試驗求導 的英文怎麼說
中文拼音 [shìyànqiúdǎo]
試驗求導
英文
experimental derivation- 試 : 名詞(古代占卜用的器具) astrolabe
- 驗 : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
- 求 : Ⅰ動詞1 (請求; 要求) ask; beg; request; entreat; beseech : 求人幫忙 ask sb a favour; ask a favou...
- 導 : 動詞1. (引導) lead; guide 2. (傳導) transmit; conduct 3. (開導) instruct; teach; give guidance to
- 試驗 : trial; experiment; test
-
Shaft sinking - abutment for guide ropes - safety requirements and testing
打豎井.導向鋼絲繩用支座.安全要求和試驗External introducer cannulae for suprapubic catheter systems for single use - requirements and testing
一次性趾骨弓上導管系統用外部導入套管.要求和試驗Shaft sinking - riders for winding kibbles - safety requirements and testing
打豎井.提升吊桶導向架.安全性要求和試驗Loran - c receivers for ships - minimum performance standards - methods of testing and required test results
船舶用c型導航接收儀.最低性能標準.試驗方法和要求試驗結果Abstract : in this paper, an analytical study of the dynamics of the piston in a reciprocating internal combustion engine is conducted. the equations of reynolds and moving of piston are derived. a useful method of solution is obtained. the method is applied to s1100 diesel engine. the results of this study indicate that piston oil film is found to be sensitive to the piston - cylinder bore clearance, the location of the wrist pin and lubricant viscosity
文摘:對往復式內燃機活塞的動力特性進行了分析研究,導出了活塞潤滑的雷諾方程和活塞運動方程,給出了可供實用的求解方法,並採用這種計算方法對s1100柴油機進行了設計計算與試驗研究.研究結果表明,活塞潤滑油膜歷程與活塞& &缸套的間隙、活塞銷的位置、潤滑油的粘度等因素密切相關The course was conducted in the form of participatory and open instruction and integration of theory with practice. starting from how to identify the major problems in farmers training, gaining confidence at communicating with farmers, and understanding their current pressing needs, facilitators systematically discussed theories and practices concerning the concept and purpose of participatory methodology ; participatory experiment and testing, and how to do experiment research ; principles, methods and steps of participatory rural appraisal ; how to use participatory methods to carry out farmers training ; responsibility of participatory facilitators and points for attention during training ; and, the nine principles regarding adults training
培訓班採用參與式開放式教學理論與實踐相結合的方式,輔導員從如何尋找農民培訓遇到的最大問題,與農民打交道的自信來源,掌握當前農民的迫切需求為切入點,較系統的討論了參與式方法的概念目的參與式實驗與試驗如何做試驗研究參與式評估pra的原則方法步驟如何利用參與式方法開展農民培訓活動參與式輔導員的責任和在培訓中應注意事項以及成人培訓的九條原則等理論知識和方法。In order to attain high accuracy of gps satellite navigation, positioning and low cost in precision agriculture, it is studied a method of gps pseudo - range observation and carrier phase measurement to combine the actual conditions of agriculture. it is presented a method of high accuracy positioning and measure based on gps oem board in this paper, and proved the feasibility of key technology with emulations and field tests
為了適應精準農業高精度、低成本的gps定位導航應用要求,本文通過對gps偽距和載波相位定位方法的研究,結合精準農業的實際情況,提出了基於gpsoem板的高精度定位與測量方法,並用模擬和田間試驗驗證了各關鍵技術的可行性。The projectile amounts in the cleaning and cooling cycle of lifetime tests of all kinds of firearms were fixed on the base of the vast and systematic research for actual combats and the statistic analysis of combat examples
經大量而系統的實戰研究、戰例統計分析,確定既可滿足試驗要求也可指導實戰的各種槍械壽命試驗中的擦拭與冷卻周期射彈量。Belt drives - v - ribbed belts, joined v - belts and v - belts including wide section belts and hexagonal belts - electrical conductivity of antistatic belts : characteristics and methods of test
帶傳動多楔帶聯組v帶及包括寬v帶六角帶在內的單根v帶抗靜電帶的導電性:要求和試驗方法According to the request of the standard in electric industry in china named " on line check and test rules of analog and digital control system of power station ", every system is tested, and according to technological guides and operation rules, static and dynamic trial are required to be done, the quality of adjust, and response time also adapt to the requirement
機組整套試運以後,各控制系統逐步投入。依據中華人民共和國電力行業標準《火力發電廠模擬量、開關量控制系統在線驗收測試規程》的要求進行測試,並按照技術指標及運行導則要求均做過靜態、動態特性試驗,調節品質、響應時間均符合要求。Environment requirements and test methods for ground radio - navigation equipment
地面無線電導航設備環境要求和試驗方法On the base of studying imaging theory of lens, the imaging theory of laser confocal scanning microscopy was analyzed in detail in this paper, and the advancement of that the optical fiber was applied to the system was described ; on the base of completed the demonstration for whole project, the experiment scheme was designed ; the relationship between the main parameters of key devices and the resolution was deduced, and the requirements of coupling efficiency and vignetting effects to optical system was analyzed ; the design of optical system and the planar scanning controlling circuit was completed ; a new method was put forward to resolved the inherent non - liner scanning problem of the galvanometer scanner by using software liner controlling in circuit design, and the perfect planar scanning was realized ; at last the low noise, high multiple and non - distortion amplify circuit of photoelectric detector was completed
本文在透鏡成像理論的基礎上,系統、深入地分析了共焦掃描顯微成像的機理,論述了應用單模光纖的激光共焦掃描顯微成像系統的優點;進行了總體方案的論證,並設計確定了單模光纖激光共焦掃描顯微成像系統的總體方案;從理論上推導分析了解析度要求與試驗系統中相關器件主要參數之間的關系,分析了系統耦合效率和漸暈現象對光學系統的設計要求;完成了方案中光學系統和二維掃描控制電路的設計,並在電路設計中採用了用軟體解決檢流計式光學掃描器(振鏡)非線性問題的新方法,能夠實現較為理想的二維模擬掃描;完成了高增益、低噪聲和低失真的探測接收系統的設計和調試。The principle of the neural network models is different from that of the real - time running models. the latter is designed on the engine running, so the effect of the control strategy on engine performance can be observed clearly. while the former works out the solution directly from the testing data, avoiding the complex calculation procedure
神經網路模型與實時運轉模型的構成原理不同,實時模型以發動機運轉機理為設計依據,使于充分觀測控制策略對發動機各種性能指標的影響;而神經網路模型是根據己有的試驗數據進行直接推理,可避免大量的簡化、推導、求解過程,對于諸多機理繁復的發動機變量而言是一極佳的求解方案,因此就更全面的進行電控系統的調試評估考慮,兩種模型有著良好的互補性。System omega and differential omega receivers for ships - operational and performance requirements - methods of testing and required test results
船用奧米伽遠程導航系統和壓差奧米伽遠程導航系統接收機.運行和性能要求.試驗方法和規定的試驗結果Clamping closures of plastics for telecommunication cables with metallic conductors and optical fibres - requirements and tests
金屬導線和光纖通信電纜用塑料夾緊套管.要求和試驗Conditions of normal mode realization are deduced and optimized model with the multivariate mode indicator function as the target function is built. through solving the maximal eigenvalue problem, the original shaker force vector of appropriation is reached. then the realization approach of the optimal shaker force vector based on single shape principle is proposed and at the same time the automatization of normal mode appropriation is realized
對于模態物理分離技術的多點正弦激振純模態試驗技術,尋求其最佳激振力矢量是最為關鍵的環節,本文先推導出純模態實現的條件,建立以多變量模態指示函數為目標函數的優化模型,通過求解最大特徵值問題,得出適調純模態的初始激振力矢量,再提出以單純形原理為基礎的最佳激振力矢量的實現方法,同時也實現了純模態適調過程的自動化。An accomplished software engineer specializing in object - oriented design and analysis with extensive experience in the full life cycle of the software design process including requirements definition, prototyping, proof of concept, design, interface implementation, testing and maintenance
完成了在目標導向設計和在整個循環中對于軟體設計程序的經驗分析,程序包括:需求定義,原型,觀念試驗,設計,界面執行,測試與維護。Secondly, according to the requirement of the parametric sensitivity analysis, the method based on orthogonal experiment is chosen to cope with the difficulty of obtaining the sensitivity analysis through the partial derivative of explicit function. and it also overcomes the traditional single factor cyclical method ' s shortcoming ? impossibility to analysis interactional factors. furthermore, some significative conclusions are acquired from the sensitivity analysis
其次根據軌跡優化問題靈敏度分析的需要,選取基於正交試驗的靈敏度分析方法,解決了軌跡優化問題沒有顯函數,無法通過求其偏導數獲得靈敏度的難點,同時克服了傳統的單因素輪換法對該類問題進行靈敏度分析帶來的弊端? ?無法對有相互作用的因素進行靈敏度分析,並通過對軌跡優化問題進行靈敏度分析,得出了一些有益的結論。The method, based on the finite element theory, force - method theory, increment method and middle stiffness method, making use of the increment of curvature of the section, works out the increment of load applying and is proved in this thesis
接著,本文根據有限單元和力法原理、增量法及中點剛度理論,提出了本文暫且命名為曲率力法的非線性分析方法。該方法通過增加截面的曲率來反求框架外加荷載的增量,並在文中以試驗的框架模型為例,給出了整個推導過程。Dead reckoning navigation needs little space, but has high precision. the paper solves the navigation system of " tset - 1 " auv based on the sensors available, and a compact soft has been developed. some experience has gotten during the song hua lake " s test
本文針對「試驗- 1號」小型機器人導航系統要求和傳感器的配備情況,從工程實用性出發,完成了導航軟體的開發,並進行了松花湖試驗,這為今後水下機器人導航系統的研究與應用提供了有益的借鑒,積累了一定的經驗。分享友人