衰減誤差 的英文怎麼說

中文拼音 [shuāijiǎnchā]
衰減誤差 英文
attenuated error
  • : 衰動詞(衰弱) decline; wane
  • : Ⅰ名詞(錯誤) mistake; error Ⅱ動詞1 (弄錯) mistake; misunderstand 2 (耽誤) miss 3 (使受損害...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • 衰減 : attenuation; decay; damping; reduction; rejection; weakening; deamplification; dampening; dying o...
  • 誤差 : error
  1. Its main contributions include the following several aspects : firstly, the dissertation constructs the mathematic model of short baseline orientation determination using two geostationary satellites and analyses the applicable conditions of carrier phase interferometry. orientation determination precision is analysed in depth through both the conventional linearized method and monte - carlo computer simulation method, and the mathematical simulation results show that the linearized method has the shortcoming of fairly low elevation error analysis precision in high latitude area so as not to be very appropriate there. by analyzing the definite factors influencing orientation precision, the dissertation develops the concept of orientation dilution of precision, which uncovers the internal cause of exotic error behavior of bi - satellite orientation, and has important guiding significance for practical engineering applications

    本文系統地研究了基於「北斗一號」衛星載波相位干涉測量原理實現地球靜止雙星定向的相關技術,主要研究成果包括以下幾方面:首先,建立了利用兩顆地球靜止軌道衛星進行短基線定向的數學模型,分析了載波相位干涉測量的適用條件;採用傳統的線性化解析法及蒙特卡洛隨機模擬法兩種途徑對雙星定向的精度進行了詳細分析,數學模擬結果表明在高緯度地區線性化解析法由於俯仰角分析精度略有下降而不太適合;在分析定向精度確定性影響因素的基礎上,提出了雙星定向精度因子odop的概念,揭示了雙星定向特殊表現的內部機理,對實際工程應用具有重要的指導意義。
  2. To ensure the reliability of tracking the target, signal attenuation and boresight error must be predicted accurately

    要保證導彈跟蹤目標的準確性,必須預測在給定掃描角下的信號和瞄準
  3. It is shown that the proposed scheme guarantees the stability of the closed - loop system and achieves tracking performance idex, meanwhile the influences of external disturbance, neural network approximation error and the cross - coupling of input to output on the tracking error are reduced to a prescribed level

    該方法不僅保證了閉環系統的穩定,而且使外部干擾、神經網路逼近及輸入對輸出的交叉耦合對跟蹤的影響到給定的水平。
  4. Sigma - delta modulator, combined with oversampling, effectively attenuate the in - band quantization noise in the output signal and enhance the signal - to - noise ratio ( snr ) through the shaping of the quantization error

    調制器與過采樣相結合,對量化噪聲進行整形,有效輸出信號的帶內量化噪聲,提高了輸出帶內信噪比( snr ) 。
  5. The results show that these algorithms for attenuation correction can work well in the valid range and their effects on attenuation correction are almost identical. when attenuation is strong or measurement error of real echo is large, however, the result from the h - b algorithm for attenuation correction is not good

    結果表明:在有效的訂正范圍內,幾種訂正方法均能得到很好的訂正,並且訂正效果幾乎保持一致,但h - b演算法在作用很強或實際回波測量值很大時,其訂正結果就變得不可靠了,從而造成訂正能力下降。
  6. Simulation results of a duffing forced - oscillation system confirm that the effect of the fuzzy approximation error on the tracking error can be attenuated efficiently by the proposed method

    強迫震?系統的模擬結果確定在模糊近似的影響下,追蹤能被有效的
  7. Applying the method of this article, we can get that the attenuation of stop - band is - 75db and the error of reconstruction is 0. 0015. the simulation program and experiment result are provided. the correctness and validity are proved

    用本文的方法,在重構將近千分之一的情況下,取得了較好的濾波器特性,其阻帶達到- 75db ,文中給出了matlab實驗程序及結果,並通過simulink模擬,證明了這種方法的正確性與有效性。
  8. The resonant box effect is the most important. in chapter five, we use the experimental setup constructed and the cavity decay time method to measure the total loss of a passive resonant cavity, and analyse the experimental data in very detail. we conclude that, in present experimental conditions it is the uniformity and stability of laser mirror to confine the precision and repeatability of experimental results

    第五章在建立起了連續光波時間法測量裝置的基礎上,進行了無源諧振腔總損耗的測量,仔細分析了實驗過程中的因素,並指出在目前的實驗條件下限制測量精度和重復性的主要原因是激光鏡片的均勻性和穩定性不理想。
  9. It attenuates the output of the preamp in the same manner as you would experience with a “ passive preamp ” except that it has a precision 256 position 4 pole attenuator for both balanced channels matched to. 1 %

    正如你以前見過的「被動前級放大器」那樣,它能夠前級放大器的輸出,並且它具有一個精密的256位4通道器,可以令兩個平衡通道匹配僅為0 . 1 % 。
  10. The proposed control system includes the attitude controller acting on the rigid hub, designed by using pulse - width pulse - frequency ( pwpf ) modulation integrated with command shaping technique based on csvs method, and the piezoelectric material elements as sensors / actuators bonded on the surface of the beam appendages, designed by the optimal positive position feedback ( oppf ) control technique, in which the selection of ppf gains is determined via introducing a cost function to be minimized by feedback gains which are subject to the stability criterion at the

    設計的控制器僅利用輸出信息,從而避免設計撓性模態狀態觀測器以及引入狀態觀測器;在此基礎上,採用分力合成方法設計命令成形控制器來抑制撓性附件的振動,設計的優化命令成形控制信號在理論上可以對系統的各階撓性模態完全抑制。但考慮到模型不確定性和外部擾動,在內迴路又設計了最優正位置反饋( oppf )補償器以增加撓性結構的阻尼,使撓性結構的振動能夠很快
  11. Presented in this paper is the investigation of some problems existing in the far - field method widely used in hpm measurement. first, the errors are analyzed from the practical calculation of the directivity for the radiation of the te11 mode in the circular waveguide. secondly, the results obtained from simulation and experiments are compared with each other on the effective area of the receiving antenna of certain types, and the power capacity are calculated for these antenna

    首先,對圓波導te11主模輻射方向性系數實際計算中存在的進行了分析;其次,對一些型號的接收喇叭有效面積進行了模擬和實測對比,並通過計算給出了這些型號的接收喇叭的功率容量;最後,實驗測定了微波脈寬對一些微波器件? ?同軸型檢波器、同軸型器及微波電纜性能的影響。
  12. The design of the laser and its bracket, neutral density filters, lens, and digital camera are complete in the hardware design ; the image collection and centroid calculation are complete in the software design ; and the experiment of straightness calibration is accomplished. the possible errors are analyzed about the whole system, and some methods to decrease the errors are put forward

    硬體部分主要完成了激光器及其支架、片組、透鏡組和數字相機的結構設計;軟體部分主要完成了圖像的採集和質心的求取;最後進行了直線性校準實驗,並對實驗過程進行了分析,提出了的方法。
  13. This paper has analyzed the characteristics of near - field electromagnetic fields and the measurement principle of magnetic - field sensor, and designed probe, amplifier unit and compensator according to measurement needs. finally, based on the electromagnetic pulse simulator in the lab, a set of experiments have been done on the designed magnetic fields measurement system and analyzed the error of the measurement system

    文中分析了近場電磁場分佈的特點;研究了磁場探頭的測量原理;根據實際測量需要製作了磁場探頭、設計了信號放大單元和用於補償電纜信號的補償器;最後利用實驗室的電磁脈沖模擬器對所設計的磁場測量系統進行了一系列實驗,分析了系統的測量
分享友人