纖維的強度 的英文怎麼說

中文拼音 [xiānwéideqiángdù]
纖維的強度 英文
toughness of fiber
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 纖維 : fibre; staple; filamentary
  1. In allusion to some types of the functional fibre s performances and characters the paper mainly has this fibres microstructure scanned by electron microscrope. in addition we also discuss their differences of microstructure eroded by the plasm. meanwhile by performing mechanics analysis we get theoretical analysis of their space - conglomerating structure. finally we perform analysis of the ultraviolet radiation and analysis of the caloricr weightlessness. as a result these types of fibre not only keep their own fine traits, but also own good conglomerating structure, crystal limit, calorifics performance and mechanics performance. compared with the ordinary fiber, the neatness of high - contracted polyester fiber increases and it s diameter also increases. there are bubbles in the burning - resisting viscose fiber and it has smooth vertical structure

    對應子高收縮的滌綸纖維的平整度有所提高，有較普通纖維變粗的趨勢；在難燃粘膠纖維裏面有氣泡，其具有較明顯的光滑平整縱向結構；滌綸系列棉纖維，在其耐刻蝕方面是比較強的，僅有均勻的小部分刻蝕現象；抗菌衛生級粘膠纖維的刻蝕效果是較差的：難燃的粘膠纖維，刻蝕的效果最好；而抗紫外粘膠纖維刻蝕的效果略有遜色。
  2. With the filling of diabase, the mechanical properties of the composite increased first and then decreased with a top tensile strength of 56. 5mpa and a top impact strength of 70. 1mpa. these illuminated that the diabase fiber reinforced pvc composites could be used as structure materials

    復合材料的力學性能隨著輝綠巖的增加先升后降，復合材料拉伸強度最高可達56 . 5mpa ，復合材料沖擊強度最高可達70 . 1mpa ，說明輝綠巖纖維增強pvc復合材料作結構材料使用。
  3. In the paper, the diabase fiber was also selected to reinforce pvc for the first time, which has high intensity, high rigidity and low cost, the diabase fiber was treated firstly, then during mixing, melting, pressing procedure, the diabase / pvc composite were prepared

    本文首次對高強度、高剛度、低成本的輝綠巖纖維增強pvc復合材料進行了研究。論文首先對輝綠巖纖維進行了表面改性，然後將改性后的輝綠巖纖維與pvc混煉、壓片制備了輝綠巖纖維pvc復合材料。
  4. These fibers are characterized by having high strengths, high elongations and good to excellent elastic recovery.

    這些纖維的特點是具有高強力，高伸度和優異的彈性恢復。
  5. The strength of glass fibres presents a more complex picture.

    玻璃纖維的強度情況很復雜。
  6. The strengths reported are usually on "virgin" glass fibres.

    通常報道的強度是「新生」玻璃纖維的強度。
  7. Firstly, the surface characteristic of polystyrene particle is changed from water detesting to water intimity by using special techniques and admixtures so mat the compound quality with inorganic materials is insured. secondly, the contradiction between the weight and strength is solved through optimizing the particle size and using composite fiber and the best heat conductivity is achieved under the condition that the necessary strength is met. in the research process, the author solved the problem of fiber dispersing in insulating materials so that the contraction of the material is controlled

    課題研究中，首先採用特殊的改性工藝及外加劑實現對聚苯乙烯顆粒表面的成功改性，使其表面由憎水轉化為完全親水，確保與無機材料的復合質量；其次，通過採用優化骨料級配及使用復合纖維等措施解決了保溫材料的輕質與強度的矛盾，使保溫材料在滿足必要的強度的前提下，導熱系數降至最小；並且，課題研究中成功解決了纖維在保溫材料中均勻分散的問題，達到了抑制保溫材料收縮的目的；最後，通過採用復合外加劑、合適的膠凝材料及合理的配比等措施確保該保溫材料具有良好的和易性，滿足施工的要求。
  8. In this research, the lime - fly - ash bound macadam was joined with steel fibers, glass fibers and polypropylene fibers with the contents of the lime, the fly ash and the macadam fixed in lab tests. the study focuses mainly on the split strength, compression strength, and modulus of compressive resilience and shrinkage property of the lime - fly - ash bound macadam enhanced by different kinds of fibers. based on the test, a detail theoretical analysis was made on the relation of mechanical property, dry shr inkage with the variety and the quantity of fibers, applying the theories of strength, dry shrinkage and the methods of statistics, curve mimesis and variance analysis

    本論文主要是研究在同一種二灰碎石混合料（石灰、粉煤灰、集料的含量及比例相同）中分別摻入不同數量的鋼纖維、玻璃纖維、聚丙烯纖維，通過室內試驗對其抗拉強度、抗壓強度、抗壓回彈模量和乾燥收縮性能與纖維摻量和纖維品種之間的關系加以分析和研究，並在此基礎上根據二灰碎石強度形成機理、乾燥收縮機理和數理統計、曲線擬合、方差分析的方法分析纖維品種和纖維數量對二灰碎石的力學性能和乾燥收縮性能的影響，最後得出纖維對二灰碎石的強度、抗壓回彈模量、乾燥收縮有很顯著的影響，並提出了相應的建議。
  9. Secondly, according to some performances of putty specimen such as strength mucosity work function, the effect of cmc and pp fiber was discussed by contrast experimentation. and find the last elements and mix proportion. thirdly, the article researched generally other performances about pp fiber putty by contrast

    其次，以膩子試件的強度、粘結性能及施工性能等作為考察依據，通過對比試驗研究分析了甲基纖維素和聚丙烯纖維對試件的影響，確定了新型膩子粉的最終配方。
  10. Strength of multifilament with different fiber number

    化纖復絲強度與纖維根數的關系
  11. The hemicelluloses and pectic substances interact with the cellulose microfibrils of the cell wall to give extra strength and at the same time retain some plasticity

    半纖維素和果膠質與細胞壁中的纖維素微纖絲相結合，這樣就具有了較大的強度同時還可以保持一定的可塑性。
  12. According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing

    針對吸水變形、霉變主要發生在地板企口表面的特徵，採用企口表面全封閉法，在復合強化地板企口表面噴塗特殊的防水封閉劑，使其依靠毛細管作用及滲透作用進入板內一定深度，堵塞木纖維之間的空隙及毛細孔通道，截斷水分傳遞的渠道，並改變毛細孔壁及纖維的表面性質以不利於水的浸潤與吸附，同時其固化后能在企口表面形成一層緻密的憎水薄膜，防止水分、濕氣從企口侵入板內引起木纖維膨脹變形、發霉等現象。
  13. Here the hsc of sompa is achieved through adding super - effective water reducer, fined slag and silicon fume, and decreasing the water / cement ratio. by varying the area ( spacing ) of tension bars, compressive bars, vertical links and distribution steel and embedding steel fiber and polypropylene fiber we try to improve the behaviors of reinforced high performance concrete one - way spanning slabs in bending, so that its ductility be greater than 5. with the same arrangement of steel the width of bending member is varied to observe the effect of the width / depth ratio on the ultimate compressive strain of concrete

    通過變化受拉筋含筋率和受壓筋、箍筋（鉤筋、分佈筋）含量，或摻加纖維使之成為鋼纖維高強混凝土（ sfrhsc ）和聚丙烯纖維高強混凝土（ pfrhsc ） ，對高強混凝土雙筋截面梁、板的受彎性能進行了試驗研究，試圖改善高強混凝土受彎構件的延性，使其延性比大於5 ；並在相同配筋情況下，通過變化截面寬度，研究了高強混凝土受彎構件的寬高比對壓區混凝土極限應變的影響；並對試驗構件的裂縫發展情況進行了觀測。
  14. Ruyi group insist on exploiting new products, strengthen research, exploiture and development strength of special zoic fibre

    公司始終堅持新產品開發，不斷加強特殊動物纖維的研究、開發、利用力度。
  15. The high chrome tanned leather fibre and natural rubber content give it excellent strength, while the right percentage of vegetable tanned leather fibre aids the chamfering of edges

    高含量的鉻鞣皮屑纖維和天然乳膠使它的強度增大，而適當比例的植鞣皮屑纖維更使它容易做多角度的切割。
  16. Standard test method for monotonic compressive strength testing of continuous fiber - reinforced advanced ceramics with solid rectangular cross - section test specimens at ambient temperatures

    室溫下帶實心矩形截面試樣的連續纖維增強高級陶瓷的單值抗壓強度試驗的標準試驗方法
  17. Also, the pan mats are handed with heat treatment, preoxidation, carbonization. the heat treatment can enhance the strength of nanoflbers, and the mats deposited on the cylinder have luster by preoxidation and the diameter of nanofiber minish greatly after carbonization

    對所得pan纖維氈作熱定型、預氧化及碳化處理，發現熱定型在一定程度上能提高纖維的強度，輥筒收集的預氧化纖維氈有一定光澤，而碳化后的單根纖維直徑大大減小。
  18. In the field of forming processes for composite materials, filament winding forming process is widely used because of its good performance

    在復合材料的成型工藝中，纖維纏繞成型工藝由於具有產品強度高（拉伸強度密度） 、可整體成型及能更好的發揮纖維高強度特性等特點，得到了廣泛的應用。
  19. Effect of exogenous materials on cotton fiber strength development in low temperature conditions

    低溫條件下外源物質對棉纖維比強度的影響
  20. In filament wound pressure vessels, the strength of fibers can not be sufficiently utilized

    摘要纖維的強度性能在纖維纏繞壓力容器中不可能得到百分之百的發揮。
分享友人
分享到 Line

分享到臉書