羽狀排列 的英文怎麼說

中文拼音 [zhuàngbèiliè]
羽狀排列 英文
pinnate arrangement
  • : 名詞1 (羽毛) feather; plume2 [音樂] (古代五音之一) a note of the ancient chinese five tone sc...
  • : Ⅰ名詞1 (形狀) form; shape 2 (情況) state; condition; situation; circumstances 3 (陳述事件或...
  • : 排構詞成分。
  • : Ⅰ動1 (排列) arrange; form a line; line up 2 (安排到某類事物之中) list; enter in a list Ⅱ名詞1...
  • 排列 : 1 (順次序放) arrange; rank; place; range; put in order; arrangement; permutation 2 [數學] permu...
  1. Leaves crowded near apex of the trunk, spirally arranged ; stipes dark brown, with sharp spines ; lamina large, oblong, tripinnate ; pinnae 17 - 20 pairs, alternate, longest one to 60 cm long, the basal one reduced ; rachis short - spiny ; pinnules 18 - 20 pairs, sessile or nearly so, lanceolate, to 10 cm long and 2. 5 cm wide, divided almost to the costa ; segments more or less falcate, toothed

    葉螺旋,聚生於莖端;葉柄棕色,具銳刺;葉片大,長矩圓形,三回深裂;片17 - 20對,互生,最大的長達60厘米,基部一對縮短,軸有短刺;小片18 - 20對,無柄或近於無柄,披針形,長達10厘米,寬2 . 5厘米,深裂幾達中脈;末回裂片多少鐮,有齒。
  2. Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume

    運用cfd進行數字模擬,以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要,熱煙氣流特性受火源位置的影響很大,並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛完好,也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明,在縱向通風隧道內,熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現,火災流造成的螺旋上升空氣會在墻體和流之間形成一個渦流區
  3. Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume

    文摘:運用cfd進行數字模擬,以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要,熱煙氣流特性受火源位置的影響很大,並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛完好,也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明,在縱向通風隧道內,熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現,火災流造成的螺旋上升空氣會在墻體和流之間形成一個渦流區
分享友人