膠質電池 的英文怎麼說
中文拼音 [jiāozhídiànchí]
膠質電池
英文
gelled cell- 膠 : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
- 質 : Ⅰ名詞1 (性質; 本質) nature; character; essence 2 (質量) quality 3 (物質) matter; substance;...
- 電 : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
- 池 : 名詞1 (池塘) pool; pond 2 (旁邊高中間窪的地方) an enclosed space with raised sides 3 (舊指劇...
- 膠質 : galotinous; colloidalmatter膠質層 gelatinous layer; 膠質電池 [電學] gelled cell; 膠質膜 cutose
- 電池 : [電學] cell; battery; element; electric battery
-
Composition battery case
膠質電池殼The sol - gel method and solid - state thermal reaction technique were used to prepare the composite oxides with variable lithium content. the doping treatments of some compounds were conducted. dta and tg were used to analyse synthesis mechanism, xrd to analyse phase composition, sem to observe morphology, li - b / licl - kcl / oxide simulated thermal cells to analyse the lithium - intercalation mechanism and properties of cathode material
實驗中採用溶膠?凝膠工藝和固相熱反應技術制取相應的不同鋰含量的復合氧化物,並嘗試對某些化合物進行適當的摻雜處理,應用dta和tg分析合成機制、 xrd分析所得物的物相組成、 sem觀察其形貌,模擬li - b / licl - kcl /氧化物的單體熱電池來分析陰極材料的嵌鋰機制及其電極性質。Firstly, a situ - polymerization method as the preparation process of gplb is introduced and pmma as the polymer matrix of the gel electrolyte is selected. the thermal polymerization process of the gel electrolyte is also optimized
首先,採用了現場聚合法制備凝膠聚合物鋰離子電池的工藝,根據該制備工藝選擇pmma基作為該凝膠聚合物電解質的聚合物體系,然後對凝膠的熱聚合工藝進行了優化,確定了最佳的熱聚合工藝。Now the ion conductivity of gel polymer electrolyte ( gpe ) can reach the magnitude of 10 - 3s / cm, which can satisfy the practical request. however, it is still lower than that of liquid electrolyte ( 10 - 2 s / cm ), which causes the fall of high rate discharge and low temperature performance of lithium battery
目前凝膠聚合物電解質( gpe )的室溫離子電導率可達10 ~ ( - 3 ) s cm數量級,已經能基本滿足應用的要求,但相比液態電解液的電導率( 10 ~ ( - 2 ) s cm ) , gpe的電導率仍然偏低,使得凝膠聚合物鋰離子電池的高充放電速率和低溫性能都大大的降低。Objective : construct effective mathematic model to analyse the piezoelectric frequency data of pt test based on the theoretic analysis of viscosity and density changes in coagulation reaction system and discuss the feasibility of detecting patients ’ samples in clinic, on the
方法: 1 .選用基頻為10mhz的at切型銀膜電極石英晶體傳感器構建螺旋式檢測池,使不同檢測池具有同質性。在傳感器上下各墊加一o形硅膠密封圈,並置於金屬基座上。The cathodes, which were made of above - mentioned three composites, and gel polymer electrolytes were used for lithium batteries
並分別把以上三大類復合材料做成正極與液態電解質或凝膠態電解質組裝成金屬鋰電池。The mechanisms of dehydrogenization and sulfuration reaction were deduced on the basis of the characterization results. the charge capacities, reversibilities and self - discharge properties of the above - mentioned composites were systematically studied in lithium batteries based on gel electrolytes
將上述復合材料制備成正極,結合凝膠電解質組裝成鋰電池,研究了復合材料的比容量、循環性能、充放電可逆性、自放電等多種電化學性能。The company product widely applies in the new battery raw material, the rubber cementing agent, the petroleum catalysis, the paint, hard alloy, arrester manufacturing industry, ceramic colored glaze industry, professions and so on electric cable
公司產品廣泛應用於新型電池原料、橡膠粘結劑,石油催化,油漆,硬質合金,避雷器製造業,陶瓷彩釉業,電纜等行業。The specific properties, types, the methods in studying their structure and function and the prospect of their application in electronic double layer capacitors are discussed
討論了凝膠電解質的特性、類型、關于其結構性能的研究方法,以及其在電雙層電容器和鋰離子二次電池方面的應用研究狀況,並簡要探討了發展前景。Finally, we prepare some gplbs using the gpe mentioned above through situ - polymerization process followed by measuring the performance of the batteries
最後,採用該凝膠聚合物電解質,根據現場聚合法制備了凝膠聚合物鋰離子電池,並檢測了該電池的各項性能。A gel - typed polymer electrolyte based on pvdf - hfp was studied
本文研究了pvdf - hfp基鋰離子電池聚合物凝膠電解質的性質。Now the main method of preparing gplb is to fabricate a gpe film through solution casting first, and then assemble the battery
而且目前gpe主要是通過溶液澆鑄的方法,首先制備成凝膠聚合物電解質膜,然後再組裝成電池。The pvdf - hfp / pmma blended gel type polymer li - ion batteries are studied. the ratios of the pvdf - hfp and pmma affect the performance of the batteries
進一步討論了pvdf - hfp / pmma共混物凝膠電解質組分的改變對電池性能的影響。分享友人