裂紋 的英文怎麼說

中文拼音 [lièwén]
裂紋 英文
flaw; fissure; chine; gash; [房] craze; crazing; crackle （on pottery, porcelain, etc. ）
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 紋 : 名詞（花紋; 紋縷兒） lines; veins; grain
  1. Guide to methods for assessing the acceptability of flaws in metallic structures

    金屬結構裂紋驗收評定方法指南
  2. Standard test method for evaluating stress - corrosion cracking of stainless alloys with different nickel content in boiling acidified sodium chloride solution

    沸騰酸化氯化鈉溶液中不同鎳合量不銹鋼合金應力腐蝕裂紋評定的標準試驗方法
  3. Test method for stress crazing of acrylic plastics in contact with liquid or semi - liquid compounds

    丙烯塑料在與液態或半液態化合物接觸中產生的應力裂紋的試驗方法
  4. Failure analysis on fixing crack of fuel adjuster

    燃油調節器支座裂紋失效分析
  5. There are many defects in the tic preforms prepared by cold pressing, such as small air holes and cracks. the tic preforms prepared by hot pressing have better qualities

    冷壓成型預制體一般存在分層、裂紋等缺陷，未造粒的粉體壓制時流動性、均勻性差是根本原因。
  6. The research shows that the fractal theory can be used to describe quantificationally differentiate and anomalistic micro cracks of concrete that formed in injury evolution

    研究表明，用分形理論方法可以定量描述和區分混凝土在損傷演化期間形成的極其不規則的微裂紋。
  7. Based on the previous research on the portal crane administration, one standpoint put forward in this paper is idea that is on the foundation of reliability in this paper, two viewpoints take shape when reason is analyzed, that is fatigue break and appearing the flaw that will extend. what is the fatigue break ? ( this phenomenon is always happen in some place ), the fatigue is that board appears apophysis and concave when the board is pressed. so that the board ability of bearing the weight of load will descend

    本論文建立在已有的港口裝卸機械管理的研究基礎之上，進一步提出了以可靠性為基礎的港口裝卸機械的管理思想，已有的研究表明，港口機械設備破壞主要由於兩個原因，第一是穩定性問題，特別是構件的局部穩定性，所謂穩定性是指：在板的平面內，板受到平行於板面的壓力作用，使板發生隆起、內陷等凹凸不平的結果，從而使板受載能力減弱；第二是結構出現疲勞裂紋及其擴展，這是由於設備長時期運行，而造成設備某些部位出現裂紋並得以擴展，使設備承載能力下降。
  8. The crack between the coped and hole was removed by air arc and then repaired by welding.

    在修割邊和鉆孔之間的裂紋用氣弧消除，然後進行焊補。
  9. Floor-beam webs have cracked in tied arch bridges.

    在系干拱橋的橫梁腹板上發生裂紋。
  10. Atomistic simulation of crack propagation and its size - dependent behavior

    分子動力學模擬裂紋擴展及相關尺寸行為
  11. The rolling axletree in the power plants may split during the long time running

    摘要火電站的發電機組的滾動軸承由於在長時間的運行和碰撞中，有可能導致裂紋的產生。
  12. A method to identify the crack generation in the rolling axletree is introduced and the most important code in the c language is also shown

    介紹了一種用小波分析的方法來識別發電機組的滾動軸承裂紋的方法，並給出了其c語言的核心程序。
  13. Crack propagation usually begins slowly.

    裂紋的增長常常是開始緩慢。
  14. Subcritical crack growth and influence of biaxial stress in brittle materials

    脆性材料的亞臨界裂紋擴展和雙向應力的影響
  15. Analysis of singular electromechanical fields at the interfaces of bimorph with a quot; cracked element quot

    用裂紋單元分析雙壓電材料界面力電耦合奇異場
  16. The tomato vines had blackened and the red globes had burst.

    番茄藤已變黑，顆顆鮮紅的番茄裂紋綻開。
  17. Crazing is the invariable precursor of brittle fracture.

    出現小裂紋必然是脆性斷裂的前兆。
  18. However, a low fatigue strength detail or a large built-in defect may produce only a single significant crack.

    但是，疲勞強度較低的細節部分或較大的內部缺陷可能只產生一條很大的裂紋。
  19. This indicated that the fracture had initiated at the unfused butt weld in the longitudinal stiffener.

    研究表明裂紋是從縱向加勁助未熔透的對接焊縫中起始的。
  20. Some crack extension probably developed from the unfused section of the butt weld across the thickness of the stiffener during transport and erection.

    有些裂紋可能在運輸和安裝過程中就從加勁肋對接焊未熔透處開始發展。
分享友人
分享到 Line

分享到臉書