象限法器 的英文怎麼說

中文拼音 [xiàngxiànfǎqì]
象限法器 英文
quadrant multiplier
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 象限 : [數學] quadrant象限儀 [天文學] quadrant
  • 法器 : [宗教] musical instruments used in a buddhist or taoist mass
  1. The complete set of constraints is not even computable as is the case for compilers and interpreters

    整套的限定元素甚至是無法計算的（就象編譯器和解釋器的情況一樣） 。
  2. The limitations of this scheme became quite apparent with the introduction of detectors such as the plumbicon, image orthicon and vidicon.

    這個方法的局限性在引進諸如氧化鉛光導管攝像管，超正析象和光導攝像管之類的探測器之後變得很明顯。
  3. By improving the conventional electric - arc fusion method, we have realized the splicing between two kinds of mofs and smf with relatively low splice losses. we have written fiber bragg gratings in grapefruit mof successfully. the multi - wavelength resonances are observed in the grating, and theoretical analysis shows that this phenomenon is caused by the resonances between core modes and cladding modes

    在此基礎上對微結構光纖光柵進行了理論和實驗研究，在柚子型光敏微結構光纖上成功寫制了布拉格光柵，觀察到多波長的反射峰，並利用全矢量有限元方法對微結構光纖布拉格光柵中的多波長諧振現象進行了理論分析，最後在實驗上對其在多參量傳感和多波長光纖激光器件中的應用進行了嘗試。
  4. With the corrected parameter files, the results indicate that the isotopic abundance in the sample can be determined within 2 % error using a hpge detector system. artificial neural networks ( ann ) are a class of models based on neural computation and have been applied to the measurement of uranium enrichment. the principles of ann methods used in uranium measurement are presented in this paper and the conditions of analysis proceedings are described

    在核保障核查測量中和實物監測中，測量對象往往是規格確定並種類有限的元件或部件，只需要關心測量對象的屬性是否發生了變化，或者對同一種類的放射性樣品的一致性做出判斷，這種要求下使用神經網路方法是比較適宜的，並且神經網路方法是與探測器和探測效率無關的。
  5. The matlab language and c language were applied to simulate the fixed - point dsp arithmetic of equalizer algorithm. the simulation result indicated the diveragence phenomenon would happen to adfe ( adaptive decision feedback equalizer ) based on rls algorithm under the fixed - point finite - precision arithmetic

    採用matlab和c語言模擬均衡器定點dsp演算法的實現，模擬結果表明rls演算法的自適應判決反饋均衡器（ adfe ）在定點有限字長運算的情況下存在著發散現象。
  6. There are much complicated and exquisite physical and chemical processes when the oil and the air been mixed. for some theories of the combustion are not clear and the differential eguations are so complicated, it is very difficlut to get the accurate flow field distribution. so it limits the combustion theory to design conb ustion equipment

    由於對某些燃料的燃燒過程機理至今尚不完全清楚，並且描述這一現象數學模型的控制微分方程很復雜，所以很難用解析方法求得等離子點火器燃燒流場的精確分佈，這樣就極大的限制了人們應用燃燒理論指導這一燃燒設備的設計研究。
  7. Thirdly, integrating bell - type scheduling investigation of domestic and overseas documents, the paper defines optimized scheduling production of bell - type annealing process as the problem of parallel machine scheduling with resource - constrained and multi - step working procedure, whose optimized function of objective function is given also. furthermore, the author constructs bell - type optimized scheduling model by means of the way combing discrete event simulation with algorithm of intelligent optimization

    本文在綜合國內外對于罩式爐調度研究的基礎上，將罩式爐退火過程優化排產定義為資源受限多步工序并行機器調度問題，並定義了優化目標評價函數；將面向對象的離散事件建模模擬方法和智能優化方法相結合建立了退火爐優化排產模型。
  8. 4. through our research, the whole measuring scheme is finalized for pulse - counting method with analog intervene chosen to measure distance, the differential coefficient method based on the least - squares curve fitting based on power functions chosen to measure velocity and qd optical spot location method chosen to measure angle

    4 .通過研究，最終確定了以模擬插入脈沖計數法測距，冪函數族基最小二乘曲線擬合微分法測速，四象限探測器（ qd ）光斑定位法測角的脈沖激光雷達整體測量方案。
  9. With concepts of the robot occupancy space, the surgeon occupancy space, the surgical object space, the instrument occupancy space, the robot working space, the robot finite dexterity space, the error - sensitive coefficient, etc., the content and the method for the orthopaedic robot space design are proposed under the surgical environment in the orthopaedic clinic

    採用機器人佔有空間、醫生佔有空間、手術對象空間、手術器械佔有空間、機器人工作空間、機器人有限靈活空間、誤差敏感系數等概念，結合骨科臨床手術環境，提出了骨科機器人空間設計的內容和方法。
  10. The simulating results indicate that the scheme is stable in linear frame, and exists weak instability on the intersecting points of lateral boundary and interface in nonlinear frame. in present stage, a technique of using damping zone to limit the movement of the intersecting points is used to avoid this instability problem, however, to solve it thoroughly, the original model has to be modified in the future

    實驗證明，在線性框架下該模式是穩定的，但在非線性模擬中卻出現了由邊界角點引起的弱不穩定現象，必須對模式作進一步修改，為此同時提出了以消波器消除該角點影響的限制性解決方法。
  11. Based on the theory of mechanical optimization and finite element analysis, elbow - bar mechanism of the mp1040b moulding machines made by beiren group is investigated in the dissertation. firstly, a kinematic model representing the bar mechanism is built and the nonlinear system of equations is solved through the method of gradient. meanwhile, the angular displacement, angular velocity, angular acceleration and the corresponding curves of each component in a motion period are obtained

    本文以北京人民機器廠mp1040b型模切機肘桿機構為研究對象，以機械最優化理論和有限元技術為基礎，首先對模切機肘桿機構建立數學模型，通過梯度法求解此非線性方程組，並得出機構在一個運動周期中各構件的角位移、角速度、加速度等運動參數及曲線。
  12. The ingredients limiting power capability and depress combining efficiency in the whole system have been discussed. the infection of the dimension of microstrip line to power capability of devices and the power capability of isolate resistor has been investigated in detail. a high efficiency adaptive power combining technique restraining great degradation in multi - way combining system has been introduced ; 2

    文章的主要內容是: 1 .討論了功率合成系統中限制功率容量、降低合成效率的因素;詳細研究了微帶線尺寸對器件功率容量的影響，以及大功率合成系統中隔離電阻功率容量的量值;針對多路合成系統中適度惡化現象合成提出高效率的自適應合成方法。
  13. Taking no account of the non - uniformity of the detector, this paper analyzed the performance of the traditional four - quadrant angle - measurement algorithm and two other algorithms in calculating the pitch angle and the deflection angle of the incident ray, and also compared the error curve of the pitch angle calculated by each algorithm in the full plane

    摘要在不考慮探測器非均勻性影響的情況下，本文分析了傳統四象限測角演算法和另外幾種演算法在計算入射光的俯仰角和偏轉角時的性能，還比較了在整個平面內各個演算法得到的俯仰角的誤差曲面。
  14. It ' s a driving force and also a challenge to control in both theory and technology due to the more and more severe specifications imposing on it. a variety control theory have been developed, however, with limited performance in practical applications, especially in term of the relatively lower response speed when used in those machines which run fast. therefore, it is necessary to develop a new self - tuning algorithm for fast running plant of uncertainty so as to set theoretical base for controller design

    在科技飛速發展的今天，各種新設備、新工藝的出現促進了控制理論的發展，同時也對控制技術提出了越來越高的要求，雖然已有許多旨在提高控制性能的不同的控制理論，但由於其各自的局限性，在應用中仍然存在許多問題，特別是對于運行速度較快的機械設備等，其響應時間往往不能達到要求，因此，有必要開發一種新型、快速、能夠適應快速運行或變化的對象或過程的自調節演算法，以為控制器的開發作好理論支持。
  15. The major subjects of training survey of adverse effects of medical devices were enterprises manufacturing / managing medical devices, medical organizations and staff in supervise department., the requirements for training survey of adverse effects of medical devices to whom were same or specific in the content, temporal limits, modes or methods and so on

    醫療器械生產經營企業、醫療機構和監管部門的有關人員是醫療器械不良事件監測培訓的主要對象，對于醫療器械不良事件監測培訓的內容、時間時限、方式方法等有關事項有著相同或不同的需求。
  16. This paper begins with the restrictions of the - existent net - flow modelling methods. integrated with the characteristics of modern net - flow system and utilizing francesco luna ' s idea of pcrceptron and xor function, we express human ' s consciousness with logistic function of perceptron, and the uncertain relations among nodes are mapped to xor function. on the basis of these, a new modelling method of net - flow is offered

    本文從已有網流系統建模方法的局限性出發，結合現代網流系統的特徵，利用francescoluna的感知器與異或問題的思想，將人的意識用感知器對應的邏輯函數進行描述，節點之間連接關系的不可感知性映象為異或函數，提出網流系統的一種新的建模方法。
  17. Aimed to the two deficiencies of three - ring gear transmission, the dissertation will analyze these two aspects. the first, according to the finite element model of gear pair of three - ring gear reducer, the dissertation is aimed to analyze the multi - tooth meshing effect of three - ring gear reducer using finite element method, and the number of teeth contacted simultaneously, their load distribution characteristics and the von mises stress change are gained

    針對三環減速器以上兩點的不足之處，本文將對以下兩方面進行分析:首先，本文以三環減速器齒輪副有限元模型為研究對象，利用有限單元法對三環減速器多齒嚙合效應進行分析，得到三環減速器傳動時的實際接觸齒數、嚙合齒載荷分配以及vonmises應力變化規律。
  18. Taking some suspension bridge as an investigation target, we used emulation mode of the finite element method to investigate effects of damper parameters on anti - seismic performance of a suspension bridge

    摘要以某懸索橋為分析對象，採用有限元模擬分析方法，研究了粘滯阻尼器不同參數對該橋抗震性能的影響。
  19. The structure and character of deformable mirror were analyzed, and the conflict between the deformation band and the pitch of deformable cells was pointed out. the " two - time compensation " wave - front correct mode was introduced to settle that conflict. the method for allocating wave - front aberration and designing static corrector was found, and the " two - time compensation " wave - front correct mode was validated by simulation

    分析了變形鏡的結構特點，初步給出了變形鏡本身驅動單元數與校正量之間的制約關系；引入「二次補償」波前校正方案，解決了變形鏡校正量有限與高功率固體激光系統波前誤差起伏量大的矛盾，建立了波前校正對象優化分配、靜態校正器優化設計等細節過程所需要的方法，通過模擬模擬驗證了「二次補償」波前校正方案對于降低變形鏡校正量要求和放寬光學元件加工精度的作用； 5
  20. Finally, the finite element analysis of electromagnetic fields of large capacity transformer and mechanic - electric equipments were carried by using software designed in the article, achieving the satisfactory results, certifying correct and efficient of the method of finite element

    最後，運用本文的軟體對高壓斷路器的電磁場進行了有限元分析，獲得了較為滿意的結果，從而驗證了本文面向對象有限元方法的有效性和正確性。
分享友人
分享到 Line

分享到臉書