終點誤差 的英文怎麼說

中文拼音 [zhōngdiǎnwùchā]
終點誤差 英文
end point error
  • 終 : Ⅰ名詞1 （最後; 末了） end; ending; finish 2 （指人死） death; end 3 （姓氏） a surname Ⅱ形容詞（...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 終點 : 1 （一段路程結束的地方） terminal point; finishing point; destination 2 [體育] finish; 終點裁判員...
  • 誤差 : error
  1. Complexation retitrate end point error margin probe into

    絡合返滴定終點誤差探討
  2. Aiming at the difficulty of the titer measurement and ending judgment, the dissertation brings forward the resolution project and presents the collectivity design

    針對滴定法中滴定劑耗用量測量與終點判斷容易產生較大誤差這一問題，提出了解決方案，給出了濃度測定儀的總體設計方案。
  3. Among the adaptive beam - forming algorithms, the least mean square algorithm is widely used because it has a simple configuration and it is apt to come true and have nice convergence. on the other hand, it has a disadvantage that it converges slowly and there is a conflict between the fixed step and the convergence pace or the error in stabilization. so people have developed many improved least mean square algorithms which generally start from convergence, stabilization, misadjustment, and robustness and come to a formula about variational step in the end

    在自適應波束形成演算法中，最小均方（ lms ）演算法因結構簡單，易於實現，能穩定收斂而得到廣泛應用，但它也存在收斂速度受限的缺點：固定步長因子無法解決收斂速度和穩態誤差之間的矛盾。因此，人們提出了各種改進的最小均法演算法來解決這一問題。改進的最小均方演算法通常從如何改進收斂速度、穩態誤差、失調量和魯棒性等指標上出發，最後在新演算法最終表達式中的步長公式上變化。
  4. After the comparison of the merits and faults between fourier spectrum analysis method and wavelet - neural network analysis method, the latter is selected. after the research on the principle of accuracy - loss diagnosis of the dynamic measurement, the diagnosis theory and method are advanced. according to the error model established of the dynamic system and the results of the error tracing, using bp neural network, the accuracy - loss law of each inner unit is acknowledged

    對于實際進行誤差分解與溯源的信號處理方法，在比較了譜分析方法與小波神經網路分析方法的優缺點之後，指出譜分析方法的分解結果不夠理想，並最終確定用小波神經網路來進行實際測量系統的誤差分解與溯源。
  5. The error spreading and improving of auto - control terminal point of anti - ship missiles

    反艦導彈自控終點誤差散布及其改進
  6. Feedrate planning of continuous micro - line ' s start and end points are discussed, and the constraining conditions, including the machine ' s acceleration and deceleration capability, allowable error of corner machining, maximum acceleration and dynamical behavior of the machine, are established 。

    摘要針對連續小直線段高速高精插補演算法中起始點和終止點的速度規劃，建立了包含機床加減速性能、轉接處誤差控制、最大加速度以及機床負載功率等的速度約束條件。
  7. And use relative fitting error to measure statistical data non - uniform error ; then introduce the method systematically of using the fuzzy comprehensive evaluation method to carry on the overall superior test of the government statistical data quality. includes the establishment of step level appraisal target system, target weight determination, calculates the factor weight in various levels, uniform test of judgment matrix, and built up the final fuzzy comprehensive evaluation model of the government statistical data quality according to the above - mentioned standard ; finally selects the partial main social economy total quantity target from chinese statistics yearbook 2003 to carry on the real diagnosis analysis : ( 1 ) confirm these social economy total quantity targets using the description statistics and the k - s inspection method to obey the lognormal normal distribution. ( 2 ) according to the two levels of inspection methods which this article proposed to carry on accuracy and the overall superior test for these social economy total quantity targets

    本文首先從統計數據及質量的涵義出發，全面系統的介紹了統計數據質量的概念;其次，從研究統計數據的分佈規律入手，對統計數據準確性檢驗問題進行了探討，利用對數正態分佈檢驗對反映研究對象規模大小的統計數據的質量及異常數據進行定量檢查和識別，並利用相對擬合誤差計量統計數據的非一致性誤差;接著系統介紹了利用模糊綜合評價方法對政府統計數據質量進行整體優度檢驗的思路，具體包括建立遞階層次的評價指標體系，指標權重的確定，計算各層次中因素的權重，判斷矩陣的一致性檢驗，並根據上述標準建立了最終的政府統計數據質量模糊綜合評價模型;然後通過從2003年中國統計年鑒資料中選取部分主要的社會經濟總量指標進行實證分析: （ 1 ）利用描述統計和k - s檢驗法來驗證這些社會經濟總量指標服從對數正態分佈的規律; （ 2 ）按照本文提出的二級檢驗法來對這些社會經濟總量指標進行準確性和整體優度檢驗，從而達到綜合評價政府統計數據質量的目的;最後對這種二級檢驗法的優點和不足進行小結，提出今後應該努力改進的方向。
  8. According to the design theory of the cable - stayed bridge and to the feature of the cantilever construction the authors propose a construction control method called optimum completion state method ( ocsm ) for rc cable - stayed bridges in the proposed method, the optimum completion state is regarded as the final target of the construction control, and the optimum construction state at each construction stage is taken as the technical route the key of the method is to properly choose or adjust the cable forces the objectives function of optimization is to minimize the elevation error of the girder under the constraint condition that the internal forces ( bending moments ) of the girder are bounded the optimization variables are the cable forces on the basis of the above principles, a optimum model for a construction step is established and cable force adjustments can be found for each construction step in this model, the creep and shrinkage effects of concrete have been considered a bridge example is given which shows that the final state of the bridge is very close to the design aim and that this method is much better than the so - called double - control method the example is a good illustration of the soundness and practical value of the proposed method

    根據現代斜拉橋結構設計理論和懸臂施工方法的特點，提出了以最佳成橋狀態作為施工控制的最終目標，以實施最佳施工階段為技術路線，以索力調整為核心內容的斜拉橋施工控制理論，簡稱為最佳成橋狀態法；以斜拉橋主梁標高誤差最小為目標函數，以主梁內力（彎矩）為約束條件，以索力為優化變量，建立了最佳施工階段的索力調整計算模型；推導了考慮徐變收縮效應的索力調整計算公式；用最佳成橋狀態法對一實橋工程進行了施工控制全過程計算研究，得到的成橋狀態與設計目標相當接近，優于該橋以「雙控」為控制目標的實測結果，有力地證明了本文方法的正確性及其工程實際價值
  9. Sample error probably caused from data collection circuit of rf virtual frequency spectrum analyzer instrument was emphasized, and some kinds of selectable resolution scheme were presented, then these schemes of advantages and disadvantages were compared and summarized by the way of theory analyse, matlab simulation and practice validate and so on, at last, the optimum scheme of rf virtual frequency analyzer instrument was decided and adopted

    重點對虛擬射頻頻譜分析儀中的數據採集電路可能造成的采樣誤差進行了分析，提出了幾種可供選擇的解決方案，經過理論分析、 matlab模擬和實際驗證等手段，對這幾種方案的優缺點進行了比較和總結，並最終確定了其中最適合虛擬射頻頻譜分析儀的方案。
  10. The main process of the method is : after the converged solution for a certain layer of grid is obtained, all elements that are required to be refined based on error analysis are automatically found and output. as the distribution of the elements to be refined is often discrete and irregular, regular square blocks consisting of elements to be refined need to be manually built and input to the computer. the computation for the refined layer grid is then carried out and the procedure is repeated until the final convergence criterion is satisfied

    該方法的特點是：當某一層次網格取得收斂解后，程序根據誤差分析自動判別並輸出該層次網格內需加密的單元，由於需加密單元的分佈一般較為離散和不規則，因此通過人工介入對這些單元進行組塊並輸入到計算機，程序便開始進行下一層次網格的迭代計算，直至得到滿足最終收斂判據的解。
  11. The first step is the spatial coordinate conversion, which converts the measurement data from the measurement coordinate system to the theoretical coordinate system. the next step is to work out the systematic distortion errors of the antenna surface. the last step is to found the antenna surface model based upon neural network, then we can get random errors of the measurement data and take the mse ( mean square errors ) as the standard errors of the random errors by statistical method

    本論文的數據處理過程主要包括：一，實現測量數據的坐標轉換，將測量數據從測量坐標系轉換到設計坐標系；二，求出天線面的變形系統誤差；三，建立基於神經網路的天線面模型，求出各點的隨機誤差值，用統計的方法取其均方根作為標準偏差，並最終求得天線面的型面誤差值。
  12. This controller is designed to stabilize angle error, front error and side error separately based on the kinematic model of the rover. the simulation results show the lunar rover can be stabilized to expected point by our proposed method

    以月球車的運動學模型為控制對象，分段鎮定月球車的方向角、前向誤差和側向誤差，最終使月球車鎮定到坐標原點。
  13. Next, the paper summarizes the principles to get the main parts of the chinese sentences according to the chinese syntax rules, and analyzes the realization and error - correction mechanisms to identity the contention of the basic sentences. on the bases of the principles and the mechanisms above, this paper brings forward the method to identity the contention of the network information in real time, and also shows a series of functions for the realization of the method

    同時，本文還根據漢語的自然語法規則總結出了句子主幹提取的原理，再進一步解析出漢語基本句型的語義分析及其誤差校正的機制，最終提出了一種對網路信息內容的論點傾向進行實時判別的方法，並且開發出了一套對應的函數庫對該方法加以實現。
  14. Embedded image coding is especially fit for the changeful and fallible environment, such as internet / wireless transmission, image browse etc. the output bit stream of the embedded code can be truncated and reconstruct image for practical applications to achieve varying degrees of scalability and different target bit rates or distortion

    嵌入式編碼可以應用於網路、無線傳輸，圖像瀏覽，特別適合於容易發生誤差的環境。為了滿足目標比特率或者誤差要求，通過監視編碼的一些參數，嵌入式的編碼器可以在任何一點終止編碼。
分享友人
分享到 Line

分享到臉書