膠凝 的英文怎麼說

中文拼音 [jiāoníng]
膠凝 英文
[化學] gelatinization; gelatinize; jelling膠凝材料 gelled material; 膠凝劑 gelatinizing agent; gelatinizer
  • : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
  • : 動詞1. (凝結) congeal; curdle; coagulate 2. (注意力集中) fix
  1. We infered that this new absorption band was associated with the effect of charge - transfer transition between adsorbates and colloidal silver particles, not the effect of the surface plasma resonance due to the silver particles aggregation which was usually attributed to in previous research work

    我們將其歸因於與納米銀顆粒表面間的電荷轉移效應( ct ) ,而非通常所認為的因銀膠凝聚而產生的表面等離子體共振吸收效應。
  2. Preparation of bioglass ultrafine powder by sol - gel - self - propagating process

    膠凝自蔓延法制備生物玻璃超細粉
  3. The present work indicates the organic nf membranes and the inorganic nf membranes all have shortages, so develop composite nf membranes that have low cost, mechanically strong and thermally / chemically - resistant, easy to cleanout and good performances is a very important task. in this paper, the preparation of inorganic - organic composite nf membranes were presented. this composite comprise a porous sio2 / al2o3 support substrate, the pore diameters of which ranging from 10 to 15 nm, this inorganic support substrate having a polymer membrane which comprises an polyvinyl alcohol ( pva ) or polyamide ( pa ) densely deposited on at least one of the face surfaces thereof, the structural porosity of such pva and pa membrane ranging from 3 to 5 nm

    本論文以開發無機?有機復合納濾膜為出發點,首先在al _ 2o _ 3多孔微濾膜上利用溶?法制備sio _ 2 al _ 2o _ 3無機復合超濾膜作為無機?有機復合納濾膜的基膜;選用聚乙烯醇和聚酰胺為表面功能層材料,分別探討了以羥基丁二酸和磺基水楊酸為混合交聯劑,採用浸塗法制備了聚乙烯醇sio _ 2 ? al _ 2o _ 3復合納濾膜;以均苯二甲酰氯、哌嗪和二胺為單體,採用界面聚合法制備了聚酰胺sio _ 2 ? al _ 2o _ 3復合納濾膜,並對影響膜性能的諸多因素進行系統研究。
  4. Mas precursor powders are prepared using aluminium sulfate, colloidal silica, and magnesium nitrate as raw materials via sol - gel methods, dsc - tg and xrd show that the mas precursor powders transform to cordierite completely at 1300

    以硫酸鋁、硝酸鎂和硅溶為原料,採用溶-法,制得mas先驅體粉末, xrd表明,該粉末經1300的熱處理后,完全轉變為堇青石。
  5. Cork. compound agglomerated corf for insulation underlays for parquets intended to be glued. tests

    軟木.預定接地板的絕緣底層用膠凝軟木.試驗
  6. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定:當r _ v 10 ~ 8時,製成100 100 4mm板材,用zc36型高阻儀測量;當r _ v 10 ~ 8時,用dt - 9205b型數字式萬用表測試試樣的體積電阻,為了減小接觸電阻對測試的影響,採用銀導電將銅片粘接在試樣的兩個端面上,靜置24小時,待銀導電膠凝固,試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  7. 08. 02 test method for gel time and peak exothermic temperature of reacting thermosetting resins

    活性熱固樹脂膠凝時間和最大放熱溫度測試方法
  8. Gelation time refers to the interval of time between the addition of the last ingredient and the completion of the gelling.

    膠凝時間,是指加入最後成分到膠凝完畢所需時間。
  9. Methods of test for adhesives - determination of gelation time

    粘合劑試驗方法.第b5部分:膠凝時間的測定
  10. Studies on the mechanism of combined gelation formation of myosin and - carrageenan

    卡拉混合膠凝機理的研究
  11. Methods of testing plastics - other properties - determination of gelation time of phenolic resins

    塑料的試驗方法.其他特性.酚醛樹脂膠凝時間的測定
  12. Methods of testing plastics - other properties - determination of gelation time of polyester resins manual method

    塑料的試驗方法.其他特性.聚酯樹脂膠凝時間的測定
  13. Glass fibre reinforced magnesium cement corrugated sheet and ridge tile

    玻纖鎂質膠凝材料波瓦及其脊瓦
  14. Heat sets eggs and cold sets jullies

    加熱能使蛋結,寒冷能使凍膠凝固。
  15. Firstly, the surface characteristic of polystyrene particle is changed from water detesting to water intimity by using special techniques and admixtures so mat the compound quality with inorganic materials is insured. secondly, the contradiction between the weight and strength is solved through optimizing the particle size and using composite fiber and the best heat conductivity is achieved under the condition that the necessary strength is met. in the research process, the author solved the problem of fiber dispersing in insulating materials so that the contraction of the material is controlled

    課題研究中,首先採用特殊的改性工藝及外加劑實現對聚苯乙烯顆粒表面的成功改性,使其表面由憎水轉化為完全親水,確保與無機材料的復合質量;其次,通過採用優化骨料級配及使用復合纖維等措施解決了保溫材料的輕質與強度的矛盾,使保溫材料在滿足必要的強度的前提下,導熱系數降至最小;並且,課題研究中成功解決了纖維在保溫材料中均勻分散的問題,達到了抑制保溫材料收縮的目的;最後,通過採用復合外加劑、合適的膠凝材料及合理的配比等措施確保該保溫材料具有良好的和易性,滿足施工的要求。
  16. A laboratorial study of system

    體系膠凝材料的初步探索
  17. The pertinent research work has been carried out as follows : the transparent nano - tio2 films on soda - lime glass substrates were obtained by sol - gel process. the precursor of nano - tio2 film was ti ( oc4h9 ) 4 and the menstruum was c2h5oh. the preparation conditions which were effecting the nano - tio2 quality were researched

    本文主要就納米tio _ 2薄膜的制備、探索用ecr氮等離子納米tio _ 2的摻雜改性等開展了如下的工作:本文採用溶?法,以鈦酸丁醋做前驅體、無水乙醇做溶劑,水解制備溶,然後通過提拉法制備納米tio _ 2薄膜。
  18. Activation of the complement may lead to killing of the microorganisms by direct lysis effect of complement system or the phagocytosis by the enhancement of the attachment of microbes to the phagocyte ( opsonization ). low serun concentrations of mbl in man is the basis for a common opsonic defect associated with recurrent infection

    它可選擇性識別多種病原體表面的糖結構,以不依賴抗體和c1q的方式激活補體,發揮溶破和間接調理功能,還能與吞噬細胞膠凝素受體結合而起直接調理作用。
  19. The limno2 synthesized by sol - gel method was orthorhombic phase and pmnm space group, with farthing impurity of mn2o3 。 the result of sem showed that the size of flake was about 1 ~ 2 m, the thickness of flake was about 50 ~ 100nm. the highest discharge capacity is 170. 7mah / g

    膠凝法所得limno2材料的xrd結果顯示,該材料為斜方晶系, pmnm空間群,有極少量mn2o3雜質; sem結果顯示其片層尺寸大約在1 ~ 2 m ,厚度大約為50 ~ 100nm 。
  20. Thus, to improve the specific of lithium ion batteries, main effort should be directed toward the synthesis of new positive electrode materials, i. e. various lithiated oxides that could reversibly intercalate one li atom per 3d - metal atom at about 4v versus li

    O 。由於電壓高、價格便宜和對環境友好而成為最有希望的備選材料之一。首次採用了聚丙烯酸paa為鰲合劑,運用溶膠凝法,合成了limn 。
分享友人