粒子計數管 的英文怎麼說

中文拼音 [zishǔguǎn]
粒子計數管 英文
particle counter
  • : Ⅰ名 (小圓珠形或小碎塊形物) small particles; grain; granule; pellet Ⅱ量詞(用於粒狀物)
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • : 數副詞(屢次) frequently; repeatedly
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • 粒子 : grain; granule
  • 計數 : count; tally; counting計數卡 numbered card
  1. The autogeny target neutron and pipeline neutron are monitored with associated particle method and long counter through changing different target foil. the effect of the autogeny target neutron is over ten times than that of the pipeline neutron

    對加速器d - t中源自生靶中道中,通過改變不同靶片,用伴隨法和長器進行測量,評估了自生靶中道中的影響。
  2. According to the " solid - particle " theoretical model, a theory model of the dynamic burning - velocity of a rocket - portfire in its igniting delay - time cannulation is established, a theory model of the dynamic delay - time is educed. the factors are analyzed, setting position and shape of a igniting delay - time cannulation that affect its igniting delay - time, the theoretical basis is offered to develop the high - level precision rocket - portfire in the air

    本文根據「固體」效應理論,建立了點火延期動態燃速學模型,導出了點火延期動態延時控制的理論算模型,分析了火箭空中點火延期的安裝位置及其形態對其延期時間的影響,為高精度火箭空中點火具的工程研製提供了理論依據。
  3. The paper applyed principle analysis and numerical computation to compare the scheme of particle injection syphon and convergence - turn tube. the last method was adopted to conduct research because it could produce high concentrated particles stream and operated conveniently. 2

    本文應用原理分析、算等手段,對加入、彎和收斂?折方案進行了比較,認為收斂?折方案可以產生發動機在飛行過載中的凝相聚集效應,且燒蝕參控制方便。
  4. The basic principle, main properties, typical parameters, technical characteristics and general situation of klystron are introduced. the electron beam prebunching in the modulated cavity and shift tube of relativistic klystron amplifer ( rka ) is studied analytically, a self - consistent equation of radiation generated by the prebunched electron beam in the radiation cavity is derived using the field method of particle ? wave interaction instead of the electrical circuit method, and in terms of it, the gain in the linear regime calculated, a field analysis method is proposed. the theory analysis shows that the characteristic parameters, such as resonance frequency, real part of gap - impedance, external quality fadtor in all kinds of klystron output circuits including single - beam, multi - beam, single - gap, multi - gap, single - beammulti - gap, multi - beam multi - gap klystron output circuit, can be calculated by the field analysis method

    本文系統的介紹了速調的工作原理、主要特點、發展概況、主要性能指標和技術特點,解析的研究了電束在相對論速調放大器的調制腔和漂移中的預群聚;用波互作用的場方法導出了在輻射腔中預群聚電束產生輻射的自洽方程,同時對線性區的增益進行了算。理論分析表明,場分析法可用於算單注單間隙、多注多間隙、單注多間隙和多注多間隙速調輸出迴路的諧振頻率、間隙阻抗實部和外觀品質因等特性參
  5. Measurment of emission rate of particle. method for large area proportional counter

    發射率的測量大面積正比
  6. Beta counter tube

    粒子計數管
  7. Firstly, when the pipe flow was laminar, the movement of fibers was computed in the 2 - d force formulae that were deduced from the slender body theory and in 3 - d integral method. results revealed that angles between fibers " axis and the orientation of flow would concentrate gradually on a low number as the re numbers increased. that is, the axis of fibers would rotate toward the orientation of flow

    首先,當道內流動為層流時,分別利用從細長體理論出發得出的纖維二維受力公式和三維分段積分算方法模擬了大量纖維在流場中的運動,然後在最終時刻統了纖維的偏角分佈,並得出相同的結果:隨著re的增加,纖維的偏角逐漸集中於小角度,即纖維軸線方向越來越集中於流向,此結果與實驗吻合較好。
  8. In the next part, after verifying the simplified computational method of turbulence, the movement of fibers in turbulent pipe flow was simulated by 3 - d integral method and simplified computational method of turbulence. it was found that the fluctuation of turbulence caused random of fibers " orientation and its distribution became broader as the re numbers increased

    然後,在驗證了湍流的簡化方法的合理性后,利用三維分段算方法和湍流簡化方法模擬了大量纖維道湍流內的運動,得出的結果為:湍流的脈動速度導致了纖維的偏角趨于無序,且隨著re的增加,纖維偏角的分佈越來越趨于均勻。
  9. And this numerical result is similar to the experimental result. then, the computation was played on different domain, rate of fibers and st numbers and got the conclusion that the farther the distance between the domain and the center of the pipe was, the more fibers " axis concentrated on the orientation of flow, while the rate of fibers and the st numbers had little influence on the distribution

    然後通過考慮道截面上的不同區域、改變纖維長徑比和st來研究他們對纖維偏角分佈的影響,從而得出結果:隨著算區域從道截面的中心向壁面的轉移,纖維的偏角分佈逐漸集中於低角度;而纖維長徑比和st卻對纖維的偏角分佈沒有明顯影響。
分享友人