給定值調節器 的英文怎麼說

中文拼音 [gěidìngzhídiàojié]
給定值調節器 英文
set point adjuster
  • : 給Ⅰ動詞1 (送對方某物; 使對方得到) give; grant 2 (用在動詞后 表示交與 付出) pass; pay 3 (叫; ...
  • : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : 節構詞成分。
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. To accept the current signal from high negative voltage circuit, the analog ground is raised to a certain positive voltage, which makes it possible for the signal amplitude to be compressed at the same time of its polarity reversion. a pi control program special for laser gyro current control is brought forward according to the conventional pid control method, in which the control signal is figured out corresponding to the difference between the sample and the reference value by turn of proportion - short step integral - long step integral. and at the end of this paper, a comparison of system performance on different conditions is made and the key elements influencing system performance are educed

    利用集成a / d 、 d / a轉換的新型晶元aduc824 ,實現了電流(電壓)采樣?數據處理?電流控制的閉環控制結構;地電位的抬升解決了a / d轉換對負高壓迴路電流采樣時的輸入范圍匹配問題;控制信號反相的同時進行幅度壓縮,使得輸出調整電壓的解析度提高;根據常規的比例?積分?微分( pid )調模型,針對陀螺系統的特性,出了一種可以滿足系統要求、據采樣偏差大小進行的比例?大步長積分?小步長積分、分層次比例?積分演算法;不同條件下系統穩流性能的對比、分析在論文最後出,並據此找出了決該系統穩流精度的關鍵因素,提出了系統的改進意見。
  2. This paper presents an on - line adjusting method for the contrast degree of lcd with touch panel by using the digital potentiometer. the structure of the syatem is also presented

    摘要根據液晶顯示屏配用觸摸屏的情況,提出一種基於觸摸屏的用於液晶屏對比度調的數字電位電阻的在線確方法,並出軟硬體實現原理和運行結果。
  3. Based on the analysis and comparison of the peak current - injection mode and average current mode control strategies, the method of designing average current control mode pi regulator is obtained. the digital simulation of the converter has been done with the help of matlab software. the good transient and stable character of the converter is attained while rated load

    在分析與比較峰電流模式與平均電流模式控制策略的基礎上,出平均電流模式pi調的設計方法,利用matlab軟體對變換進行了數字模擬,證實了變換在額功率范圍內動、靜態特性良好;過載情況下變換具有自動限流、保護主功率件的特性。
分享友人