結晶爐 的英文怎麼說

中文拼音 [jiējīnglú]
結晶爐 英文
crystal oven
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 結晶 : 1 （析出晶體） crystallize2 （晶體） crystal 3 （成果） crystallization; fruit; product; quintess...
  1. Because of the large stuff of silicon, complex structure of furnace and expensive cost, computer simulation is a best way to optimize design. in order to study the new heat system, we have calculated the heat zone of 200mm solar cell czsi growth

    由於拉晶過程中投料量較大，爐體結構復雜、造價昂貴，所以計算機數值模擬對于優化單晶爐設計是一種重要的工具。本論文用有限元方法對改造后單晶爐的適合的熱場進行了數值模擬。
  2. On account of the solidification character of rare earth alloys, the zone melting is improved by putting the alloys prepared by arc - melting into the quartz tube, then melting

    鑒于稀土化合物凝固結晶的特點，對區熔法進行了改進，將電弧爐熔煉好的樣品裝入石英管中，封石英管后在區熔設備上進行區熔。
  3. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  4. Qualified molten steel from the steelmaking furnace will be contained in ladle and conveyed to continuous caster, poured into crastyllizer through pouring basket, then handled with the processes of vibration, water spraying cooling, straightening, roll conveying, flame cutting, and cooling on cooling bed, finally the formed billets will be stored at the stockyard or directly sent to the heating furnace of rolling mill for heating

    煉鋼爐冶煉出合格的鋼水，用鋼水包送至連鑄機，經中間包澆注到結晶器，再經振動水噴淋冷卻拉矯輥道輸送火焰切割冷床冷卻，最後存放于鋼坯堆放區或直接送至軋鋼機加熱爐進行加熱。
  5. The material of electro - fused magnesia sinter is selected from special grade a natural magnesite or high - purity caustic calcined magnesite, which is fused in arc furnace to finish the products. the products possess high purity, crystal with and compact texture, have high heat - vibration steady and cinder corrosion resistant, it is used for making high quality magnesite bricks, magnesia - carbon bricks

    電熔鎂砂是用精選的特a級天然菱鎂石，在電弧爐中熔融制得，該產品具有純度高，結晶緻密，抗渣性強熱震穩定性好，是製作高檔鎂磚，鎂碳磚及不定形耐火材料的重要原料。
  6. Furthermore, the growth and the study of self - organized quantum dots structures become more and more important recently, and the application of self - organization technique become wider and wider in this thesis, we address the theory of film growth and the growth technique firstly more, the ways and characteristics of surface detection are prescribed we mainly report the growth process, results and discuss of self - organized quantum dots structures in the a12o3 substrates by s - k mode using ecr - mocvd, in the espd - u device the growth art of ain epilayer which is the preliminary foundation of self - organized gan / ain quantum dots structures, including the substrate cleaning, nitridation, the growth of buffer and the growth of gan and ain epilayer, is discussed we deliberately compare the test result of rheed xrd and afm and achieved the optimalized condition of ain at last we have successfully realized the growth of ain which is much smooth and better crystal quality moreover, we grow the self - organized gan / ain quantum dots structure in s - k mode because the limits of the heater temperature, we can not grow the atom - smooth epilayer of ain until now so we could not grow better quantum dots which have small diameter and big density but the self - organized quantum dots structures with better quality will be realized successfully if the substrate temperature is increased the thesis study belong to my tutor subject of national nature science foundation ( 69976008 )

    本論文主要論述了在espd - u裝置上，採用電子迴旋共振等離子體增強mocvd （ ecr - pamocvd ）方法，在藍寶石襯底上通過s - k模式自組裝生長gan aln量子點結構的生長工藝、結果及討論。而重點分析了自組裝生長量子點之前的aln外延層生長工藝，包括襯底清洗、氮化、緩沖層的生長和gan 、 aln外延層的生長；通過高能電子衍射、 x射線衍射和原子力顯微鏡測試，並且對這些測試結果進行了詳細的比較研究，得出了較優化的工藝條件，生長出了晶質較好、表面較平整的aln外延層；進而採用s - k模式自組裝生長了gan aln量子點結構。由於實驗裝置加熱爐溫度的限制，我們沒有能夠生長出原子級平滑的aln外延層表面，因而沒能夠生長出密度比較大和直徑比較小的量子點。
  7. The influence of nano - al2o3 on the sintering and the properties of the si3n4 ceramics was researched in this paper. the samples with different amount of nano - al2o3 were obtained by using pressureless sintering at 1600, 1650, 1700 in the nitrogen atmosphere. the microstructure and the composition of the ceramics were determined by the means of x - ray, sem, micro - hardness meter etc. it is show that the sisty ceramics can be densified at 1650c to % percent of the theory density through the addition of nano - al2o3 ( the value could be 90 percent by other technique ). the crystalline growth of the cylindrical - si3n4 and the ratio of its longitude to its diameter are increased with the addition of nano - al2o3. a uniform microstructure and an fined crystal as well as more sialon phases can be obtained in the si3n4 ceramics through the addition of that

    實驗結果表明：在碳管爐中、氮氣保護下進行燒結，添加劑為納米al _ 2o _ 3粉末時，由於納米粉末的高活性、高燒結驅動力，在1650就可使si _ 3n _ 4完全地燒結，並使其緻密度可達理論密度的96以上（比其它工藝高6左右） ；同時，納米al _ 2o _ 3地加入大大促進了長柱狀? si _ 3n _ 4的生長和發育及柱狀晶長徑比的提高，使微觀結構均勻、細化，形成了更多力學性能優異的固體? sialon相，減少了不利於陶瓷材料性能的晶間玻璃相，凈化了晶界。
  8. A new measuring instrument for melting and crystallizing temperature of smelting slag is designed by adopting advanced microcomputer technology, micro - controller technology, and computer image processing technology in order to accurately and efficiently measure physical features of smelting slag, e. g. melting temperature, flowing temperature, crystallizing temperature, and crystallizing rate, etc

    設計了一種採用先進的微型計算機技術、微控制器技術、計算機圖像處理技術相結合的冶金爐渣熔化結晶溫度測定儀，能夠準確高效地測試冶金爐渣等材料的熔化溫度、流動溫度、結晶溫度、結晶率等物理特性。
  9. The occurrence, mineral composition and constructure of titanium in solidified slags which are obtained from blast furnace slags via selective precipitating and growth have been studied, and the contribution of titanium among different mineral phases has been calculated by optical microscope, x - ray diffraction ( crd ) as well as scanning electron microscope ( sem )

    本文採用光學顯微鏡、 x射線粉晶衍射、圖象分析和掃描電鏡等多種手段，研究了攀鋼含鈦高爐渣經選擇性析出處理的凝渣中鈦的賦存狀態、礦物組成及結構，計算了鈦在各礦物相中的分佈，測定了原料中鈦礦物的解離度，為鈦的綜合利用提供了科學依據。
  10. Abstract : the occurrence, mineral composition and constructure of titanium in solidified slags which are obtained from blast furnace slags via selective precipitating and growth have been studied, and the contribution of titanium among different mineral phases has been calculated by optical microscope, x - ray diffraction ( crd ) as well as scanning electron microscope ( sem )

    文摘:本文採用光學顯微鏡、 x射線粉晶衍射、圖象分析和掃描電鏡等多種手段，研究了攀鋼含鈦高爐渣經選擇性析出處理的凝渣中鈦的賦存狀態、礦物組成及結構，計算了鈦在各礦物相中的分佈，測定了原料中鈦礦物的解離度，為鈦的綜合利用提供了科學依據。
  11. Surface morphology, phase constitution and biocompatibility of the material were analyzed and evaluated in this paper. titanium alloys were prepared by non - consumable vacuum arc smelting furnace. and the microstructures and the properties of titanium alloys were investigated

    採用非自耗真空電弧凝殼爐熔煉鈦及鈦合金，並對鈦合金的組織及性能進行觀察和測定，分析了電弧爐熔煉鈦合金的結晶特點。
  12. The results show that the most titanium occurred in perovskite phase, which could be selectively preciptated and growth by optimizing heat treated condition, and then could be separated by mineral processing

    研究結果表明：爐渣中大部分鈦富集於鈣鈦礦相中；通過改性處理后，可以使鈣鈦礦晶體選擇性析出並長大，進而採用選礦方法將其分離出來，為綜合利用創造條件。
  13. Quart crystal devices and materials, sensors and materials, resistors, potentiometers, capacitors and ti - srseries ceramics powder, high performance electronic ceramic material and parts, industry furnaces, various electric instruments and specific equipment

    主要產品：石英晶體材料和器件，敏感材料和元器件，電阻器，電容器及鈦鍶系統瓷粉，高性能電子陶瓷材料及結構件，工業窯爐，無線電測試儀器和專用設備。
  14. The design parameters of cusp magnetic field in 8 - inch mono - crystal furnace ( 16 - inch crucible ) are obtained via the simulation method, and the validation check is made of the simulation results of parameters of magnetic field

    摘要通過模擬方法得到8英寸單晶爐（ 16英寸坩堝）勾形磁場的設計參數，並對磁場參數的模擬結果進行了實驗驗證。
分享友人
分享到 Line

分享到臉書