聚焦衍射計 的英文怎麼說

中文拼音 [jùjiāoyǎnshèjì]
聚焦衍射計 英文
focusing diffractometer
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 焦 : Ⅰ形容詞1 （物體受熱失去水分 呈現黃黑色並發硬、發脆） burnt; scorched; charred 2 （著急） worried;...
  • 衍 : [書面語]Ⅰ動詞（開展; 發揮） spread out; develop; amplifyⅡ形容詞（多餘） redundant; superfluousⅢ名...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 聚焦 : [物理學] （使光或電子束等聚集於一點） focus; focusing; concentrate
  1. The position and size of the monochromator, focusing curvature radii and tilting angles of the germanium focusing monochromator under different different take - off angle, size and divergency of the second collimator and intensity loss due to the use of it were determined. the neutron flux at different wavelength, under different reflection and take - off angle of the monochromator and divergency of the first collimator, were given. the simulation on the aperture used for limiting beam size in front of the sample showed that, smaller the size of the aperture and further the distance from the aperture to the sample, greater the loss of the intensity and more serious the spread of the beam along vertical direction at the sample position which makes the practical sampling volume greater than expected

    用蒙特卡羅模擬方法對中子應力衍射譜儀的設計方案進行了優化研究，提出了一系列可供參考的數據：確定了單色器的位置、尺寸、垂直聚焦單色器在不同起飛角下的聚焦曲率半徑和傾角；討論了第二準直器的尺寸和發散，以及使用第二準直器造成的強度損失；給出了在不同單色器反射面、起飛角、中子波長和第一準直器發散度的情況下樣品處的中子注量率，以及多種組合情況下譜儀的解析度曲線；對限束方孔的尺寸、距離樣品遠近對強度損失和測量中的影響做了深入研究。
  2. A cyclic radial shearing interferometer was used to diagnose the wavefront distortion of a laser system and an lcslm ( liquid crysnd spatial ligh modulator ) was used to control it. some results have been summarized as follows : l. according to the theory of scalar quanity diffeaction and the model of the random gaussian phase screen of low frequency wavefront, the effect of the low frequency wavefront with different rms gradient on the focal spot of a laser beam was studied

    本論文在激光光束波前畸變檢測和控制上進行了新的探索，主要就空間相位調制環路徑向剪切干涉儀以及它對波前畸變的檢測和液晶空間光調制器及其對中頻段波前畸變的控制進行了研究，其研究的內容和取得的成果如下：一、根據標量衍射理論，結合低頻波前畸變的高斯隨機位相分佈模型，研究了不同均方根梯度低頻畸變波前對激光光束焦斑聚焦性的影響，並採用描述中頻段波前畸變的功率譜密度概念，模擬計算了它對激光焦斑旁瓣的貢獻。
  3. In the second chapter, during the study of compound x - ray refractive lenses, diffraction function of compound lens is derived in the light of refraction and absorption effect and the design theory of x - ray is deduced using diffraction theory in connection with the characteristic of x - ray band. the structure design of this device and micro - machined technique are also discussed

    在第二章x射線聚焦組合透鏡的研究中，針對x射線波段的特性，綜合考慮折射和吸收效應得出組合透鏡的衍射屏函數，利用衍射理論推導出x射線聚焦組合透鏡的設計理論並進行結構設計與微細加工製作技術研究。
  4. Based on the rate - equation theory of four - level system, the expressions of threshold pump power, output power and slope efficiency are given. the influence of space distribution of pump light ( the position of focusing point, dimension of pumping light and divergence angle ) to the output characteristics are also discussed. then, by investigating the effects of thermal effect of laser crystal on the size of laser cavity mode, we obtain the mode - matching principle of high power laser diode end - pumped solid - state lasers

    其中，在泵浦光的空間分佈變量中我們分別考慮了泵浦光聚焦后的腰斑大小、聚焦腰斑在增益介質中的位置以及泵浦光在介質中發散角的影響；然後我們研究了在高泵浦功率下激光晶體因吸收泵浦光而產生的熱效應所導致的熱透鏡效應以及熱致衍射損耗，通過分析它們對振蕩激光腔模尺寸的影響，得到了高功率半導體激光二極體端面泵浦固體激光器模式匹配的要求，為高功率連續單頻nd ： yvo _ 4激光器的優化設計提供了理論依據。
分享友人
分享到 Line

分享到臉書