誤差敏感度數 的英文怎麼說

中文拼音 [wùchāmǐngǎndùshǔ]
誤差敏感度數 英文
error sensitivity number
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 敏 : Ⅰ形容詞（靈敏;敏捷） quick; agile; smart; nimble Ⅱ名詞（姓氏） a surname
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 誤差 : error
  • 敏感 : sensitive; susceptible; tactful
  • 度數 : number of degrees; readings; dimensionality; degree
  1. In general, a precise resistor is in series with one of the resistors in wheatstone bridge to compensate the zero offset, and the other one is in parallel with another arm of the wheatstone bridge to compensate thermal zero drift. based on this principle, in this paper, a compensation method based on virtual instrument technology has been put forward. actuated by current source, a good calculation method of compensation resistors and their position in the bridge is deduced

    本文基於串並聯電阻補償法的原理，提出了一種基於虛擬儀器的誤差補償方案，推導了在恆流源供電下可以精確的計算出補償電阻大小和補償位置的演算法，並且在虛擬儀器軟體平臺labview上完成了數據採集、處理、顯示等軟體的設計，經過實驗的驗證，對傳感器的零點溫度漂移補償取得較好的效果，而對靈敏度溫度漂移的工藝補償亦有一定的效果。
  2. However, video communication can tolerate some kind of data error or loss and different parts of video bitstream have unequal error sensitivities. so we need new error control methods designed especially for video communicaton

    同時視頻數據能夠容忍一定的誤碼和丟失，並不需要絕對的無差錯傳輸，而且視頻數據流的不同部分對錯誤的敏感度也不同，因此有必要也有可能根據視頻通信的特點研究新的差錯控制方法。
  3. In order to make the sensitivity of 2 - demension accelerometer along the two main arbors almost identical, symmetric four - beam structure that embeds a double - sides interdigitated differential capacitive with puckered beam in two directions was used as sensitive component. in addition, the differential capacitive accelerometer fabricated by bulky silicon micromechanical technique has high sensitivity, wide measurement scope, less nonlinear error, and simple converting circuit. then, the structure parameters of the sensitive component were calculated and stimulated, which results in a set of the optimized structure design parameters, main fabrication procedure and several key fabrication technology

    為使二維振動傳感器在兩主軸方向的靈敏度大致相同，敏感元件採用高度對稱的四梁結構，其中每個軸向上均採用帶折疊梁的雙側叉指電容結構，採用體硅微機械工藝製作的高深寬比叉指電容式敏感元件，具有高靈敏度、寬量程、非線性誤差小、外圍電路簡單等優點;對設計的敏感元件結構參數進行了計算，並利用有限元法進行了模擬分析，根據模擬結果得出了優化參數;在確定敏感結構的基礎上，研究了敏感元件採用體硅微機械加工工藝製作的工藝流程和關鍵工藝技術;對敏感晶元內部的c - v介面電路進行了原理設計與分析，利用差動測量技術得到由振動引起的微小電容變化量，經c - v介面電路進行相位調制處理，然後通過解調輸出與加速度成正比的電壓信號。
  4. Results rectify that matched field processing based on ray travel time delay is insensitive to the mismatch of sound speed proflle, although the mismatch of ocean bottom depth and receiver location is bad to matched field processing, different forms of cost fimctions could decline the sensitivity

    計算結果表明，基於聲傳播時延的匹配場定位對聲速分佈失配是不敏感的。雖然接收基陣位置傾斜和海洋深度誤差對匹配場處理影響較大，但只要選擇適當的代價函數，可以得到克服。
  5. Frequency response, quantization noise, reconstruction error and its sensitivity to mismatch among adcs are studied at length in prqmf banks adc system, and the theoretic results include : ( 1 ) the distortion / aliasing functions of hybrid filter banks adc system is similar with that of switch capacitor filter banks adc system ; ( 2 ) for wide or narrow band input signal, the effective resolution of the two adc systems is 0. 51og2m bits higher than their adc ; ( 3 ) reconstruction error ' s sensitivity to mismatch among adcs of the two adc systems is reduced effectively than time interleaved adc system

    2對prqmf濾波器組adc系統的頻響、量化噪聲特性、重建誤差特性以及重建誤差對adc間的失配敏感性進行了理論分析研究，所得到的理論結果為： （ 1 ）混合濾波器組adc系統與開關電容濾波器組adc系統的失真/混迭函數一致； （ 2 ）無論輸入寬帶還是窄帶信號，這兩種adc系統的有效解析度均比其adc提高了0 . 5log _ 2m比特； （ 3 ）這兩種adc系統的重建誤差對其adc間的失配敏感性均明顯低於時間交織adc系統。
  6. Assisted with the sensitivity of the linear analog circuits, the feasibility of parametric faults detection was analyzed through the maximum fault errors acquired at the sensitive frequencies, a stimulation matrix and its stimulation expression were put forward on the test points information

    摘要從線性模擬電路靈敏度的概念入手，分析了通過獲取敏感頻點激勵下的最大故障誤差來檢測電路參數故障的可能性，提出了一種針對測試頻率和測點信息的激勵矩陣。
  7. Different sampling periods of sensors and the recursive steps of initial states are investigated. the navigation precision with different condition such as different precision of sensors, different length of observation time are compared. then, three orbit types, consisting of low - altitude orbit, middle - altitude orbit and high - altitude orbit, are simulated respectively

    在pc機上首先分析敏感器采樣周期和濾波迭代次數對自主導航精度的影響，然後比較敏感器精度不同，觀測時間長短不同，軌道類型不同情況下所產生的導航誤差。
  8. This article uses the modem consumption theory to study chinese fanner ' s consumer behavior and sets up error - correction model as econometric model on the basis of implementing stationarity test to the data of the model, and concludes that the uncertainty, excess sensitivity and the fanner ' s life - cycle characteristic are important factors to affect fanner ' s consumer behavior

    摘要本文運用現代消費理論對中國的農民消費行為進行研究，在對模型的數據進行平穩性檢驗的基礎上，建立誤差修正模型作為計量模型，認為農民面臨的不確定性、農民消費的過度敏感性和農民消費行為的生命周期特徵是影響農民消費行為的重要因素。
  9. The backward error and the structured backward error of the approximate solution are the criteria to judge the stability and the strong stability of the numerical algorithm. condition number is a measure of the sensitivity to the approximate solution for the perturbation of original date

    近似解的最佳向後誤差和最佳結構向後誤差的數值分別是判別演算法的穩定性和強穩定性的標準，而條件數則是反映數值問題的解對于該問題數據擾動的敏感程度。
  10. By means of establishing mathematic model for the influence of synthetic accuracy of track of planar four - bar linkage affected by manufacturing error of bar length, the sensitive coefficient of manufacturing error of bar - length was deter mined and the law of influence on synthetic accuracy of track affected by manufacturing error of bar length was analyzed

    摘要通過建立桿長製造誤差對平面四桿機構軌跡綜合精度影響的數學模型，確定了桿長製造誤差的敏感系數，分析了桿長製造誤差對軌跡綜合精度的影響規律。
  11. In present dissertation, the model of ert was established, the method to deduce the system equation using finite element method ( fem ) was discussed, and the process of calculating the voltage, resistance and sensitivity matrix through numerical computation was also introduces. because during the process of positive problem solution, errors are unavoidable, so the evaluation of the results were carried out through data and diagram, also the influence to the results caused by the change of parameters was analyzed

    由於在正問題求解過程中，被測域的離散化、計算公式的離散化以及數值計算的近似處理等都將不可避免的引入誤差，因此論文中對計算結果進行了評價，分析了傳感器的參數（電極數，電極尺寸等）以及計算過程所用參數（如剖分精度）的改變對計算結果（電勢、電阻、敏感場）的影響。
  12. Through contrast, mode data are more sensitive to structure local damage than frequency, but it has the question that the measured accuracy is lower than natural frequency which make results having big deviation

    相比之下，振型數據對結構的局部損傷要比頻率敏感的多，但又面臨著測試精度比固有頻率低，容易造成識別結果誤差增大。
  13. The tactical missile seeker handover accuracy from midcourse to terminal guidance is researched. the small perturbation method is proposed to analyse error sensitivity of the seeker presetting parameters from error sources. firstly, the terminal guidance seeker presetting parameters are computed, based on the equations of a surface - to - air missile movement and a target movement. then the seeker presetting unaccuracy due to the command guidance radar measurement errors is also computed. it can be seen that the seeker presetting errors increase rapidly when the missile is close to the target, which leads to an important conclusion that the late seeker handover from midcourse to teminal guidance should be avoided

    研究復合制導的戰術導彈中末制導交班的導引頭預定精度問題.提出用小擾動法分析導引頭預定參數對誤差源的誤差敏感性關系.以中遠程防空導彈為例，結合導彈運動方程組和目標運動模型，計算了中末制導交班的導引頭預定參數，並計算了在制導站雷達測量誤差下的末制導導引頭預定參數的計算精度.可知，導引頭定位參數的計算誤差隨著彈目距離的接近而顯著增大，得到中末制導交班不能太晚的重要結論
  14. Abstract : the tactical missile seeker handover accuracy from midcourse to terminal guidance is researched. the small perturbation method is proposed to analyse error sensitivity of the seeker presetting parameters from error sources. firstly, the terminal guidance seeker presetting parameters are computed, based on the equations of a surface - to - air missile movement and a target movement. then the seeker presetting unaccuracy due to the command guidance radar measurement errors is also computed. it can be seen that the seeker presetting errors increase rapidly when the missile is close to the target, which leads to an important conclusion that the late seeker handover from midcourse to teminal guidance should be avoided

    文摘:研究復合制導的戰術導彈中末制導交班的導引頭預定精度問題.提出用小擾動法分析導引頭預定參數對誤差源的誤差敏感性關系.以中遠程防空導彈為例，結合導彈運動方程組和目標運動模型，計算了中末制導交班的導引頭預定參數，並計算了在制導站雷達測量誤差下的末制導導引頭預定參數的計算精度.可知，導引頭定位參數的計算誤差隨著彈目距離的接近而顯著增大，得到中末制導交班不能太晚的重要結論
分享友人
分享到 Line

分享到臉書