精密比重計 的英文怎麼說

中文拼音 [jīngmìbǐzhòngjì]
精密比重計 英文
sensitive hydrometer
  • 精 : Ⅰ形容詞1 （經過提煉或挑選的） refined; picked; choice 2 （完美;最好） perfect; excellent 3 （細）...
  • 密 : Ⅰ名詞1 （秘密） secret 2 [紡織] （密度） density 3 （姓氏） a surname Ⅱ形容詞1 （距離近; 空隙小）...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 重 : 重Ⅰ名詞（重量; 分量） weight Ⅱ動詞（重視） lay [place put] stress on; place value upon; attach im...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 精密 : precise; precision; accurate
  • 比重 : 1 （部分在整體中所佔的分量; 比值） proportion 2 [物理學] （物體重量和其體積的比值） specific grav...
  1. We have contrasted several methods on fabrication of passive matrix oled, then we mainly discuss two fabricating methods, one is the precise mask method, the other is the barrier wall method. we find that the barrier wall method to fabricate the passive matrix oled ( pmoled ) has the advantages of high resolution, simple process and no crosstalking problem, so the barrier wall method is the good one to fabricate pmoled. in this paper we adopt the both methods, and we have successfully fabricated the pmoled

    分析和對比了實現無源矩陣有機電致發光顯示器件的幾種方法，著重介紹了採用精密掩模技術和障壁技術等技術方案，來製作和設計無源矩陣有機電致發光顯示器件，其中採用障壁技術方案製作的器件具有解析度高、工藝簡單容易實現、器件的交叉效應少、成本低等許多優點，是一種可行的製作無源矩陣有機電致發光顯示器件的方案。
  2. Present methods generally based on the statistics of earthquake damage, expert experiences, theory analysis and experimental researches have obvious advantages, disadvantages and certain scopes of application ; ( 2 ) different prediction methods should be adopted against different building conditions, sites, intensity and experiences etc to predict earthquake damage of buildings for prospective accuracy, dependability and availability ; ( 3 ) earthquake damage matrix, which is the foundation of earthquake damage prediction, of 7 kinds of building in the urban areas of zhangzhou city under intensity 6 to 9 has been set up. the damage conditions of different buildings under different intensity are as followings : all kinds of structures are basically intact under intensity 6 ; the reinforced concrete structures are basically intact under intensity 7, but other kinds of structures are destroyed slightly ; the reinforced concrete structures are still basically intact while other kinds of structures are destroyed intermediately under intensity 8 ; the reinforced concrete structures are destroyed slightly, single - story factories and open houses are destroyed intermediately and other kinds of structures are destroyed seriously under intensity 9 ; ( 4 ) the results of earthquake damage predicting of buildings embody the damage when earthquake happens in the future. thus, further identifications and reinforcements should be considered to buildings that will be destroyed intermediately or more under the earthquake with 10 % exceeding probability in future 50 years ; ( 5 ) the direct economic losses caused by damage of buildings resting with the area, structural type, intensity and damage of all kinds of buildings are the main part of the losses of the city in an earthquake ; ( 6 ) the direct economic losses increased progressively toward high intensity by 2 or 3 times

    基於上述研究，得出的主要結論有：建築物震害預測是一個模糊的、系統的、復雜的問題，現有的方法很多一般都是以震害統計規律、專家經驗、理論分析和試驗研究為依據，有其自身的優缺點和一定的適用范圍；應針對不同的建築物條件、場地條件、地震強度和已有經驗等，採用不同的預測方法進行建築物震害預測，以使預測結果達到預期的精確性、可靠性和可操作性；建立了漳州市區7類建築物在6度9度地震作用下的震害矩陣，成為指導抗震防災的重要依據，各類結構的震害情況表現為： 6度地震作用下各類建築物基本完好； 7度地震作用下除鋼筋混凝土結構基本完好外其餘以建築輕微破壞為主； 8度地震作用下鋼筋混凝土結構仍以基本完好為主而其餘建築以中等破壞為主； 9度地震作用下鋼筋混凝土結構以輕微破壞為主，單層工業廠房和空曠房屋以中等破壞為主，其餘建築以嚴重破壞為主；建築物的震害預測結果體現了未來地震來臨時的震害程度，在編制漳州市區抗震防災規劃時，對于遭遇50年超越概率10的地震影響發生中等以上破壞的建築物應考慮進行抗震鑒定和加固；由建築物的破壞所造成的直接經濟損失是城市地震經濟損失的主要部分，重慶大學碩士學位論文中文摘要其主要與建築物總面積、結構類型、地震烈度和各類建築物的震害程度有關;不同烈度造成的直接經濟損失按2一3倍向高烈度方向遞增，漳州市區直接經濟損失由6度至9度的比例關系為1 : 2 . 8 : 8 . 6 : 22 . 8 ;遭遇基本地震設防烈度（ 7度）時，漳州市區直接經濟損失約4 . 5億元，無家可歸人員約40000人，且以磚木結構和多層磚混結構的震害損失最大;地震造成的人員傷亡主要與建築物倒塌及嚴重破壞的程度和總面積以及震時的建築物室內人數密切相關，地震時無家可歸人員主要與住宅倒塌、嚴重破壞及中等破壞的程度和總面積以及城市人均居住面積密切相關。
  3. The development of mass transfer in the system of vapor - liquid - liquid three - phase distillation from trays was introduced, the effects of the hydrodynamic conditions e. g. vapor velocity and ratio of liquid to vapor loading and physical properties of liquid phase, including surface tension, interfacial tension, viscosity or dispersion viscosity, density, relative volatility etc. and the volume ratio of oil to water on mass transfer were discussed systematically, the influence of the second liquid on mass transfer efficiency was also investigated, a gnat deal of viewpoints and suggestions having been put forward in this paper are significant important for optimizing design of distillation tower

    摘要介紹了氣液液三相精餾塔板傳質性能研究的進展情況，討論了氣速、液氣比等操作條件，表面張力、界面張力、液體的粘度或分散粘度、密度和相對揮發度等物系性質以及油水體積比等多種參數對傳質效率的影響，探討了第二液相的存在對傳質的影響，文中的許多觀點獲和建議對于優化精餾塔的設計具有重要的指導意義。
分享友人
分享到 Line

分享到臉書