紊流流體 的英文怎麼說

中文拼音 [wènliúliútǐ]
紊流流體 英文
turbulent fluid
  • 紊 : 形容詞（紊亂） disorderly; confused
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 紊流 : burble
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  1. Spiraling of the liquid as it reaches the rotor may affect the accuracy of the turbine meters.

    當液體接近轉子時發生紊流可以影響渦輪式流量計的精確度。
  2. Two - fluid large eddy turbulence model is applied to research the movement of the sand clouds in quiescent water

    摘要本文採用雙流體大渦紊流模型對靜水中泥沙雲團下落過程進行了研究。
  3. Finite volume method is appilied in numerical modeling of the flow in no - pressure tunnel of high water reservoir in this paper. i select standard k - turbulence modeling that put forward by launder and spalding in 1972 by weighted poly - turbulence modeling. the difficulty is that there is free surface in flow, but free surface problem ' s calculating region is indefinitely

    本文利用有限體積法對高水頭下水庫無壓泄水洞水流進行了紊流數值模擬，根據多種紊流模型的優缺點進行比較，選擇了launder和spalding於1972年提出的標準的k ?紊流模型。
  4. It adopts reynolds time - average n - s equation and k - ? turbulence model to calculate the inner 3 - d viscid turbulence flow of centrifugal pump. in the unstructured grid, the governing equations are discretized with finite volume method based on finite element method. then the pressure correction method is used to carry out numerical calculation

    而後採用基於雷諾時均n - s方程與標準-湍流模型來求解離心泵葉輪內三維粘性紊流，在非結構化網格中，採用基於有限元的有限體積法對方程進行離散，用壓力校正法進行數值求解。
  5. The research object of this thesis is a chip - array that is fixed on one of printed circuit boards ( pcb ), which are located in a forced air field ( forced convection ) in an electronic case ; and from the essential equations of airflow we can deduce the mathematical model of the turbulent flow ; then we can establish the finite element algorithm and apply the fe software to work out the equations of turbulent flow, finally we can use the software to display and analyse the field of flow and temperature

    本文以處于強迫空氣對流流場中的某pcb板及其板上的電子元件陣列作為研究對象，推導了紊流流場的數學模型，並建立了相應的有限元求解格式，應用有限元法分析軟體對該系統的紊流流場和溫度場進行了模擬分析：解算出pcb板上各電子元件的溫度分佈；並提出了用於求解系統風道特性曲線的cfd方法。
  6. By performing fourier transformation, the relationship between the turbulent intensity of the particle and that of the carrier fluid was obtained which makes clear that particle size, specific gravity, velocity gradient, and the characteristic frequency of energy - containing eddies are four basic influencing parameters. it is proven theoretically that under certain conditions, the stream - wise and transverse particle turbulent intensities exceed those of the carrier fluid. based on the equations of two - phase flow, the presence of fine sediment suspension is shown to attenuate the turbulent intensity of the water

    通過對細小顆粒在剪切流場中運動方程的fourier分析，得到了顆粒脈動強度和流體脈動強度之間的定量關系，表明顆粒粒徑、顆粒密度、流速梯度以及紊動場含能旋渦的特徵頻率是影響顆粒脈動強度的主要因素，首次從理論上證明了在一定條件下，顆粒在縱、垂向的脈動強度均會超過相應的流體脈動強度，為已有的實測資料提供了合理的解釋。
  7. Based these researches acquired and using a mathmatical model, this thesis tries to research the contaminant concentration distributions of three - dimention indoor turbulent flow by means of computational fluid dynamics and heat transfer, and then works out the ventilation efficiency

    本文企圖在前人的基礎上，通過建立相應的數學模型，用流體流動數值計算方法來模擬室內三維的紊態氣流中的污染物濃度分佈，進而分析計算室內的通風效率，得出通風效率較好的室內氣流組織形式。
  8. In arbitrary curvilinear coordinates, the wall function is used for treating near wall regions. the influences of two different inlet gas parameter distributions and turbulent combustion models, as well as three different afterburners on turbulent combustion flow fields and wall temperature profiles are calculated. comparisons of experiment results and calculations results show that second - moment combustion model is reasonable for modeling turbulent reacting flows, inlet gas parameter distributions is more important. calculation method is reliable and can be used for the optimum design of afterburner

    數值研究三種不同幾何形狀、兩種進口氣流參數分佈、兩種紊流燃燒模型等對加力室內各氣流參數、隔熱屏和加力室筒體壁面溫度分佈的影響，計算結果與試驗數據比較表明:不同幾何形狀加力室對加力室內紊流燃燒流場的影響要比進口氣流參數分佈大些，正確給定進口氣流參數分佈較為重要，二階矩紊流燃燒模型更適用摸擬三維紊流燃燒流動，計算方法合理，編制的計算程序可靠，可供加力燃燒室優化設計用。
  9. The - two - equation turbulence model and the control - volume integration method and simplest algorithm were employed to simulate the three dimensional, isothermal, incompressible, rectangular two - impinging - jet on a flat plate

    本文採用-紊流模式，使用控制體積積分之有限差分法及simplest計算程序，進行三維、恆溫、不可壓縮、矩形雙噴射撞擊流場之數值模擬。
  10. Secondly, the relation between nusselt number and the local time - averaged velocity and temperature fields of turbulent convection was theoretically induced, which expands the field - coordinated enhancement principle to turbulent convective heat transfer

    然後，在理論上導出了紊流對流換熱的整體換熱性能與局域時均速度場和時均溫度場的一般關系式，將對流換熱的場協同強化原則擴展至湍流換熱。
  11. In the turbulent flow, the fluid ’ s physical parameters has the stochastic change along with the time and the space, it is very difficult to carries on its rate process ’ s precise computation and the simulation with mathematics method, but unstable condition navier - stokes equation regarding open canal current of water transient motion suitable

    閘后水流經過加糙的海漫段時，其水流狀態屬明渠紊流。流體中的各種物理參數，都隨時間與空間發生隨機的變化，很難用數學的方法對其運動過程進行精確計算和模擬。
  12. The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments

    對歧管式單通道熱沉流動特性的研究結果表明，微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外，選用十二烷基硫酸鈉（ sodiumdodecylsulphate ， sds ）以及烷基多糖苷（ alkylpolyglycoside ， apg ）作為減阻添加劑，研究了表面活性劑添加對微通道流動特性的影響。
  13. The growth rate of inflectional instability and viscous instability also saturate similarly to the primary and nonlinearly generated disturbances. the main effect of inflectional instability mode in the final breakdown seems to interact with the disturbances having developed and thus widens the frequency spectrum to turbulent state

    屬于拐點不穩定性的高頻二次不穩定模態對最後轉捩的影響主要體現在與其它擾動的相互作用，並導致出現紊流狀態寬帶頻譜。
  14. With the phenomena of dropping flow, backflow and secondary flow effected by circulation and surface curvature, the centrifugal pump ' s inner flow is very complicated 3d flow. therefore, the centrifugal pump inner flow is one of the difficult problems both in testing research and numeric computation

    離心泵葉輪的內部流動是很復雜的三維紊流流動，同時由於受旋轉和葉片表面曲率的影響還拌有脫流、迴流及二次流的現象，是流體工程中較難的試驗研究和數值計算問題之一。
  15. Topics include the principles of conservation of mass, momentum and energy ; hydrostatic behavior of floating and submerged bodies ; lift and drag forces ; dimensional anaylsis ; wave forces on ships and offshore platforms ; laminar and turbulent flows

    主題涵蓋質量守恆、動量守恆及能量守恆等原理、浮體及沈體之流體靜力行為、升力、拖曳力、因次分析、船舶及離岸平臺上作用的波力、層流及紊流。
  16. For dilute solid - liquid two - phase flow, the mechanism of particle motion driven by fluid is the main subject, especially the particle motion in the near wall region. the bursting phenomenon and coherent structure of turbulence play an important role on the motion of particles in the near wall region

    明槽紊流近壁區的顆粒運動與紊動猝發現象及紊流相干結構有著密切的關系，開展近壁區顆粒與紊流相互作用的機理研究對于流體力學和泥沙運動力學都有著重要的理論意義和實際價值。
  17. It uses the software of phoenics, imitating stratified air distribution of three - dimension turbulence in large space at many kinds of working at in k e pe in bo at arch wi m for ndds cut ords ed as pe of air ~ for wt pe of - w op of ~ nd we ch de ^ t wt the pe pe the pe ed co the bo of mp nd - - ds the for for the nd ~ or ~ for ds in tw pe bo inedwh edfor bo an all chwt to gr - - rpwhthe ~ oftw -, so ihat it co ha the ed ofds be all ghthemeedch

    使用phoenics軟體，對多種工況下高大廠房大空間分層氣流組織進行三維紊流模擬。主要研究了高大廠房內的水平隔斷氣流，分析送風噴口類型、送排風口位置、障礙物高度、地面干擾氣流等因素對隔斷氣流的影響。在經濟性和實用性上得到最優化的結果，為大空間變動塵源復雜氣流的優化組織研究提供了參考。
  18. By analyzing flow status of fluid in aerating pipeline, giving up hydraulics and utilizing hydromechanics and advance numerical calculations, the prediction method to solve optimizations height on flow status in aerating pipeline is studied and put forward, which provides a scientific theory base to realize effective drag reduction and economic principle in blend phase transportation for pipeline design

    摘要通過分析摻入少量高粘流體形成分層紊流層流的流動狀態，拋棄傳統的水力學研究方法，應用流體力學原理、高級程序設計語言和先進的數值計算技術研究了摻入少量高粘流體分層紊流層流減阻規律，為實現管道混相輸送時高效減阻和經濟節約的設計提供理論依據。
  19. The extent of attenuation is proportional to the parameter under some assumptions in open channel flow. the lack of a sound theoretical basis for predicting the behavior of coarse particles means that experiments play a critical role

    在明渠二維恆定均勻流條件下，經過適當簡化和假定得到的結果表明，懸移質運動起到減弱流體紊動強度的作用，制紊作用隨參數的加大而增強。
  20. Abstract : based on the turbulent flow kinetics theory the paper describes astudy on two - region flocculation model, the turbulent region is the dominant effect of fiocculation speed, the transition region is the dominant effect of scale and compactness of floculating body, and the order magnitude of available energy disipation and controlling index is put forward

    文摘:應用紊流動力學原理，分析紊流條件下兩區絮凝模型，提出紊流區主導絮凝速率，過渡區主導絮凝體的成長尺度及密實度，導出了有效能耗的量級及絮凝控制指標。
分享友人
分享到 Line

分享到臉書