脈沖輸入信號 的英文怎麼說

中文拼音 [màichōngshūrùxìnháo]
脈沖輸入信號 英文
pulse input
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 號 : 號Ⅰ名1 （名稱） name 2 （別號; 字） assumed name; alternative name3 （商店） business house 4 （...
  • 輸入 : 1 （從外部送到內部） import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  1. That is, vibration caused by the first part of the command signal is canceled by vibration caused by the second part of the command. input shaping is implemented by convolving a sequence of impulses, an input shaper, with any desired command

    輸入成型通過把參考輸入信號和一系列脈沖進行卷積，得到成型輸入信號，而成型輸入信號作用於控制對象，其中這脈沖序列就是輸入成型器。
  2. The system comprises three modules : the first is the ccd driver module, which controlled with cpld. programming the cpld to produce ccd driving pulses and synchronized communication signals. after preprocessing, the output video signals are transmitted into high resolution adc module, in which they are converted into digital signals, and then processed in arm processing module

    整個系統分為三個模塊: ccd驅動模塊的核心是一片復雜可編程邏輯器件（ cpld ） ，對其編程產生ccd的驅動脈沖及同步控制信號;視頻輸出信號經預處理后，由高精度ad轉換模塊進行采樣，將ccd輸出的模擬信號轉換成數字量;最後，將數據送入arm處理系統中進行后續處理。
  3. This circuit board can translate impulse signal outputted from photoelectric sensor into ascii codes and then input them into serial interface of the computer, these ascii codes are ulteriorly displayed and disposed through the cat software

    該電路板可將光電傳感器輸出的脈沖信號轉換成ascll碼輸入到計算機串o ，進一步通過相應的cat軟體進行顯示與數據處理。
  4. Flexible dimming control utilizes either an analog control signal or direct digital pwm control without external rc filtering. this also increases dimming accuracy at low brightness levels

    電路採用靈活的調光控制方式，既可輸入模擬控制信號，也可直接輸入數字脈沖寬度調制信號而不需要外置rc濾波器。
  5. The video signal processing circuit realizes the primary catching, filtering and signal amplifying. variable threshold binarization processing circuit and two - channel counter are designed to sample to count the output pulse signal, which is processed, deposited and displayed in microprocessor. the communication interface circuit with the computer is also designed

    視頻信號處理電路完成了原始信號的初級捕捉、濾波、視頻放大等處理，設計了浮動閾值二值化處理電路，採用兩路計數器對輸出脈沖信號采樣計數，最後送入微處理器進行運算處理，可實現測量值的儲存、顯示等，並設計了與上位機的通訊介面。
  6. Secondly the detection precision is only related to the synchronization phase but not to the amplitude of the mainline voltage because that it uses the optimized pulses synchronous with the mainline voltage as modulation signals. thirdly it decreases the requirement of the input low pass filter and eliminates the error resulting from the direct component and even harmonics of load current. the most significant merit is that it can eliminate the effect of a few low order odd harmonics and the detecting circuit is easy to be implemented

    模擬和實驗結果表明該方法的主要優點有：不需使用乘法器進行信號調制，調制信號採用與電網電壓同步的優化特定脈沖，其檢測精度只與同步相位有關，而與電網電壓幅值無關；降低了對輸入低通濾波器的通頻帶要求，直流和偶次諧波分量對檢測精度沒有影響；突出的優點是可以消除有限個低奇次諧波對檢測結果的影響。
  7. X fluorescence can quickly carry out measurement without damage and motion. it was widely adopted in geology, mining, environmental - protection, archaeology and industrial - analysis. its principium is that in measurement of radioactivity, the pulse energy is directly proportional to pulse signal amplitude detected by the radiation detector

    X熒光方法可以實現快速、原位、無損測量，被廣泛應用於地質、礦業、環保、考古、工業在線分析等領域，其原理是：在核能譜測量工作中探測器輸出的脈沖信號與入射粒子的能量成正比，通過測量脈沖信號幅度，得到入射粒子的能量。
  8. In this system, cpld controls semiconductor laser, the fet controls surface light source by the way of changing input voltage to control current, and the pulse signal of 1khz produced by at89c2051mcu controls yag laser

    系統中使用cpld控制半導體激光器，使用場效應管通過改變輸入電壓控制電流的方法來控制面光源，通過at89c2051單片機產生1khz的脈沖信號來控制yag激光器。
  9. The glitch may, in turn, reduce the relative magnitude, causing the output node of the input inverter to switch states

    此干擾脈沖反過來又減小（輸入信號）的相對幅度，造成輸入反相器的輸出節點改變狀態。
  10. From three - wave coupling equations, the optimal crystal length, conversion efficiency and parametric light pulse width are computed numerically when clbo is used in picosecond optical parametric amplification. the results present that clbo are suited for optical parametric amplification in short wave band. in order to get higher conversion efficiency, the crystal length should be optimized according to the intensities of pump and signal waves

    從三波耦合方程出發，對clbo用於皮秒級光參量放大時，最佳晶體長度、轉換效率和參量光的脈沖寬度進行了理論分析和數值模擬，結果表明clbo晶體適合在短波范圍作光參量放大，為達到高的轉換效率和窄脈寬的信號光輸出，泵浦光和初始入射信號光的強度應根據晶體長度取最優化值。
  11. The paper advised that electronic control system could apply step by step. the writer believes that it is disadvantage to use high quality control system, because it is too expensive to use the electronic control system. the research puts forth a new electronic control system

    空燃比的閉環控制輸入信號是節氣門位置傳感器和排氣氧傳感器，經過ecu計算處理后，向步進電機發出控制指令，利用步進電機的脈沖方向和步長改變向汽缸內的供氣量，形成對空燃比的閉環控制。
  12. The results show that wavelength locates in gain zone of semiconductor optical amplifier, and have higher peak power and proper time delay between the two pulses for the second order super gauss control pulse in semiconductor optical amplifier. a high quality amplified signal pulse can be achieved. the chirp can be reduced notability by using cascading soa in cross gain modulation based on soa, and the distance and the peak power of conversion optical pulse can be increased notability, and we can let down the demand for wavelength based on xgm in soa and enhance the flexibility of wavelength conversion

    我們應用二階超高斯光脈沖與高斯信號脈沖同時注入soa和應用soa與非線性光學環鏡（ nolm ）相結合的方案來對信號脈沖進行壓縮整形，模擬顯示，在調節系統合適參數的情況下，波長位於soa增益區的二階超高斯控制光脈沖在具有較高的峰值功率和適當時延下輸入soa時，最後可以得到放大的高質量超簡訊號光脈沖；在基於soa的交叉增益調制（ xgm ）全光波長轉換中，採用級聯的soa能有效地使反轉光脈沖的頻率啁啾得到有效降低，波長向下轉換的距離和反轉光的峰值能量都得到明顯提高，降低了利用交叉增益調制（ xgm ）波長轉換中對波長精度的要求，從而提高了波長轉換的靈和性。
  13. These impulses, when fed into a receiver ( television set ), can then be electronically reconstituted into that same image

    當這些電子脈沖信號被輸入一部接收機（電視機）時，就可以用電子學的方法把脈沖信號重新恢復成同一幅圖像。
  14. Scm as control core applied in the variable axial piston pump is introduced briefly in the paper, including structure and work principle

    摘要本文介紹了基於單片機控制的數字變量軸向柱塞泵的結構組成、工作原理，並理論推導了數字泵的輸出流量與輸入脈沖信號呈線性關系。
  15. The common detector output pulse signal scope is several dozens millivolts, but the multichannel pulse analyzer input pulse amplitude request is 1 - 15v, therefore the pulse linear amplifier must have the certain voltage gain, about ten times to several times

    一般探測器輸出脈沖信號幅度為幾十毫伏，而多道脈沖幅度分析器輸入脈沖幅度要求為1 - 10v ，所以脈沖線性放大器必須具有一定的電壓放大增益，為數倍到上百倍。
  16. The enable-a signal must be released before the pulse-train inputs are enabled.

    在允許脈沖序列輸入之前，A的通信號必須消失。
  17. The enable - a signal must be released before the pulse - train inputs are enabled

    在允許脈沖序列輸入之前， a的通信號必須消失。
  18. The specific route is as follows : firstly, the output signals from the multipath sensor are nornalized, i. e., all sensor signals ( including the analog data ) are transformed into multipath square wave pulse signals to form multipath parallel condition codes. these codes are treated as input signals for dac to obtain a series of dispersed analog signals for output as input signals for the vco. finally, a high frequency modulation signal is conducted at the vco ' s output

    具體技術路線如下：先將由多路傳感器輸出的信號進行歸一化處理，即將所有傳感器信號（包括模擬量）轉換成多路方波脈沖信號，以形成多位并行信號的狀態碼，將其作為dac的數據輸入信號，從而得到一系列離散的模擬信號輸出，作為vco的輸入信號，最終在vco輸出端形成高頻的調制信號。
  19. Although adsl comes with new digital processing, coding, modulation and error correction technologies, it is also faced with various challenges out of subscriber lines, such as background noise, impulse noise, insertion loss, cross talk, wire size variations, bridge tap, line joints and line insulation, etc. all those factors tend to produce adverse impacts on the performance of high - speed transmission services. firstly, the insertion loss of copper lines increases in proportion to the length of lines

    雖然adsl採用先進的數字信號處理技術、編碼調制技術和糾錯技術，但是在推廣adsl業務時，用戶線路的許多特性，包括線路上的背景噪聲、脈沖噪聲、線路的插入損耗、線路間的串擾、線徑的變化、線路的橋接抽頭、線路接頭和線路絕緣等因素將影響高速率傳輸業務的性能。
  20. The video simulator is of significant flexibility and commonality. so long as the simulation software is changed, simulation of different radar signals can be implemented. the video simulator can dominate radio frequency ( rf ) equipment to export rf pulse to implement the function of radar signal environment integrated simulation system

    模擬器控制射頻設備輸出的射頻脈沖，既可作為注入信號直接輸入雷達偵察接收機，也可以放大到足夠的功率后通過天線輻射，作為微波暗室的輻射源，實現雷達信號環境一體化模擬系統的功能。
分享友人
分享到 Line

分享到臉書