耦合變壓器 的英文怎麼說

中文拼音 [ǒugěbiànyāqì]
耦合變壓器 英文
coupling tra former
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 壓 : 壓構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. That usually means push pull amplifiers are almost always " transformer only " coupled

    這也意味著推挽基本只能夠是變壓器耦合。
  2. Only transformer coupling can contribute to the voltage gain of an amplifier by virtue of a stepup turns ratio.

    只有放大器耦合方能通過開壓匝數比提高變壓器電壓增益。
  3. The signal is fed into a filter-amplifier which is transformer-coupled to the video-detector.

    這個信號送到濾波器-放大器，它是由變壓器耦合到視頻檢波器的。
  4. Like the transformer coupled circuit, the choke feed in the parafeed circuit allows the output to swing above and below the power supply voltage

    和變壓器耦合電路一樣，旁饋電路中地扼流圈也能容許輸出在高於和低於高壓的情況下波動。
  5. A novel parallel - serial type cttfc ( combined two - transistor forward converter ) with coupled inductor is present in this paper, and the performance of three parallel - serial type cttfcs is studied and compared. the performance of cttfc with coupled inductor is similar to the other two cttfcs while coupling coefficient is less than one and the converter working ccm ( continuous current mode ), and input - to - output voltage gain increase one times while coupling coefficient is one

    本文提出了一種耦合電感並?串型雙管正激組合變換器，並對三種並?串型組合變換器的特性作了比較：耦合系數小於1且耦合線圈電流連續時，三種並?串型組合變換器特性相類似：耦合系數為1時，組合變換器輸入輸出電壓增益增大一倍。
  6. The output transformer is capacitively coupled to the anode

    輸出變壓器電容耦合到屏級。
  7. Sometimes the capacitor is inserted between the anode and the transformer ( as shown in the schematic above ), and sometimes the transformer is connected directly to the anode, and the capacitor inserted in the ground lead

    有的時候耦合電容在屏級和輸出變壓器之間（如圖原理圖所示） ，有時變壓器直接耦合到屏級，而電容則連接在到地端。
  8. Five different structures are described : standard transformer coupling, parafeed, resistively loaded stage capacitively coupled to the output transformer, tube ( valve ) based constant current source load capacitively coupled to the output transformer, and solid state ( mos fet ) constant current source load capacitively coupled to the output transformer

    我們將討論五種不同的方式：標準變壓器耦合；旁饋耦合；電阻性負載電容性耦合至輸出變壓器；膽恆流源負載電容性耦合至輸出變壓器；以及晶體管恆流源負載電容性耦合至輸出變壓器。
  9. After that, the author discusses a novel solid states limiting technology and provides a single - phase solid states bridge current limiter and a main circuit topology of three - phase fault current limiter. it can be found that the new type of three - phase solid states bridge current limiter can handle the fault conditions more flexibly. it can not only remove the fault circuit, but also control the value of stable fault current to cooperate with the existing line three - segment relay

    繼而，介紹了一種新型固態限流技術，給出了單相、三相限流器的主電路拓撲，分析了其基本工作原理和控制方式，指出以全控橋結構為基礎的變壓器耦合橋式限流器能夠更加靈活地處理電力系統的各種短路故障，及時地限制短路電流，並與現有的線路三段保護相配合，還可根據需要實現及時切除故障電路，在故障恢復時軟重合閘。
  10. After a simulated sample is given, we compute on this sample coupling analysis and steady non - linear analysis. by contrast with the experimental outcome of short circuit, we make certain that steady non - linear analysis should be used to analyze a true model. and then, we confirm the external conditions of finite element heat analysis after analyzing the cooling ways of multiple magnetic circuit transformers

    2 、論述了有限元分析的電磁場和溫度場的理論基礎;製造出模擬樣機，分別用耦合場分析法和穩態非線性分析法對其進行計算，計算結果與其短路實驗結果進行對比，驗證了穩態非線性分析法計算結果的可信性;分析多磁路變壓器的冷卻方式，確定有限元熱分析的外部條件。
  11. Antenna coupling transformator

    天線耦合變壓器
  12. It also gives the results of simulation and experiment. the comparision of the two transformers shows that the flyback rotating converter can just transform signal or low power while the fullbridge one conducts the larger

    本文還對旋轉變換器的重要部件?旋轉變壓器進行了設計和磁性能分析，得出這種原、副邊分離耦合變壓器的性能比普通的原、副邊緊密耦合變壓器的性能較差。
  13. In the second chapter, equivalent circuit of the eddy current sensor is firstly analyzed. based on that, the carrier signal generating circuit that is realized by the lc periodic circuit is introduced, thus, the carrier signal of standard frequency is obtained through the trimming capacity. subsequently, the disc type rotational armature generator and the rotational coupling transformer are separately leaded in to realize the power supplies of the carrier signal generating circuit and output of the measuring signal

    在傳感器設計一章中，首先對渦流傳感器進行等效電路分析，在此基礎上分析了由電感、電容諧振電路構成的載波信號發生電路，並通過微調電容獲得了標準頻率的載波信號；接下來提出了採用盤式旋轉電樞發電機解決載波信號發生電路電源供給問題的方案，同時通過旋轉耦合變壓器的引入，使得測量信號輸出問題很好地解決；本章最後給出的一組實驗曲線充分說明了這一方案的可實現性。
  14. First, the capacitor inserted allows a low frequency " extension " due to the resonance between the transformers inductance and the capacitance value

    第一，耦合電容和變壓器初級電感之間的諧振可以容許更好的低頻延展。
  15. The high voltage part of the same kind products in market is composed of bulking transformer which is n ' t according to the trend to minitype. a switch high - voltage sine out inverter based on spwm is designed instead of the old transformer. this inverter adopts the double cpu which are communicated with spi

    本文進一步對此測試儀中的關鍵技術測試高壓交流電源進行了研究，目前市面上同類儀器均採用笨重的自耦變壓器加工頻升壓變壓器的方法來實現，不符合當前電子產品向輕巧，小型化發展的方向。
  16. The change of transformer ’ s output voltage with coupling coefficient is analyzed. the calculated formulas for parameters of air - core and part - magnetic - core pulse transformer are deduced based on electromagnetic theory. comparing with past formulas for calculated the parameters of the transformer, this formulas is more accurate to reckon the parameters of transformer

    首先從理論上分析了提高耦合系數對變壓器輸出電壓的影響，推導了高功率帶繞式空芯和部分磁芯脈沖變壓器的電感及耦合系數的計算公式，並與已有的方法進行比較，經實驗驗證，本文推導的方法能夠較準確地計算帶繞式空芯脈沖變壓器的參數。
  17. For the air - core pulse transformer has no magnetic material to form the magnetic loop, its coupling coefficient and energy efficiency is lower. in order to improve its property, partial magnetic material is inserted in air - core spiral strip transformer. this method not only results in better property of transformer, but also reduces the bulk of transformer

    本課題設計的變壓器是在帶繞式空芯脈沖變壓器中加部分磁芯材料以提高變壓器耦合系數，進而提高其能量傳輸效率，此方法彌補了空芯變壓器耦合系數低的缺點，並且可以使變壓器小型化，因此對部分磁芯脈沖變壓器理論和試驗的進一步研究具有重要的理論和實踐意義。
  18. Appliance coupling for the primary connection of resistance welding transformers, 200 a 550 v

    200a . 550v電阻焊接變壓器初級線圈連接裝置耦合器
  19. Aerospace series - elements of electrical and optical connection - test methods - part 704 : electrical elements - measurement of turns ratio on a transformer used in a coupler

    航空航天系列.電氣及光學連接元件.試驗方法.第704部分:電氣元件.耦合器用變壓器的匝數比測量
  20. Transformer - coupling amplifier

    變壓器耦合放大器
分享友人
分享到 Line

分享到臉書