自感耦合 的英文怎麼說

中文拼音 [zìgǎnǒugě]
自感耦合 英文
autoinductive coupling
  • 自 : Ⅰ代詞（自己） self; oneself; one s own Ⅱ副詞（自然;當然） certainly; of course; naturally; willin...
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  2. 30 litre couplant tank. automatic pumped supply with full recirculation. visual and electronic level display. continuous couplant monitoring by flow sensor and ultrasonically

    30升的耦合劑儲蓄槽。自動化泵槽裝置可以將其完全循環利用。可顯示直觀的電子層面。通過流量傳感器和超聲波地來對耦合劑進行連續監控。
  3. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  4. This article discuss the method to measure distortion of truss by means of ccd device. the distortion can be measured with many kind of displacement transducer, but it must be placed on stable base. when the huge truss is moving through some tunnel, it is difficult to find a stable base, especially there is no enough space for someone to operate. it is hardly to measure the distortion by touching. on the contrary, this can be achieved by means of ccd device

    桁架在自重或載荷的作用下產生的撓度可以用多種位移傳感器測得，這些測量方法需要有良好的基礎，在大型桁架梁測量現場，由於桁架的變形，難于找到這種基準，如果加上測量環境惡劣，人無法操作情況，則會給撓度測量帶來極大的困難，而採用光電荷耦合器件，並利用激光進行遠程實時撓度測量，即可以解決這個難題。
  5. Firstly, the paper, combining the characteristic of synchronous pulse bursts and inhibition with the modified pcnn model, presents a way of finding the foveation points in the images adaptively and effectively, and simulates the human vision system. secondly, pcnn is extended to pcnns, based on the properties of information couple and transmission, an algorithm that is used to fuse images of the same target got by several sensors to an image is presented to simulate the human vision system. thirdly, combining the properties of synchronous pulse bursts, capture, and transmission and competition of waves, the paper presents two ways of classification, one is an algorithm based on the properties of neuron to capture and inhibit to classify the data taking on any complex unlinear distribution robustly, the other is based on the restricted distance and modified of the former to remove the influence of inferior samples in classification ; fin ally, based on the accumulative difference pictures, and the forming and transmission of pcnn wave, selecting and controlling the direction of autowave by connecting the neighbouring neurons selectively, the paper presents a way to simulate the tracks of moving object and detect the moving direction

    首先結合pcnn的同步脈沖發放和側抑制特性，提出了基於改進型pcnn的圖像凹點檢測演算法，該演算法是一種自適應而有效的圖像凹點檢測方法，並且較好地模擬了人類視覺系統；然後，結合信息傳遞和信息耦合特性，將pcnn擴展成pcnns （ pcnn網路群） ，提出了一種基於pcnns的圖像融合演算法，能夠將多個傳感器獲取的同一目標的圖像信息融合到一幅圖像中，有效模擬了人類視覺系統；另外，結合pcnn的同步脈沖發放特性、捕獲特性和波的傳播競爭特性，開拓地將pcnn用於模式分類中，提出了基於耦合神經元點火捕獲抑制特性的分類方法和改進的約束距離下的pcnn分類方法，前者可實現對樣本空間中任意復雜分佈訓練樣本的穩健非線性分類，而後者能夠消除訓練樣本中刺點對分類的影響；最後，結合累積差分圖像思想、 pcnn波的形成與傳播特性，通過各神經元之間連接取向來選擇與控制自動波的流向，將pcnn用於運動視覺分析中的運動軌跡模擬及運動方向檢測。
  6. Meb are non - inductively wound with metallized polyester dielectric / eletrode and copper - clad steel leads encapsulated in a plastic case sealed with epoxy resin. they are suitable for filtering, by - pass, coupling decoupling and timing circuits with applications in telecommunications, data processing, industrial instruments and automatic control system equipments

    Meb為非感應式，用鍍金屬聚酯電介質/電極繞制而成，導線採用鍍錫銅包線，用環氧樹脂密封在一塑料套內，本品適合於耦合、濾波、和計時電路中，廣泛御用於遠程通訊、數據處理、工業儀表和自動控制系統的設備中。
  7. Mef are non - indluctively wound with metallized polyester film as the dielectric / electrode with copper - clad steel leads and epoxy resin coating they are suitable for blocking, copling decoupling filtering, by - pass and timing circuits, they find application in telecommunication, date processing, industrial instruments. and automatic control system epuipments

    Mef為非感應式，用鍍金屬聚酯薄膜作為電介質/電極，導線採用鍍錫銅包線和環氧樹脂包封.本品適合於耦合、濾波、整流和計時電路中，在遠程通訊、數據處理、工業儀表和自動控制系統的設備中得到了運用。
  8. Be different with other botdr systems, the coherent self - heterodyne botdr system uses only one consecutive laser. the light from consecutive laser is divided into two beams, the detecting light and the reference light, by a coupler

    與其他的botdr系統分別使用兩臺激光器不同，自相干外差的布里淵散射分散式光纖傳感系統採用一臺激光器，經耦合器分為兩路光束? ?探測光和參考光束。
  9. Saw excitated by input idt is divided axisymmetrily ( y type ) or centrosymmetrily ( s type ) into two pathes and detected by their output idts. there is a mass loading area located accurately in each acoustic path and fabricated by photolithography technology in y type and s type mass loading sensor devices. as the characteristics of saw sensor are greatly influenced by temperature, these sensors have one acoustic path for reference another acoustic path for measurement in order to reduce the influence of temperature

    它們各自具有一個輸入idt和兩個輸出idt 。輸入idt激發的saw經過耦合器按軸對稱（ y型）和中心對稱（ s型）分成兩路，分別由輸出idt檢測輸出。在y型和s型saw質量沉積效應傳感器件的傳播路徑上都有一個由光刻工藝精確定位的質量沉積區。
  10. As the structure and the dynamic characteristic of a multi - dimension force sensor influence the dynamic characteristic of a robot system deeply, therefore the sensor ' s analytic studying, the sensor ' s optimal design, the sensor ' s dynamic characteristic analysis and the sensor ' s coupling function among it ' s dimensions are also studied in this dissertation

    多維力傳感器自身的結構和特性影響機器人系統的動態特性，本論文還涉及多維力傳感器解析分析、優化設計、多維力傳感器的動力學特性分析、傳感器維間耦合函數研究等內容。本學位論文主要研究工作如下： 1
分享友人
分享到 Line

分享到臉書