粘合纖維片 的英文怎麼說

中文拼音 [niánxiānwéipiān]
粘合纖維片 英文
bonded web
  • : 粘動詞(粘附) glue; stick; paste; adhere to; bond
  • : 合量詞(容量單位) ge, a unit of dry measure for grain (=1 decilitre)
  • : 纖形容詞(細小) fine; minute
  • : Ⅰ動詞1 (連接) tie up; hold together; link 2 (保持; 保全) maintain; safeguard; preserve; keep ...
  • : 片構詞成分。
  • 纖維 : fibre; staple; filamentary
  1. It is felted by flakes planed from timber crossbedded. thus wooden fibre is interconnected to keep stable performance of product

    採用木材刨切成的薄,縱橫交錯,多層組結而成,使其木材相互牽扯保持性質穩定。
  2. Section two the evaluation of biocompatibility of the acellular dermal matrix by the method of cell culture. the new born rat ' s epdermic cells were cultured with the acellular dermal matrix together as experiment group, while the epdermic cell were cultured simply as control. 24 hours later, under the invert microscope, the epidermic cells anchored well and transparent flat cells were observed in both groups. 7 days later, both cultured cells were taked out and fixed in 95 % ethanol, stained with hematoxylin and were observed under light microscope. many cleaved cells were observed in both groups. during cell culture, no pathogenic microganism was observed. so we considered the acellular dermal matrix was aseptic and had good biocompatibility. section three subdermal implantation of the acellular dermal matrix. 24 rats were used in the experiments. a piece of acellular dermal matrix ( 1. 5 x 1. 5cm2 ) was implanted beneath the dorsum skin flaps of each rat, 1 week, 2 weeks, 3 weeks and 4 weeks after implantation, 6 pieces of acellular dermal matrix were harvested and the size of implanted acellular dermal matrix were measured, the sections were used for he staining and observed under light microscope. the result were as folio wing : 1 - 2 weeks after implantation, the acellular dermal matrix began to adhere to the tissue around and turned red gradually ; 3 - 4weeks after implantation, the acellular dermal matrix adhered closely to the tissue around and could be recognized easily, 1 - 3 weeks after implantation, the size of implanted acellular dermal matrix had no statistical difference ( p > 0. 05 ). 4 weeks after implantation implanted acellular dermal matrix contracted ( p < 0. 05 ). under light microscope, l - 2weeks after implantation, the fibroblast cells infiltrated the acellular dermal matrix and a small amount endothelial cells of vessel and lympho - histiocytic cells infiltrated the acellular dermal matrix. 3 - 4 weeks after implantation, infiltrating blood vessels were evident. so we think that the acellular dermal matrix had low immunological reactions and could induce the infiltration of fibroblast macrophage cell and the endothelial cells of vessel

    結果如下:皮下包埋卜周者,無細胞真皮基質漸與周圍組織附,顏色由蒼白轉紅;皮下包埋3周者,無細胞真皮基質與周圍組織緊密枯附,盾晰葉辯;術后卜周,包埋的基質面積變化較包埋前無統計學差異o川0引,術后4周包埋的無細胞真皮基質面積較包埋前縮小j刃刀5 ) 。光鏡下術后卜周,宿主的淋巳組織細胞、成細胞浸入生長,釉附在膠原上,少量血管內皮細胞浸入基質;術后34周,無細胞真皮基質內較多的血管形成,故可認為無細胞真皮基質免疫原性低,能誘導宿主的成細胞、巨噬細胞浸入生長,為一種新型的真皮替代物。第四部分無細胞真皮基質與自體斷層皮移棺的研究, sd大鼠10隻,在其背部卜方造成全厚皮膚缺損的創面
  3. Through direct pullout test, we examine the effect of the water to cement ratio, contend of steel fiber and silica fume on the bond behavior ; compare the bond behavior of two types of cfrp bars with difference surface treatment ( r1 bars and g1 bars ), and reprocess the one of inferior bond strength ; investigate the bond stress distribution along the bond length of cfrp bars, and assess the adequacy of some exist analytical models of bond - slip behavior to reproduce the experimental bond behavior

    本文主要通過直接拉拔試驗,考察水膠比、鋼摻量、硅灰摻量以及cfrp筋的表面處理類型等材料參數對結性能的影響,並對結效果較差的cfrp筋研究了表面處理方法,以提高cfrp筋與rpc的結性能;通過在cfrp筋表面貼應變,測定了結應力沿cfrp筋埋長的分佈情況,並對現有的結滑移本構模型與試驗結果的擬效果進行了比較。
  4. The creep behavior of carbon fiber reinforced polymers is studied, and the regularity between time and creep deflection is analyzed. creep model is established by statistic analysis, as well as the influence on engineering practice and prestressing bonding frp technique induced by creep behavior of cfrp is analyzed

    研究了卸載后碳材的強度、模量變化情況,分析了徐變性能對加固綜效果的影響以及對預張拉貼碳材加固混凝土結構的影響。
  5. 1. experiments on uniaxial tensile of cfrp and gfrp are carried out, in which the tensile strength, young ' s modulus and ultimate deflection of frp are measured. the influence on tensile behavior caused by different adhesives is analyzed, and the standardization problem on tensile test methods is discussed

    設計了加載裝置和測量應變裝置,測試6種不同材和結劑組的抗拉強度、彈性模量、極限應變,並分析不同結劑對材拉伸性能的影響,最後對材拉伸試驗的標準化問題進行了簡單的探討。
  6. Specification for rubber bonded compressed asbestos fibre jointing

    橡膠壓縮石棉規范
  7. Specification for rubber bonded compressed aramid fibre jointing material for aerospace purposes

    航空航天用橡膠壓縮芳族聚酰胺材料規范
  8. These problems that the influence of bond behavior among frp layers caused by the freeze - thaw action, and bond behavior between frp and concrete experienced freeze - thaw - iii - action are studied by test. in addition, the influence on integral structures by freeze - thaw action and wet - thermal condition is considered. 6

    對于凍融循環對多層增強復材料之間結性能的影響、 frp材與受到凍害混凝土的結性能問題、凍融循環對frp材加固混凝土結構整體性能影響問題和濕熱環境對frp材與混凝土結性能的影響問題進行了試驗研究。
  9. A fortran program based on conjugate beam is worked out to analyze repaired beams, and the outcome correlates well with experiment data

    本文利用共軛梁法編制了fortran語言的計算機程序對貼碳材加固后的鋼筋混凝土梁進行了數值分析,計算結果與試驗結果吻良好。
分享友人