緩沖輸出區 的英文怎麼說

中文拼音 [huǎnchōngshūchūqū]
緩沖輸出區 英文
buffered output area
  • 緩 : Ⅰ形容詞1 （遲; 慢） slow; unhurried 2 （緩和; 不緊張） not tense; relaxed Ⅱ動詞1 （延緩; 推遲） d...
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 區 : 區名詞（姓氏） a surname
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. The ins and outs of merlin s new i o buffers

    Merlin的新i / o緩沖區的輸入和輸出
  2. In the proposed method, the controller takes the buffer length as congestion indication, takes sources quality and bandwidth utility as object function so as to learn on line. as the controller outputs, the coding rate for input traffic sources and the corresponding user percentage are used to adjust the cells " arrival rate to the multiplexer buffer. compared with the previous method where cells " arrival rate is tuned only by the encoding rate and the encoding rates for all input traffic sources are regulated in a body, the proposed method guarantee that the quality of cells are optimal while cell loss rate is minimized, which means quality of service is guaranteed

    在該方法中，擁塞控制器以緩沖區大小信元作為擁塞指示，以信源質量和帶寬利用率作為目標函數進行在線學習，控制器輸出包括信源編碼率及其對應的用戶數在全部用戶中所佔的百分比，即根據信源編碼率及對應的用戶百分數調整信源輸入流，從而克服了以往擁塞控制方法中僅僅調整編碼率帶來的對所有信源進行整體調整的缺陷，使控制系統在信元損失率最小情況下確保信源輸入流質量最高，從而有效地利用了網路帶寬。
  3. We use a colorful noise to describe traffic flow and regard it as the uncontrolled input ( equaled to noise ). then we use the multi - rate sampling pi controller to eliminate the error caused by noise, and make the length of queue stabilize at the threshold. the availability of the strategies and stability of systems are proved by doing some analysis and simulation

    文中我們將一有色噪聲看作不可控輸入的擾動，採用基於pi的多采樣速率控制器以消除由此不可控輸入所造成的對系統輸出（交換節點緩沖區隊列長度）誤差的影響，使得系統輸出（隊列長度）穩定在閾值附近。
  4. If a parity error occurs on the trailing byte of a stream, an extra byte will be added to the input buffer with a value of 126

    如果在流的尾位元組上出現奇偶校驗錯誤，將向輸入緩沖區添加一個值為126的額外位元組。
  5. Before the connectting between moden and other equipments, it works at the cammand mode, the cammand that is send to moden is used to set or manipulate the mode, after the connectting between moden and other equipments, it works at connectting mode, at that time, the cammand send from the computer is send to another computer which will pass the moden and telephone line. the moden control cammand is called " at " cammand, all the control manipulation is realized by sending the ascii character to moden, after the moden received the " at " cammand, it firstly judges the cammand, secondly, it analyses and executes the cammand, finnally, it executes a response by sending back a ascii character, during the deseign of below - computer, we introduce in detail the deseign of system hardware and system software, below - computer system hardware and system software, below - computer is made up of microchip collecting and controlling system, which finish the strobe and water level data collection, display and disposal, deal with the communication with the above - computer, the microchip is the centre of data dealing with, the peripheral equipments are made up of data collecttion module, control cammand input module, display module, execute output module, and long - distance communication module

    在moden控制軟體的設計中，詳細敘述了moden正常工作時的幾個重要函數：初始化函數、撥號處理函數、應答處理函數、掛機處理函數，設計並調試了四個函數的通信程序，數據機工作時存在兩種模式，命令模式與連線模式，命令模式是針對功能設置的模式，連線模式是數據傳輸的模式。當數據機未與其他設備連接時，其處于命令模式，這時候下達給數據機的指令是作為數據機本身設置或操作用的；當數據機已經與其他設備連接時，其處于連線模式，所有在此時由計算機送至數據機的信息都將經由電話線傳送到另一部計算機上。專門使用於控制數據機的指令集被稱為「 at指令集」 ，對moden的所有操作（如撥號、應答、掛機等）都可以通過給moden發送ascii字元串來實現， moden在收到at命令后，先對命令進行判斷，接著分析和執行命令緩沖區中的命令，最後以自身的ascii字元對命令作出響應。
  6. Clears all content output from the buffer stream

    清除緩沖區流中的所有內容輸出。
  7. Subsequently, taking into consideration the characteristics of audio data over internet including delay, jitter, packet loss and etc., we propose a series of methods for solving this above problems, such as pre - storage technology, buffer technology, dynamic adjustment of the voice - coding rate to the state of network and integrated media synchronization playing mechanism, and etc. in the end, simulation on 10 / 100m lan is made using the above methods, and the result of the experiment demonstrates the method has good performance and can improve the quality of the audio data transmission

    其次本文還深入研究了語音數據在非實時的internet數據網上的傳輸特性，這些特性包括延時、延時抖動、數據包丟失等。在本文的設計方案中提出了針對這些問題的解決方法，包括預取機制、設置緩沖區技術、動態速率調節技術以及媒體綜合同步播放機制等。最後採用這些方法在10 100m局域網上做了模擬實驗，實驗結果表明本文提出的方法是有效的，在網路狀況惡劣的情況下能夠改善語音播放質量。
  8. The hardware designing include the interface with engine controller, such as d / a conversion. we chose the ad75089 which was produced by ad corp. this is a parallel port digital to analog conversion, and i give the presentation about its structure and connection scheme. in order to resolve the contradiction between faster computation and slower display, a buffer storage also needed

    第二部分詳細陳述了高速數據傳輸卡的軟、硬體設計過程，硬體設計包括dsp與pci總線的介面、 dsp與外部控制器的介面、以及電路卡上的擴展數據緩沖區的設計，並使用專門的工具軟體protel繪出全部硬體電路的設計原理圖。
  9. Writes a specified number of bytes to an output buffer at the specified offset

    將指定數量的位元組寫入輸出緩沖區中的指定偏移量處。
  10. Writes a specified number of characters to an output buffer at the specified offset

    將指定數量的字元寫入輸出緩沖區中的指定偏移量處。
  11. Method to flush any messages currently in the log file s output buffer

    方法刷新當前位於日誌文件輸出緩沖區中的所有消息。
  12. We can modify the input output part of the source code to make the tools capable of handling input output buffers rather than files

    我們可以修改源代碼的輸入輸出部分讓那些工具能夠處理輸入輸出緩沖區而不是文件。
  13. Number display may use the pictured numeric output string buffer to hold partially converted strings ( see 3. 3. 3. 6 other transient regions )

    數字顯示可以使用圖樣數值輸出字串緩沖區來保存部分轉換的字串（參閱: 3 . 3 . 3 . 6其他暫時的區域）
  14. The buffer _ size must be transported before the compressed data, thus the expanding program can read out the size in it. so the consistency of compression and pi expanding model can be ensured

    輸出壓縮代碼之前先輸出緩沖區大小值，這樣解壓程序可從壓縮代碼中得到該值，從而確保壓縮與解壓模型的一致性。
  15. The memory buffer containing the bytes to send to the http output stream

    包含要發送到http輸出流的位元組的內存緩沖區。
  16. The following example returns current output buffer information for an assumed session id of

    的會話id返回當前輸出緩沖區信息。
  17. Handles the creation of message buffers and the input output operations out of a buffer

    處理消息緩沖區的創建和緩沖區之外的輸入輸出操作。
  18. Besides serializing the xml data to an internal buffer, there are two other types of output streams -

    除了將xml數據序列化到內部緩沖區之外，還有兩種其它類型的輸出流：
  19. Writes data to the serial port output buffer

    將數據寫入串列埠輸出緩沖區。
  20. Flushes the output buffer, and then closes the

    刷新輸出緩沖區，然後關閉
分享友人
分享到 Line

分享到臉書