調零 的英文怎麼說

中文拼音 [diàolíng]
調零 英文
adjust to zero
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 零 : Ⅰ數詞1 （零數） zero2 （數的空位） zero sign （0）; nought 3 （表示沒有數量;無） nil; nought 4 （...
  1. Elements for electrical instrumentation. zero adjuster

    電工儀表用零部件.調零器
  2. Neural network - based adaptive nulling with multiple - beam antennas

    基於神經網路的多波束天線自適應調零
  3. Testing methods for determination of trace components in diluent gas and zero gas

    測定稀釋氣體及調零氣體中痕量組分的試驗方法
  4. On noncommutative hopf - galois extensions

    一致局部上同調零化子和多項式擴張
  5. Azs automatic zero setting

    自動調零
  6. Azs automatic zero set

    自動調零
  7. Software design realizes functions of flow characteristic correction, automatic zero setting, span setting, alarm, fault diagnosis and field display ; 4

    3 、軟體設計實現了流量特性修正、自動調零、調量程、報警、故障自診斷、現場顯示等功能。
  8. Secondly, the pressure sensor made by motorola co. ltd. in usa is chosen as the key part of the pneumatic - electric transducer. thirdly, the signal processing system of the pneumatic - electric is developed

    第三，研製了氣電轉換器的信號處理電子系統，設計有調零、增益調整、開關轉換擴展量程等功能。
  9. Yells : your soul will languish for eternity

    你的靈魂將永遠調零！
  10. The average dark current is often eliminated by means of a zeroing circuit.

    平均暗電流常利用調零電路消除。
  11. At present, we can produce spareparts for all kinds of refrigerators and air - conditioners and the scale of our products are applicable for all kinds of refrigerators and air - conditioners

    為了保證生產產品質量及精度，特從日本引進全套工模具及激光三維測量機及專用技術，為我國國內生產，加工冰箱、空調零配件，添補了行業空白。
  12. This null-balance system is usually more accurate than the direct-readout bridge.

    這種調零系統通常比直讀電橋更精確。
  13. In hardware design, a / d, mt8880, serial port communication module and other interface circuit are described. in software design, the related algorithms such as scale transform, digital filter, digital zero, dtmf communication and repeated output program are considered

    硬體設計主要介紹了a d轉換、 mt8880 、串列通信等模塊和介面的電路設計，軟體設計主要介紹了程序設計中比較關鍵的標度變換、數字濾波、數字調零和重復輸出等數據處理的演算法以及利用dtmf信號實現數據採集器和監測站傳輸數據的通信軟體設計。
  14. In experiment process, firstly verify the system using three points method and meanwhile adjust the zero, compiete measurement and checkout measurement

    試驗過程首先進行系統標定，三點法校準，進行調零、滿度、中值校驗。
  15. Satellite digital nulling antenna receiving technology

    星載數字調零天線接收技術
  16. Analysis of automatic zero set of intelligent instrument

    智能儀表的自動調零分析
  17. External adjustment zero resolution

    外部調零
  18. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  19. A design for high precision adjustment of zero output in testing system based on piezoresistive transducer

    壓阻式傳感器測試系統中的高精度調零設計
  20. To the defect of the system hard to equilibrate, a new circuit frame to make equilibrium was presented ( 3 ) based on the analysis of interferences of the circuit, some relative means were taken to restrain the interferences. furthermore in order to detect surface conveniently and to improve the testing accuracy some designs of the probe were introducer

    針對原電路難以調零的缺點，提出了新的電子平衡電路方案，設計了新的電子平衡電路，新的平衡電路調零精度高，速度快，平衡狀態可以長時間保持，缺點是難以利用現有電路，成本較高。
分享友人
分享到 Line

分享到臉書