線間距離 的英文怎麼說

中文拼音 [xiànjiān]
線間距離 英文
distance between conductors
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • : 間Ⅰ名詞1 (中間) between; among 2 (一定的空間或時間里) with a definite time or space 3 (一間...
  • : Ⅰ名詞1 (距離) distance 2 (雄雞、雉等的腿的後面突出像腳趾的部分) spur (of a cock etc )Ⅱ動詞...
  • : Ⅰ動詞1 (離開) leave; part from; be away from; separate 2 (背離) go against 3 (缺少) dispens...
  • 距離 : 1 (相隔的長度) distance; range; gap; space; spacing; separation 2 (相距) be apart from; be aw...
  1. Charted with them, and guangzhou time units was preliminarily analyzed as well. secondly, the author introduced the way and the signification of temporal position analyse with examples. thirdly, taking on - the - spot survey method as a practical tool, the author obtained data of temporal distance between each time unit at the verge of different urban districts and the central time unit of the city

    論文以廣州市為實證研究的對象,對廣州的市區范圍進行了時單元的劃分並繪制出了時單元圖,同時對廣州的時單元滿意率進行了簡單的分析;接著以實例介紹了時區位分析的方法和意義;然後利用實際測量法,在不同時段測得廣州市時中心到城建連片區各邊界點的時,繪制出時,得出廣州市城建連片區的時形態現狀及時形態的日變化規律。
  2. A new damping estimation method, the secant line method, was presented, that is based on the distance of neighbor peaks and valley of oscillation

    摘要提出利用相鄰波峰和波谷之估計阻尼比的割方法。
  3. Lie as a result of ground floor first floor, summer calm, wintry day does not have sunshine illuminate all things, this is the main trouble when living, but, if your house door or window direction are consistent, source of form become a common practice is linear convection, wear a room and pass, or be apart from between the building and did not hold back in relief illumination to enter etc, remain preferred requirement so

    由於底層處在一樓,夏日無風,冬日無陽光普照,這是居住時的主要煩惱,但是,假如你的房屋門或窗方向一致,形成風源直對流,穿房而過,或建築並沒有阻擋陽光照入等,這樣仍然是擇優的條件。
  4. Based on the study of the fore going ' s, this thesis regards time - cell, time - center and time - distance as the basic elements of urban time structure. secondly, carry out three constructing principles - - " spatial scale " maps " time distance ", maintain basic spatial structures, extrude main time structures. thirdly, summarize four expressing forms of urban time structure of which isotime curve, isotime circle, time contour and time network

    理論探討部分基於前人的研究成果初步確定時單元/時細胞、時中心/時基點和時為城市時結構的基本組成要素;提出時結構構築的三原則: 「空尺度」映射「時」 、維持空關系之基本格局、突出表達主幹時關系;時結構的表達則從時結構的形態方面總結出等時、等時圈、時圖和網路圖等表達形式;最後提出城市時譜概念來評價城市時結構的優劣。
  5. The algorithm can be applied to connection routing in pcbs with various pad geometry and pad sizes, with different wire widths and variable distances between wires. the basic element in routing is the search line with a given destination. the main features of the router are the target orientation of the search lines, the routing efficiency is guaranteed by rationally designed data structures and by the ability of searching around obstacles, the small amount of working storage and the reasonably short routing time

    該布演算法適用於焊盤外形尺寸不一,寬及線間距離可變的印刷電路板布,其基本要素是帶有預定終點的探索,特點是探索具有目標針對性,設計合理的數據結構及靈活的繞障探索方式可大大提高搜索效率,所需存儲量小,布速度快。
  6. The distance between parallel cables is at least 0. 2 m.

    兩根平行的傳爆線間距離不小於02米。
  7. With the mathematic model of tracking beam current by velocity, real - time tracking can be obtained ; with current simulation controlling transducer and subsection linearity, precision of velocity ( error in ? 1 % ) is triumphantly can be controlled ; with inspection of the pulse numbers of switches, the position of all vehicles are checked to eliminate the error of calculating distance between all ones

    通過建立速度跟蹤束流的數學模型,較好地解決了速度跟蹤束流的實時性問題;通過採取用電流模擬量控制變頻器和分段性處理的辦法,成功地解決了速度精度問題(誤差在士1 %內) ;通過檢測接近開關觸發的脈沖數,適時校核所有小車位置,消除各車之計算誤差,從而很好地解決了累計計算誤差。
  8. Among railway line ' s plane design parameter, the minimum radius of curve, transition curve ' s type and length, straight line between two curves, centre - to - centre distance of track are key factors which confine railway to bringing up speed, moreover these factors among maglev railway request even more strict

    由於高速磁懸浮鐵路採用了非接觸式的行車技術,舒適性將得到很好的改善。鐵路路平面設計參數中,最小曲半徑、緩和曲長度、夾直長度、線間距離是限制列車速度的關鍵因素,高速磁浮鐵路同樣如此。
  9. ( the force between two point charges at rest is directly proportional to the product of the charges and inversely proportional to the square of the distance between them

    在真空中,兩個靜止的點電荷之的相互作用力的大小與兩電荷所帶電量的乘積成正比,與它們之的平方成反比,作用力的方向沿兩電荷的連
  10. Secondly we use canny arithmetic operators to get the edge of image, and remove the short link of edge then link the edge with small clearance. at last we can calculate the distance of conductor and the width of conductor according to the grade direction to detect of defect of the circuit boards

    然後選用canny運算元提取導邊緣,並對邊緣進行短分支去除和邊緣連接處理,最後根據梯度方向來計算導線間距離和導體寬度,以此來判斷電路板缺陷。
  11. So it is very important to investigate the inverse time characteristic of microprocessor distance protection. this paper emulates all kinds of faults of transmission lines by using emtp, and gets relative current and voltage sample values. then many distance protection thoughts and algorithms are adopted to compare each inverse time characteristic, better arithmetic and set thoughts are got

    本論文應用emtp進行輸電路各種故障情況的模擬,采樣取得保護相關的電壓、電流數據;採用各種保護思想、演算法,採用c語言進行計算,比較各自的時限特性,得出反時限特性比較好的演算法及其整定思路;對于各種故障情況,應用相關整定思路進行計算,得出各種原理的時特性。
  12. The author ? major contributions are as follows. 1. with the performance requirement ( the pattern of the antenna, the rang of scanning angle, the maximal sidelcbe level and the beam ~ vidth ) givcn, a method is presented to determine the basic parameters of a serpentine feed, which includes the distance and ~ vaveguide length bet ~ veeii t ~ vo couplers, the size of the arrays and the number of components

    根據天的工作頻帶、掃描范圍、副瓣電平、半功率寬度等技術指標要求,給出了確定波導慢波基本結構尺寸的計算公式,即對相鄰單元之的空、耦合器之的饋波導長度、陣列的大小和單元數的計算。
  13. Primarily there are two aspects : 1 ) the calculation model of the value of land classifying units - - model of time distance attenuation. in the calculation model of the value of land classifying units, author brings forward the model of time distance attenuation. in this model adopting the network analysis, and by establishing the road network, and proceeding path analysis, computing the time distance, then proceed the exponential attenuation or straight line attenuation on time distance, get the value of influence factor of the land classification unit

    主要有兩個方面: 1 、定級單元分值計算模型? ?時衰減模型在定級單元分值的求取模塊中,提出了時衰減模型,模型中採用網路分析的方法,通過建立道路網路,進行路徑分析,求取時,進而按時進行指數衰減或直衰減,得到定級單元因素因子影響分值。
  14. The feasibility of taking the gamma ray spectrum as a fingerprint of nuclear warhead is studied. the range of the gamma ray fingerprint could be applied to and the conditions under which it

    我們研究了射譜作彈頭指紋以判別彈頭類型的可行性、適用范圍以及對探測時的要求。
  15. The distance between parallel cables is at least 0. 2 m

    兩根平行的傳爆線間距離不小於0 2米。
  16. The distance measurement can be divided into linear or curvilinear distance measurement and 3 - d depth measurement

    兩點測量又可分為空任意兩點直、曲的測量和三維空的深度測量。
  17. Sensors with wider distance between electrode tracks exhibit improved stability in aging process

    而增加電極中心線間距離可提高元件的耐老化性能。
  18. A formula for distance between two un - co - planestraight lines in 3 - dimensional space

    二異面直線間距離的一個公式
  19. Secondly, combining practical survey method and time - resistance mathematic model, the author obtained average time distance from every time - cell to fictitious time center, isotime curve figure ( by arc view 3d analyze ) and temporal shape

    然後利用實際測量法和理論公式法計算出深圳特區各時單元的平均時,並用arcview中的3d分析模塊自動生成等時圖。
  20. Based on the analysis and conclusion of the existed methods of pcb defect inspection and widely gathered data, the author put forward a solution, in which two parameters - the distance of conductors and the width of conductor can be used to detect the defect of pcb

    我們進行了廣泛的資料收集,對已有的印刷電路板檢測方法進行了分析、歸納的的基礎上,提出以導線間距離和導體寬度為為特徵參數來檢測印刷電路板缺陷的方法。
分享友人