行了測量，分析結果顯示流道尺寸精度完全滿足滴頭的製作要求。
  6. Vacuum technology. steel tubes for vacuum pipes. dimensions

    真空技術.真空管道用鋼管.尺寸
  7. Ventilation for buildings - ductwork - dimensions and mechanical requirements for flexible ducts

    建築物的通風.通風道工程.軟導管尺寸和機械性能要求
  8. En1123 - 2 pipes and fittings of longitudinally welded, hot - dip galvanized steel pipes with spigot and socket for waste water systems. part 2 : dimensions

    廢水系統帶插端和管座的徑向焊接熱浸電鍍鋼管管道和配件.第2部分:尺寸
  9. For small male and female joints care should be taken in the use of these dimensions to insure that the inside diameter of fitting or pipe is small enough to permit sufficient bearing surface to prevent the crushing of the gasket

    對于小型外內法蘭連接，在採用這些尺寸時要小心謹慎，確保連接件或管道的內徑足夠小，具有充分的支撐面，防止墊圈破碎。
  10. Road vehicles. thermoplastics tube for air braking systems. part 1 : dimensions and marking

    道路車輛.氣閘系統用熱塑管材.第1部分:尺寸和標記
  11. Fibre - cement pipes and fittings for discharge systems for buildings - dimensions and technical terms of delivery ; german version en 12763 : 2000

    建築物排水系統纖維水泥管道和配件.尺寸和交貨技術條
  12. Hot rolled steel channels - tolerances on shape, dimensions and mass

    熱軋鋼管道.形狀尺寸和質量公差
  13. Ventilation for buildings - ductwork - dimensions of circular flanges for general ventilation ; german version en 12220 : 1998

    建築物內通風.空氣管道.一般通風用圓形法蘭尺寸
  14. The main achievements are as follows : the theory models of defect mfl field are set up ; based on the magnetic dipole model and finite element model, the distribution of defect mfl field is simulated in the dissertation ; the component of flux density ( magnetic filed ) parallel to the surface of pipe is detected by a circumferential array of hall probes ; the factors including defect geometry parameters, defect surface angle and shape, pipe material, field intensity, vehicle velocity, background magnetization, operating pressure and remanent magnetization and so on influence the mfl signal characteristics

    採用霍爾元件作為缺陷漏磁檢測傳感器，獲得管道軸截面漏磁場切向分量的漏磁信號；研究了缺陷外形尺寸、缺陷傾角和形狀、管道材質和磁化強度、檢測儀移動速度、管道背底磁場、管內壓力和剩磁對漏磁信號的影響。提出了各通道增益放大、各路漏磁信號偏離調整、波形微分、數字濾波和平滑等漏磁信號預處理方法；分析了等空間采樣的漏磁信號轉換為等時間采樣信號的必要性，研究了漏磁信號的小波去噪方法。
  15. Tubular metal products other than pipe, preferred metric sizes for

    除管道外管狀金屬產品的最優米制尺寸
  16. Preferred metric sizes for tubular metal products other than pipe

    除管道外的管形金屬製品的優選米制尺寸
  17. The passage dimension of separation chamber, the heating temperature of intake pipe air and the relevant influence of the ceramic heat insulation coating of combustion chamber upon the compressive ignition process of natural gas were studied by experiment

    實驗研究了分隔室通道尺寸、進氣管空氣加熱溫度、燃燒室陶瓷隔熱塗層對天然氣壓燃著火過程的相關影響。
  18. Construction machines and machines for building materials ; concrete delivery pipelines ; dimensions

    建築機械和建築材料機械.混凝土輸送管道.尺寸
  19. In - line dynamic mixers are engineered to suit the application ( ie. throughput, pipe size, etc. )

    管道動力混合器適合於工程配置的應用（如，產量，管道尺寸等） 。
  20. The dimensions of the gas adduction pipeline should be in function with it ' s length and with gas delivery according to uni regulations

    採用的氣體管道尺寸，他的長度、傳遞方式必須根據uni的規程。
分享友人
分享到 Line

分享到臉書