肋內的 的英文怎麼說

中文拼音 [lèinèide]
肋內的 英文
intracostal
  • 肋 : 肋構詞成分。
  • 內 : 名詞1. （內部; 里頭; 里邊） inner; inside; within 2. （妻子或妻子的親屬） one's wife or her relatives 3. （姓氏） a surname
  • 的 : 4次方是 The fourth power of 2 is direction
  1. The cyclo - hoop effect which steel tubular has exert to the concrete shows the character of heterogeneous in the arch rib section, the same to the axial direction. the paper verifies the change of the material poisson ration and the concrete grade will make the cyclo - hoop effect obvious alteration, the change of the cyclo - hoop effect and the stress redistribution of the section produced by the shrinking and creeping of the concrete and the expensive concrete on the section

    在鋼管混凝土拱肋斷面上，鋼管對內填混凝土的環箍效應具有非均勻性，在拱軸方向上環箍效應也呈現非均勻性。驗證了材料的橫向變形系數、混凝土標號等參數的變化將引起環箍效應的明顯改變；混凝土的收縮、徐變和膨脹混凝土的應用導致鋼管混凝土的環箍效應發生變化並使截面的應力發生重分佈；並總結了其變化的基本規律。
  2. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ （ （ ? ） ）程序進行數值模擬、分析驗證的基礎上，對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究；計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響，得出其變化規律。
  3. The results indicate that e. rhytidosperma bears pollen with 5 waved ridges and developed hyaline lines in the grooves, which is typical for type a of pollen morphology in the genus

    結果表明斑子麻黃的花粉形態也非常特殊，其縱肋數目5條左右，縱肋波狀扭曲，肋間溝槽內透明線發達且分枝。
  4. The water onflow can be made by the direction changing and rib like spirals guide, it can strength the ability of heat absorption

    水在特殊結構內的改向和模肋式螺旋導向促成水的湍流，加大了吸收熱量的能力。
  5. This paper focuses on the research of the stress mechanism of the ribbed shell structure in statics, dynamics and under the explosive load on the basis of the engineering practice of cave depot of single aircraft. in this paper, according to the classical shell theories, the basic differential equilibrium of the ribbed shell structure and the finite element analysis of 3d rippled plate are established, in which the function of annular ribs reinforcement bars and 3d ripped steel plates are distributed in the range of the steel, and the functions along the longitude direction of tension, bending, and torsion are neglected ; applied with dynamic analytical theory, the dynamic model of ribbed shell structure and the analytical theory model of elastic - plastic are set up ; the triangle series method is used to solve the displacement and stress under the distributed load and the concentrated load of the ribbed shell structure

    本文以軍用機場地面單機掩蔽庫工程建設為工程背景，首次對內襯三維波紋鋼板混凝土拱型復合結構的受力機理進行了靜力、動力和爆炸荷載的分析研究。根據將橫肋、鋼筋及三維波紋鋼板的作用均勻分佈在殼體范圍內的情況，忽略橫肋、鋼筋及三維波紋鋼板沿殼體母線方向的抗拉、抗彎及其抗扭作用，首次推導出了內襯三維波紋鋼板混凝土殼體的微分平衡方程，建立了有限元計算模型，並採用三角函數法，求解了三維波紋鋼板混凝土拱型復合結構在分佈荷載和集中荷載作用下的位移響應和應力響應，並與普通殼體進行了比較。
  6. The investigation on the evaporation heat transfer characteristics in a horizontal micro - fin tube for r290 - 3gs mixture shows : a ) the average evaporation heat transfer coefficient of the mixture increase with the increasing of the mass flux

    R290含油混合物在水平微肋管內流動沸騰換熱特性的實驗研究表明： a ）隨著質量流率的增加，含油混合物微肋管內的沸騰平均換熱系數增加。
  7. The experimental results of air heat transfer show that the relative fin height, relative fin width, relative fin pitch and density of 3 - d ift with staggered arrangement fins all have an effect on heat transfer and flow friction. especially, the effect of fin density is bigger

    空氣換熱實驗的結果表明：肋叉排三維內肋管的相對肋高、相對肋寬、相對肋間距以及肋密度均對其對流換熱特性有影響，其中肋密度的影響較大。
  8. The experimental and numerical studies on the two enhanced tubes are performed. the strong multi - longitudinal vortex flow in the aea - tube is induced by alternating change of the elliptical cross - section, and for the ddir - tube, the strong multi - longitudinal vortex flow is

    交叉縮放橢圓管是通過橢圓截面的交叉變化誘導產生強烈的二次流和多縱向渦流，而不連續雙斜向內肋管則是通過不連續的雙斜向內肋對的作用形成強烈的多縱向渦。
  9. Compares the 3 - d ift with smooth tube, the result shows that heat transfer augments, volume decreases, metallic material reduces and energy saves. so the tube with three dimensional internally extended surface have very wide engineering application background

    使用結果表明：使用了三維內肋管的換熱器同未使用前相比，換熱強度提高，體積減少，金屬材料耗量減小，能耗降低，具有十分廣闊的應用前景。
  10. 3 - d ift have three fin arrangements : staggered arrangement fins, in - line arrangement fins and spiral arrangement fins. the former experimental study regressed the experimental data of all three fin arrangements and obtained the heat transfer criterion equation of 3 - d ift, while the paper sets apart the three mixed fin arrangements and applies othorgonal testing method to the 3 - d ift with staggered arrangement fins which is wide used in the engineering

    原有的研究是將三種肋排列形式三維內肋管的實驗數據混雜在一起進行回歸得到三維內肋管的換熱準則式，而本文則將原有研究中混雜不清的肋排列的三種形式區分開來，並對其中在工程中應用最廣泛的肋叉排三維內肋管進行了詳細的正交試驗研究。
  11. The film hole extraction has the effect of increasing the static pressure, so the pressure loss characteristics of the passage with film hole extraction is obviously different in comparison with that without extraction ; 5

    氣膜孔出流對通道內的靜壓有明顯的提升作用，因此帶肋壁和氣膜孔出流通道的流阻特性與單純帶肋壁通道有明顯差別； 5
  12. 2 based on experimental results and finite elements analysis of new joint, the stress transfer mechanism of the new joint is analyzed. there are two stress transfer patterns about the new joint, one is for rectangular steel tubular column joint, its stress transfer pattern is that beam moment is transferred to column webs mainly by stiffeners, the other is for crft column joint, its stress transfer pattern is that part of beam moment is transferred from stiffeners to column webs, another part of beam moment is transferred to infilled concrete by column flange

    （二）基於新型節點的試驗結果和有限元分析，研究了新型節點的傳力機理，其應力的傳遞路徑分為兩種：對于鋼管柱節點，梁端彎矩主要通過加勁肋板直接傳至柱腹板，對于鋼管混凝土柱節點，梁端彎矩一部分通過加勁肋傳給柱腹板，另一部分通過柱翼緣傳給鋼管內的混凝土。
  13. In this paper, the working fluid is air. experimental study of the nine different structure parameters of 3 - d ift with staggered arrangement fins in the reynolds number range of 250 to 30000 is performed to investigate the characteristics of heat transfer and flow friction behavior. analyses and reduces the experimental data by the least square method, obtains the nusselt and fanning friction fitting criterion equations

    本文以空氣為工質，在re 250 30000范圍內對九根具有不同肋形結構尺寸的肋叉排三維內肋管的換熱及流動特性進行了研究，並運用最小二乘法分析和處理實驗數據，獲得努謝爾特數，范寧摩擦系數與雷諾數，肋幾何參數的準則方程式。
  14. Through the conventional analysis of the othorgonal testing results, we can initially determine that the best structure parameter of 3 - d ift with staggered arrangement fins

    通過對正交試驗結果進行常規分析，初步確定肋叉排三維內肋管的肋幾何參數的優化方向。
  15. Abstract : cable - stayed is used to cable suspension, but cable force is calculated by manual, and only for less than 5 segments, and the prescion is poor. this paper puts forward “ zero moment method ”, which can not only calculate more segmental soupe force, but both temporary joint and fixed joint during construction. the mechanical concept is clear, and it is easy for calculating. it is fit for program, and the illustrations prove that the methods are right

    文摘:斜拉扣掛在纜索吊裝中經常運用，但扣索索力多採用手工計算，且多用於5段以內的吊裝，計算復雜，精度低.本文提出「零彎矩法」 ，可計算任意多段扣索索力，既可計算拱肋在施工過程中各節段臨時鉸接，又可計算各節段固結的情況，將兩種連接方式統一成一種計算方法，力學概念清楚，計算簡便，適宜程，文中最後用示例證實本方法的正確性
  16. 2. the investigation on the condensation heat transfer characteristics in a horizontal micro - fin tube for hc600a - oil mixture shows : a. the condensation heat transfer coefficient of the mixture increases with the increasing of the mass flux

    2 、關于hc600a含油混合物水平微肋管內的冷凝換熱特性的研究表明：混合物微肋管內冷凝平均換熱系數隨著質量流率的增加而增加。
  17. ( 2 ) the investigation on the condensation heat transfer characteristics in a horizontal micro - fin tube for hc290 - oil mixture shows : a ) the condensation heat transfer coefficient of the mixture increases with the increasing of the mass flux

    （ 2 ）關于hc290含油混合物水平微肋管內的冷凝換熱特性的研究表明： a ）隨著質量流率的增加，混合物微肋管內冷凝平均換熱系數增加。
  18. Most of the expenses were donated by catholics, especially the decoration in the chapel, most of which came from local catholics

    小德肋撒天主堂的造堂經費大部分由教友捐獻，特別是聖堂內的裝飾品，幾乎全部是教友捐獻的。
  19. At last, on the basis of the linear finite element model, the effect of different factors such as the stiffness of the arch rib, the arrangement form and the arrangement position of the lateral brace, the sloping angle of arch ribs, ratio of the width to the span, the form of the hangers, the stiffness of bridge decks, cables etc is discussed

    最後，本文還通過有限元模型的分析，就拱肋自身剛度、橫撐的布置形式和布置位置、拱肋內傾角、寬跨比、吊桿形式、橋面剛度、斜拉索等方面對該橋的整體穩定性的影響展開討論和研究。
  20. At present, the study of water in smooth helical tube, of which the main work is about critical heat flux ( chf ), is the primary concern of the research about the two - phase flow and heat transfer in curved pipe

    目前螺旋管內兩相流動傳熱研究主要以光滑螺旋管內的兩相流動傳熱為主，其研究重點為臨界熱流密度（ chf ） ，但對製冷劑在微肋螺旋管內兩相流動傳熱還鮮見報道。
分享友人
分享到 Line

分享到臉書