誤差框 的英文怎麼說

中文拼音 [wùchākuàng]
誤差框 英文
error box
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 框 : 框名詞（框架; 框子） frame; case
  • 誤差 : error
  1. There is no gimbaling error because the vessel is on a cardinal heading.

    在這種情況下也沒有框架誤差，因為船舶是處于基本航向。
  2. So-called "gimbaling errors" can result from improper gimbal geometry or from imperfect roll and pitch stabilization of the gimbal system.

    所謂「框架誤差」是框架幾何形狀的不正確或框架系統的側擺和俯仰穩定得不完善所產生的。
  3. The history and present situation of electric measuring instrument and features of intelligent meters are introduced in this paper. a brand - new scheme of intelligent electric parameter meter is proposed by the author after combining the features of intelligent meters and practical demand for electric measuring in 300mw generator units. general design, realization of hardware circuit comparison and analysis of errors of different algorisms are discussed in detail

    本論文介紹了電測儀表的發展歷史與現狀，以及新興智能儀表的特點；結合智能化儀表特點和300mw發電機組電參數測試的實際需要，首次提出了一種智能型發電機組電參數綜合測試儀的研究方案；詳細敘述了該智能型綜合測試儀的總體設計，硬體電路實現，各種演算法的比較的誤差分析；以及軟體框圖設計，針對影響測量精度的因素進行了分析，並制定了改進措施。
  4. Combined with the experimental values of eleven sgrc frames, the results calculated by computer program of this paper have some errors, so this paper analysis some relative reasons which can cause error. the proper ascertainment of the value of stiffness reduction factor of the components of sgrc frames is discussed. by contrasting push - over method with some other nonlinear analytical methods, this paper indicates this method in this paper is a simple and convenient method, and this method is practicable and applicable in future engineering

    通過比較這11榀煤矸石混凝土框架由本文方法得到的計算值與其試驗值，總結了本文方法產生誤差的一些相關原因，討論了煤矸石混凝土框架剛度折減系數的取值問題，對比其它非線性分析方法，表明了本文方法的簡便性和準確性，進而預測了本文所使用方法在未來工程實際中的可用性和適用性。
  5. Because application development in php is not as structured as the j2ee standard or struts frameworks, the design has leeway for customization

    因為php中的應用程序開發與j2ee標準或struts框架結構的構造方式不同，所以設計中允許存在定製的誤差。
  6. This reference mode can also offer a guideline to colleges, which want to set up the quality management system or / and which want to adapt the qms editor to iso9000 : 2000 editor. as the size, framework and process are various among the colleges, the author offers a reasonable assessment method in order to make the quality audit more efficient and accurate. to design a framework or syllabus of audit check sheets, which can be applied to all colleges, will reduce contrived error if the quality management systems of the colleges are audited by different auditors and will make the administration get an intuitionistic understand of the systems

    由於各學校在規模、結構和所採用的過程不盡相同，為更好做好學校質量體系的審核工作，本文提出較為合理的評價方法，按iso9001 ： 2000標準質量管理體系的審核準則設計一個適用於各種學校的審核檢查表的框架或提綱對學校的iso9000質量管理體系進行評價，使不同審核員按此方法對學校的iso9000質量體系運行的真實狀況評價時，減少審核中的人為誤差，使主管機關對學校質量管理體系有較為直觀認識。
  7. At the same time, the author gave out the formula to calculate the system position error because the three axis of the simulator are not uprightness each other

    本文還分析了系統的機械精度，給出了由於三個框架軸不垂直造成的系統位置誤差計算公式。
  8. This kind of controller is easy to design and operate, and has improved convergence rates and less overshoot than pid controller, but has stable error. in order to improve the properties of the fuzzy controllers, fine - tune - rule fuzzy controller, fine - tuned parameter fuzzy controller and fuzzy - pi controller were designed respectively based on the simple fuzzy controller. then fuzzy logic inferential system is established by using toolbox of fuzzy logic in matlab7. 0. secondly, in simulink6. 0, through the instance of the template of s - function, the module of s - function for optimizing fuzzy control and corresponding control model are constructed, and the parameters of simulation are set

    這種控制器易於設計、實現方便，較傳統pid控制有更快的響應速度和更小的超調，但其存在靜態誤差;為了進一步提高模糊控制器的控制特性，在此基礎上分別設計了可調整控制規則模糊控制器、參數自整定模糊控制器和模糊- pid復合控制器;然後利用matlab7 . 0模糊邏輯工具箱圖形用戶界面建立模糊邏輯推理系統，在simulink6 . 0系統模擬設計平臺中通過實例化s函數模板創建旨在優化模糊控制的s函數功能模塊，並構建模糊控制系統框圖模型，設置系統模擬參數，最終對系統進行動態模擬。
  9. First, according to the orthonormal quality and the rational choice of working point of the sonar array three shafts frame, the structure of the models is predigested preliminarily ; secondly, according to the quality indexes and the coupling quality between frames, relatively small quantum is neglected. so the complex non - linear coupling models of the sonar array are predigested farther ; lastly, considering the characteristic of the model coefficient matrix, the methods of the low rank polynomial approach and the error simulation are introduced. so the models are predigested again

    首先從聲納基陣框架結構的正交性和工作點的合理選擇出發，使模型的結構得以簡化；其次根據系統性能指標及框架間耦合性強弱，忽略相對小量，對聲納基陣復雜的非線性耦合模型進一步簡化；最後考慮模型系數矩陣的特點，運用低階多項式逼近和誤差模擬的方法，實現了對模型的再次降階簡化處理。
  10. A deep beam model with spring bearing is given, based on the analysis of middle frame of frame and shear wall structure ground floor, which is sensitivity to floor rigidity. comparing rigid assumption to elastic assumption, shear error of frame is worked out, which is index of floor rigidity. conclusions are drawn that floor rigidity is independent of earthquake intensity and the most effect factor to floor rigidity is floor length to width ratio

    以樓板按剛、彈性計算的框架柱的剪力誤差值作為衡量樓板剛性的指標，通過對模型進行理論分析證明以往一些只能通過歸納總結得出而沒有理論支持的結論：樓板的剛性同地震烈度無關；通過對影響樓板剛性的各個因素進行分析比較，得出樓板的長寬比是影響樓板剛性的主要因素，而增加樓板的厚度並不是增加樓板剛性的有效途徑。
  11. Chapter 2 establishes the theoretical framework of a class of dual algorithms for solving nonlinear optimization problems with inequality constraints. we prove, under some mild assumptions, the local convergence theorem for this class of dual algorithms and present the error bound for approximate solutions. the modified barrier function methods of polyak ( 1992 ) and the augmented lagrange function method of bertsekas ( 1982 ) are verified to be the special cases of the class of dual algorithms

    第2章建立求解不等式約束優化問題的一類對偶演算法的理論框架，在適當的假設條件下，證明了該類演算法的局部收斂性質，並給出近似解的誤差界，驗證了polyak （ 1992 ）的修正障礙函數演算法以及bertsekas （ 1982 ）的增廣lagrange函數演算法都是這類演算法的特例。
  12. In conventional analysis and design of steel structures ， it is usually assumed that the connections between columns and beams are either rigid or pinned. the analysis of steel frames adopting the assumption can simplify the procedure of analysis and design, but cannot precisely reflect structural practical circumstance and the errors of calculating results are large, even, get incorrect conclusions

    雖然對連接性能的這種理想化假設簡化了鋼框架的分析和設計過程，但採用理想的連接模型在很多情況下是不合理的，也不能反映結構工作的實際情況，計算結果誤差很大，有時甚至會得到錯誤的結論。
  13. Thirdly, we present a new algorithm on texture synthesis, which not only has rapid speed with the help of " synthesis consistency " but also gives pixels in the image vision - related weight to get good result. fourthly, we present an open framework about tsfs with " shadow texture ". finally, we describe a new texture synthesis method based on multiple samples, which integrates patch - based technique and the principle of minimum neighborhood error between pixels, and synthesizes in a repeat way

    該演算法不僅利用「紋理塊的連貫性」 ，加快了紋理合成的速度，而且通過給像素附上與視覺相關的權值，得到了比以往更好的合成結果；作為進一步的研究，本文還提出了利用「伴隨紋理」進行紋理合成的開放式框架；最後本文介紹了一種新的多樣圖紋理合成演算法，該演算法基於塊匹配技術與像素的鄰域誤差最小原則，同時採用多次合成的方式，對大多數紋理都取得了較好的合成效果。
  14. The errors ofcalculating lateral displacement, peak displacement and internal force among thethree methods are compared subsequently. at the same time, the validation of theextent of stability coefficient is also done. finally, many examples ( including threemulti - story and high - rise steel frame structures in real - life ) forming through changingsome parameters which affecting stability coefficient are analyzed

    最後通過改變影響穩定系數的各個因素，在大范圍內構造了大量的鋼框架算例（包括三個實際工程中的多高層鋼框架算例） ，得到這些算例中穩定系數與三種方法間計算層間側移時誤差的一一對應關系，通過統計這些穩定系數與誤差間的相互關系，對穩定系數的合理區間進行了討論。
  15. Emphasis is placed on analyzing the influences of friction characteristics on hydraulic motor, dynamic coupling between gimbals, resolution ratio error and setting error of feedback measurement element on accuracy of electro - hydraulic position servo system for a certain simulation turntable

    摘要針對具體的模擬轉臺電液位置伺服系統，著重分析了液壓馬達摩擦非線性、框架間動力學耦合、反饋測量元件的解析度誤差和安裝誤差對轉臺電液位置伺服系統精度的影響。
  16. From the experiment and analysis, it can be seen that friction limits realization of high accuracy electro - hydraulic position servo system, movement of any gimbal brings disturbance moment to servo system of other gimbals and the disturbance moment causes error, and, resolution ratio error and setting error of feedback measurement element are directly added to servo system output

    通過實驗和模擬可以看出，摩擦阻礙了轉臺電液位置伺服系統商精度控制的實現，任何一個框架的運動都會對其餘框架的伺服驅動系統產生干擾力矩並引起伺服系統誤差，反饋測量元件的解析度誤差和安裝誤差直接反映在伺服系統輸出上，對伺服系統的精度有直接影響。
  17. Aggregate errors found in this dialog can then be tracked down by station in the top talkers display

    此對話框中發現的累積誤差可以在
  18. Parasoft introduces new automated unit testing tool for preventing errors in web services built with the microsoft. net framework

    框架中網站服務誤差的新型自動單元測試工具美國加州
  19. In case of high input dimension system model, taking norm of input vector as the input of wavelet network instead of using tensor product method to construct wavelet network, which could solve the problems of high computation and curse of dimensionality. in the selecting of specific wavelet basis, this thesis first gets initial wavelet basis collection according to spectrum analysis, then gives the least squares regression algorithm to optimize wavelet basis collection based on the least estimation error criteria, which could also initialize the model parameters and increase the speed of convergence

    對于具體的模型小波基函數選擇，本文首先對樣本數據進行時頻域分析，根據小波基函數時頻空間覆蓋樣本時頻空間的原則，在小波框架中選擇建模所用的函數集，然後根據估計誤差最小準則，給出最小二乘回歸優選演算法以進一步優化小波基函數集。
分享友人
分享到 Line

分享到臉書