翹曲高度 的英文怎麼說

中文拼音 [qiáogāo]
翹曲高度 英文
depth of camber
  • : 翹動詞(一頭向上仰起) stick [hold] up ; bend [turn] upwards; curl up
  • : 曲名詞1 (一種韻文形式) qu a type of verse for singing which emerged in the southern song and ji...
  • : Ⅰ形容詞1 (從下向上距離大; 離地面遠) tall; high 2 (在一般標準或平均程度之上; 等級在上的) above...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 高度 : altitudeheightelevation
  1. Frame : strictly high - temperature sterilized, dried ( moisture content 8 % ), fine hard timber is used for sofa ' s frame so that the problems of being insect - eaten, bent or deformed can be avoided and the sofa can have a long life

    骨架材料:均採用經嚴格溫殺菌,烘乾(平均含水率為8 % ) ,握釘力及靜的優質硬木材料做沙發骨架,徹底避免出現蟲蛀、、變形等質量問題,保證沙發經久耐用。
  2. The results of the limited element analysis and experiment study confirms that both the resisting ended batten and using angle batten in place of plate one could make the laterally stiffness of such member more strong. that maybe provides somewhat practical benefits for designing the twin - wall truss

    本文還通過矩陣分析法和模擬試驗研究,證實了端綴板的存在對抵抗側向屈有明顯提;而選用角鋼代替綴板材料相對于板形板,有助於提構件的側移剛扭轉剛,這對于單軸對稱綴板柱的設計也具有一定的實用價值。
  3. Experimental research of warpage of hdpe injection molded plate

    聚乙烯平板變形實驗研究
  4. It is found by comparison that as the structural forms of special - shaped columns and short - shear walls are used, the structures should be arranged reasonably so as to meet the needs of lateral stiffness, and axial compression ratio should be controlled strictly so as to meet the needs of constructional reinforcement to prevent the probably curling and shear failure for the purpose of meeting the needs of the construction of small high - buildings

    對比討論發現:採用鋼筋混凝土異形柱和短肢剪力墻的結構形式時,應當進行合理的結構布置以滿足結構整體抗側移剛的要求,同時嚴格控制豎向構件軸壓比並滿足配筋構造以防止構件可能出現的和剪切破壞,這樣才能同時滿足小層住宅對建築和結構的需要。
  5. Therefore, it is desirable to investigate and enhance the mechanical property of silicon single crystal. in this paper, the fracture property of czochralshi ( cz ) and nitrogen - doped silicon ( ncz ) were investigated at room temperature by three - point bending method

    尤其在當今隨著矽片直徑不斷增大的情況下,提矽片的機械強,減少矽片損傷、、位錯及其滑移等帶來的損失變得十分重要。
分享友人