絕緣失效 的英文怎麼說

中文拼音 [juéyuánshīxiào]
絕緣失效 英文
insulation failure
  • : Ⅰ動詞(斷絕) cut off; sever Ⅱ形容詞1 (完全沒有了; 窮盡; 凈盡) exhausted; used up; finished 2 ...
  • : Ⅰ名詞1 (緣故) reason 2 (緣分) predestined relationship 3 (邊) edge; fringe; brink Ⅱ動詞(攀...
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • 絕緣 : 1 [電學] (隔斷電流) insulation; isolation; insulate; isolate 2 (跟外界不發生接觸) be cut off ...
  1. This heating helps to break down weak spots in the dielectric that otherwise might pass through the electrode undetected, only to fail during a later spark or hipot test

    這熱量幫助擊穿電線較薄的地方?否則線材通過電極而沒有被檢測到?結果在以後的火花測試和高壓試驗將會
  2. " automatic reset n. c. series connected thermal overload protection, two moisture sensing probes, prelubricated shaft bearings and class f insulation. * efficiencies include all mechanical losses including mechanical seals.

    自動重置n . c .系列,連接過熱保護裝置,兩個潮氣檢測探頭,預潤滑軸承和f級。 *率包括所有機械密封中的機械損
  3. Al2o3 coating is provided not only as insulation layer to decouple electrically the liquid metal flow from the load - carrying wall in the sake of the decisive reduction of pressure drop, but also as a barrier to reduce tritium permeation into structure materials

    為減少液態金屬mhd壓力損,分析液態余屬包層各種相關材料影響因素,在液態金屬流動管道內壁加以al _ 2o _ 3塗層達到電學和熱學性質上的,並起到相當好地氚壁壘果。
  4. Secondly, been generalized the failure data of electrical connectors from working and testing environment, electric contact failure, insulation failure, mechanical connection failure and other failure are four mainly failure modes of connectors, moreover, built the faulty - tree to analyze their reliability level. however, contact fault failure was the most prevalent mode of electrical connectors. under natural working and reserving conditions, the contact stress decreasing, fretting and surface film growing are mainly reasons to make electrical connector failure

    其次,通過對現場、試驗場電連接器的情況進行統計和分析,總結出電連接器的四種主要模式:電接觸絕緣失效、機械連接和其他,並對電連接器進行了故障樹分析,指出電接觸是電連接器的主要形式,而在正常的工作條件下,造成電接觸,即決定電連接器工作壽命的主要原因是氧化膜層的生長、接觸對磨損以及磨損腐蝕物的堆積,而影響氧化膜層的生長、接觸對磨損以及磨損腐蝕物堆積的主要因素是環境振動和溫度應力,為電連接器進行機理分析奠定了基礎。
  5. If there are high voltage cables running anywhere near the data cables, the potential for a fault condition exists as a result of insulation failures or inadvertent contact by an installer

    如果數據電纜附近有高壓電纜經過,在諸如絕緣失效、意外接觸設備,則會存在故障電勢。
  6. Insulation failure voltage : min 1000 v ac

    絕緣失效電壓:最小1000vac
  7. Electrical safety in low voltage distribution systems up to 1000 v a. c. and 1500 v d. c. equipment for testing, measuring or monitoring of protective measures - equipment for insulation fault location in it systems

    不超過1000v交流和1500v直流的低壓配電系統電氣安全性.防護測量用試驗測量或監測設備. it系統絕緣失效定位設備
  8. Electrical safety in low voltage distribution systems up to 1000 v a. c. and 1500 v d. c. - equipment for testing, measuring or monitoring of protective measures - part 9 : equipment for insulation fault location in it systems

    不大於1000v交流和1500v直流的低壓配電系統的電氣安全.防護測量的試驗測量和監測設備.第9部分: it系統中的絕緣失效定位設備
  9. Electrical safety in low voltage distribution systems up to 1 kv a. c. and 1, 5 kv c. c. - equipment for testing, measuring or monitoring of protective measures - part 9 : equipment for insulation fault location in it systems

    最高可達1000 v交流電和1500 v直流電的低壓配電系統的電氣安全性.防護測量的試驗測量或監測設備.第9部分: it系統中絕緣失效定位設備
分享友人